2001 MAZDA MODEL 626 lock

Form No. 8P95-EA-00G
Essential Safety Equipment2-12

Q019-4A2E
WARNING
!
Unlocked Seatback:A seatback plays an important
role in your protection in a
vehicle. Leaving the seatback
unlocked is dangerous as it can
allow passengers to be ejected or
thrown around and baggage to
strike occupants in a sudden stop
or collision, resulting in severe
injury. After returning the seat at
any time, even when there are no
other passengers, attempt to push
the seatback forward and
backward to make sure it is
locked in place.
WARNING
!
Passenger on the FoldedSeatback:Driving with a passenger on the
folded seatback is dangerous.
Allowing a child to sit up on the
folded seatback while the vehicle
is moving is particularly
dangerous. In a sudden stop or
even a minor collision, a child not
in a proper seat or child-restraint
system and seat belt could be
thrown forward, back or even out
of the car resulting in serious
injuries or death. The child or
other objects in the baggage area
could be thrown into other
(Continued)
occupants and cause serious
injury. Never allow a passenger to
sit or stand on the folded seatback
while the vehicle is moving.
WARNING
!
Children and the Folding RearSeat:Playing with the folding rear seat
is dangerous. The folding rear
seatbacks cannot be folded down
from inside the luggage
compartment. Do not give the car
keys to children and do not allow
them to play in the vehicle.

Form No. 8P95-EA-00G
Essential Safety Equipment
2-13
019-5EE
J94A2072
Unlock
Unlock Lock
Lock
 Rear Seatback Lock
To lock or unlock a seatback, move
the lever.
Q019-17AE
NOTEThe seatback locks are part of the
trunk security system (page 3-17).

Form No. 8P95-EA-00G
Essential Safety Equipment2-14


020-1IE
Seat Belt SystemSeat belts help to decrease the
possibility of severe injury during
accidents and sudden stops. Mazda
recommends that the driver and all
passengers always wear seat belts.
All of the seat belt retractors are
designed to keep the lap/shoulder belts
out of the way when not in use.
The driver ’s seat belt has no
provisions for child-restraint systems
and has only an emergency locking
mode. The driver may wear it
comfortably, and it will lock during a
collision.
However, the front passenger ’s seat
and rear lap/shoulder belt retractors operate in two modes, emergency
locking mode and for child-restraint
systems, automatic locking mode.
Emergency locking mode
If the belt has fully retracted, it will
always be in the emergency locking
mode until you move it into automatic
locking mode by pulling the belt all
the way out to its full length. In the
emergency locking mode, the belt
remains comfortable on the occupant
and the retractor will lock in position
during a collision.
If the belt feels tight and hinders
comfortable movement while the
vehicle is stopped or in motion, youmay be in the automatic locking mode
because you have pulled the belt too
far out. To return to the more
comfortable emergency locking mode,
wait until you can stop the vehicle in a
safe area, retract the belt fully to
convert it back to emergency locking
mode and then again extend it around
you.
Automatic locking mode
Always use the automatic locking
mode to keep the child-restraint
system from shifting to an unsafe
position in the event of an accident. To
get the seat belt into the automatic
locking mode, pull it all the way out
and connect it as instructed on the

Form No. 8P95-EA-00G
Essential Safety Equipment
2-15
child-restraint system. It will retract
down to the child-restraint system and
stay locked on it. See the section on
child restraint (page 2-26).

020-2A2E
WARNING
!
Not Wearing Seat Belts:Not wearing a seat belt is
extremely dangerous. During a
collision, occupants not wearing
seat belts could hit someone or
things inside the vehicle or even
be thrown out of the vehicle. They
could be seriously injured or even
killed. In the same collision,
occupants wearing seat belts
would be much safer. Always
wear your seat belt and make
sure all occupants are properly
restrained.
WARNING
!
Seat Belt Damaged During anAccident:Using a damaged seat belt is
dangerous. An accident could
damage the belt webbing of the
seat belt in use. A damaged seat
belt cannot provide adequate
protection in a collision. Have an
Authorized Mazda Dealer inspect
all seat belt systems in use during
an accident before they are used
again.

Form No. 8P95-EA-00G
Essential Safety Equipment2-18
WARNING
!
Positioning the Shoulder Portionof the Seat Belt:Improper positioning of the
shoulder portion of the seat belt is
dangerous. An improperly
positioned belt will provide little
or no protection in a collision.
Always make sure the shoulder
portion of the seat belt is
positioned across your shoulder
and near your neck, but never
under your arm, on your neck, or
on your upper arm.


020-22A3E
Shoulder belt adjuster
J94A2036
This adjusts the shoulder belt angle for
a more comfortable fit. Simply push
the button, move it to the desired
position, and then release it. Make
sure the adjuster is locked.
J94A2037
(J18Y2806)

Form No. 8P95-EA-00G
94S004–002
For rear
center seat
For rear
right seatCover
Open
Essential Safety Equipment
2-31
J76TCS06lap/shoulder belt. See the
instructions on the child-restraint
system for belt routing instructions.
2. To get the retractor into the automatic locking mode, pull the
shoulder belt portion of the seat
belt until the entire length of the belt is out of the retractor. Position
the belt correctly, push the
child-restraint system firmly into
the vehicle seat and be sure the belt
retracts as snugly as possible.
Clicking from the retractor will be
heard during retraction if the
system is in the automatic locking
mode. If the belt does not lock the
seat down tight, repeat this step.
3. Inspect this function before each use of the child-restraint system.
You should not be able to pull the
shoulder belt out of the retractor
while the system is in the automatic
locking mode. When you remove
the child-restraint system, be sure
the belt fully retracts to return the system to emergency locking mode
before occupants use the seat belts.
4. If your child-restraint system requires the use of a tether strap,
hook the tether strap by following
the manufacturer ’s instructions.

Form No. 8P95-EA-00G
Essential Safety Equipment2-34in the rear seat, do not allow the
child to lean over or against the
front door, even if the child is
seated in a child-restraint system.
J54A2112HFront passenger ’s seat
child-restraint system installation
(Lap/shoulder belt)
1. Slide the seat as far back as possible. 2. Secure the child-restraint system with
the lap portion of the lap/shoulder
belt. See the instructions on the
child-restraint system for belt routing
instructions.
3. To get the retractor into the automatic locking mode, pull the
shoulder belt portion of the seat belt
until the entire length of the belt is
out of the retractor. Position the belt
correctly, push the child-restraint
system firmly into the vehicle seat
and be sure the belt retracts as snugly
as possible. Clicking from the
retractor will be heard during
retraction if the system is in
automatic locking mode. If the belt
does not lock the seat down tight,

Form No. 8P95-EA-00G
*Some models.
Essential Safety Equipment
2-35
repeat this step.
4. Inspect this function before each use of the child-restraint system.
You should not be able to pull the
shoulder belt out of the retractor
while the system is in the automatic
locking mode. When you remove
the child-restraint system, be sure
the belt fully retracts to return the
system to emergency locking mode
before occupants use the seat belts.

000–00?
Supplemental Restraint
Systems The front and side* supplemental
restraint systems include 4 air
bags. They are located in:
• The steering wheel
• The passenger side dashboard
• The outboard sides of the front
seatbacks
These systems operate independently
depending on the type of accident
encountered; both side air bags are not
likely to deploy in the same accident
because a vehicle is not often hit from
both sides. The front and side air bag
systems will not normally deploy
during the same type of accident
unless a combination of frontal and
side impacts occur. In a front-end or side impact, the air
bag supplemental restraint systems are
designed to provide only supplemental
protection for the driver and front seat
passenger. Seat belts must still be
worn.
Without seat belt usage, the air bags
cannot provide adequate protection
during an accident. Seat belt usage is
necessary to:
•
Keep the passenger away from an
inflating air bag.
• Reduce the possibility of injuries
during an accident that is not
designed for air bag inflation, such
as roll-over or rear impact.