2001 MAZDA MODEL 626 ECU

Form No. 8P95-EA-00G
Knowing Your Mazda3-28J94A2008A
Lock
The following method will also arm
the theft-deterrent system.
Close the hood and the trunk lid. Press
the area on the door-lock switch
marked “DOOR LOCK” once and
then close all the doors.
 096-12AE
J94S30013. The turn signal lights flash for
about 2 seconds, then the security
indicator light starts to flash every
3 seconds to indicate that the
system is fully armed. It continues
to flash until the theft-deterrent
system is turned off.
096-14C1E
J94S3002 To Turn off an Armed System
An armed system can be turned off by
pressing the UNLOCK button on the
keyless entry system transmitter. If the
transmitter doesn’ t work, unlock the
driver ’s door with a key. Open the
door and within 15 seconds, put the

Form No. 8P95-EA-00G
Knowing Your Mazda3-32
015-5AE
CAUTION
!
Make sure the fuel-filler cap is
tightened securely. The check
engine light comes on when the
cap isn’ t tightened securely. If the
light remains on (even after you
have tightened the cap securely,
driven, and restarted the engine
several times), it may indicate a
different problem. Contact an
Authorized Mazda Dealer as soon
as possible.
 022-1FE
Steering WheelJ94A2052_aTilt wheel
release lever Tilt Wheel
To change the angle of the steering
wheel, stop the vehicle, pull the tilt
wheel release lever on the left side of
the steering column down, adjust the
wheel, then push the release lever up
to lock the column. After adjusting, push the wheel up and
down to be certain it’
s locked before
driving.
WARNING
!
Adjusting the Tilt Wheel:Adjusting the tilt wheel while the
vehicle is moving can be
dangerous. Moving it up and
down can very easily cause the
driver to abruptly turn to the left
or right. This can lead to loss of
control or an accident. Never
adjust the tilt wheel while the
vehicle is moving.

Form No. 8P95-EA-00G
Protecting Your Mazda
4-13
WARNING
!
Mixing Tire Types:Using tires different in size or type
is dangerous. Your vehicle’s
handling could be greatly affected
and result in an accident. Use
only the same size and type tires
(snow, radial, or non-radial) on
all four wheels.NOTECheck local regulations before
using studded tires.

037-9A5E
 Tire chains
Check local regulations before using
tire chains.
Install the chains on the front tires.
Don’ t use chains on the rear tires.
Use only SAE Class “S” chains, and
make sure they fit.
To install the chains:
1. Remove the wheel covers, or the chain bands will scratch them.
2. Secure the chains on the front tires as tightly as possible. Always
follow the chain manufacturer ’s
instructions. 3. Retighten the chains after driving
1/2-1 km (1/4-1/2 mile).

Form No. 8P95-EA-00G


*Some models.Driving Your Mazda
5-39

053-55A1E
 Traction Control System
(TCS) Warning Light*
This warning light stays on for a few
seconds when the ignition switch is
turned to the ON position.
The light flashes when the system
regulates engine torque and will stay
on if the system malfunctions. If it
stays on while the system is operating,
consult an Authorized Mazda Dealer.
053-8BE
 Low Fuel Warning Light
This warning signals that the fuel tank
will soon be empty. Get fuel as soon as
possible.

053-9FE
 Check Engine Light
If this light comes on while driving,
the vehicle may have a problem. It is
important to note the driving
conditions when the light came on and
consult an Authorized Mazda Dealer. The check engine light may come on
in the following cases:
•
The fuel tank level being very low
or approaching empty.
• The engine’ s electrical system has a
problem.
• The emission control system has a
problem.
• A ROOM fuse blows or is
removed.
• The fuel-filler cap is missing or not
tightened securely.

Form No. 8P95-EA-00G
*Some models.
Driving Your Mazda5-40If the check engine light flashes
continuously, decrease your speed and
consult an Authorizd Mazda Dealer as
soon as possible.

053-12CE
 Door-Ajar Warning
Light
This warning light comes on when any
door or trunk isn’ t securely closed.
Q053-15IE
Antilock Brake System
(ABS) Warning Light*
The warning light stays on for a few
seconds when the ignition switch is
turned to the ON position.
If the ABS warning light stays on
while you’re driving, the ABS control
unit has detected a system
malfunction. If this occurs, your
brakes will function normally as if the
vehicle had no ABS. Should this
happen, consult an Authorized Mazda
Dealer as soon as possible.
NOTEWhen the engine is jump-started to
charge the battery, uneven rpm
occurs and the ABS warning light
comes on. This is due to a weak
battery, not a malfunction.
Recharge the battery.

Form No. 8P95-EA-00G
*Some models.Driving Your Mazda
5-41

053-16RE
 Supplemental Restraint
System Warning Light
If the supplemental restraint system is
OK, the warning light comes on when
the ignition switch is turned to the ON
position or after the engine is cranked.
After about 6 seconds it goes out.
A system malfunction is indicated
when this light constantly flashes,
stays on or doesn’ t come on at all. If
one of these occur, consult an
Authorized Mazda Dealer as soon as
possible. The system may not work in
an accident.
WARNING
!
Self-Servicing the SupplementalRestraint System:Self-servicing or tampering with
the supplemental restraint system
is dangerous. The air bags could
accidentally activate or become
disabled. This could cause serious
injuries. Never tamper with the
supplemental restraint system and
always have an Authorized Mazda
Dealer perform all servicing and
repairs.

053-49BE
 Immobilizer System
Warning/Security
Indicator Light*
 Immobilizer system warning light
When the key is in the ignition, this
light serves as the immobilizer system
warning light.
If the immobilizer system is working
properly, the light will come on when
the ignition is turned to the start
position. The light will go out when
the engine starts.

Form No. 8P95-EA-00G
Driving Your Mazda5-42If the light flashes rapidly, fails to
come on, or comes on and stays on, it
indicates a system malfunction. If any
of these occur, contact an Authorized
Mazda Dealer as soon as possible.
Security indicator light
When there is no key in the ignition,
and the theft-deterrent system has been
armed, the light will flash once every
three seconds. This indicates that the
system is working properly.
053-18F1E
 Ignition Key Reminder
If the ignition switch is in the LOCK
or ACC position, a beep will sound
when any door is opened.
053-19FE
 Lights-On Reminder
If lights are on and the key is removed
from the ignition switch, a beep will
sound when any door is opened.
053-20A1E
 Headlight High-Beam
Indicator Light
This light indicates one of two things:
• The high-beam headlights are on.
• The turn-signal lever is in the
flash-to-pass position.
053-33AE
Rear Window Defroster
Indicator Light
This light comes on when the rear
window defroster is on.

Form No. 8P95-EA-00G
In Case of Emergency6-20
076-2A1E
J94A5014\bTo remove the jack
Turn the wing bolt counterclockwise.
076-29A1E
\b To secure the jack
Perform the removal procedure in
reverse.
076-3A1E
J94S6006
\b To remove the spare tire
Turn the tire hold-down bolt
counterclockwise with the lug wrench.