2001 MAZDA MODEL 626 oil dipstick

Form No. 8P95-EA-00G
Maintenance8-14
083-4AE
 Engine Compartment Overview
Cooling system cap
2.0-liter engine
Engine oil dipstick Air filter
Automatic transaxle fluid-level dipstick
(only for automatic transaxle)
Brake/Clutch fluid reservoir
Fuse block
Battery
Coolant reservoir
Windshield washer fluid reservoir
Power steering fluid reservoir
Engine oil-filler cap
J94A7001A

Form No. 8P95-EA-00G
Maintenance
8-15
Engine oil-filler cap
Engine oil dipstick
Air filter
Automatic transaxle fluid-level dipstick
(only for automatic transaxle)
Brake/Clutch fluid reservoir
Fuse block
Battery
Coolant reservoir
Windshield washer fluid reservoir
J94A7002A2.5-liter engine
Power steering fluid reservoir
Cooling system cap

Form No. 8P95-EA-00G
Maintenance
8-17
CAUTION
!
Using oils of viscosity besides
those recommended for specific
temperature ranges could result in
engine damage.Energy conserving oils are
recommended. A chief contribution
they make to fuel economy is reducing
the amount of fuel necessary to
overcome engine friction.

083-6A2E
J94A7005
2.0-liter engine
OKInspecting engine oil level
1. Be sure the vehicle is on a level surface.
2. Warm up the engine to normal operating temperature.
OK
J94A7004
2.5-liter engine3. Turn it off and wait 5 minutes forthe oil to return to the oil pan.
4. Pull out the dipstick, wipe it clean, and reinsert it fully.

Form No. 8P95-EA-00G
Maintenance8-185. Pull it out again and examine thelevel. It’ s OK between L and F.
But if it’ s near at or below L, add
enough oil to bring the level to F.
CAUTION
!
Don’ t add engine oil over F.
This may cause engine damage.NOTEThe distance between L and F on
the dipstick represents 1.0 L (1.06
US qt, 0.88 Imp qt).

083-7CE
Changing engine oil and filter
Change engine oil and filter according
to Scheduled Maintenance (page
8-3).
Please act responsibly—protect the
environment and take used oil to a
recycling facility. Ask your dealer or a
service station for information.
WARNING
!
Handling Used Engine Oil:Continuous contact with used
engine oil could be dangerous. It
could cause skin cancer. Always
wash with soap and water
immediately after changing oil
and filter.

Form No. 8P95-EA-00G
Maintenance8-20
083-47B1E
3. Replace the plug tightly after theoil has thoroughly drained.
4. Fill the engine with new oil to the F mark on the dipstick.
5. Securely replace the oil-filler cap.
6. Start the engine and inspect around the drain plug for leaks.
7. Turn it off and wait 5 minutes for the oil to return to the oil pan.

 083-48BE
Check the oil level and fill to the F
mark if necessary.
Oil capacity
(General reference only)
2.0-liter engine:
3.3 L (3.5 US qt, 2.9 Imp qt)
2.5-liter engine: 3.7 L (3.9 US qt, 3.3 Imp qt)
NOTE• The indicated engine oil
capacities are for general
reference purposes only. When
adding or changing oil, verify
the engine oil level with the oil
dipstick.
• Use only specified engine oil
(page 8-16).Changing oil filter
Because you need a special tool to
retighten the filter, an Authorized
Mazda Dealer should do the work.