Automatic Air Conditioning Controls
82SETTING OPERATION ± manual control
When one of the manual control buttons
is depressed while operating in automat-
ic mode, the mode relevant to the de-
pressed button is set. Other conditions
continue to be adjusted automatically.
If manual air flow selection is desired ±
UNG504
The outlets from which air is delivered can be
selected manually by touching the switch.
The function of each mode is as follows:
1
Panel ± Air flows mainly from the instru-
ment panel vents.
2
Bi±level ± Air flows from both the floor
vents and the instrument panel vents.
3
Floor ± Air flows mainly from the floor
vents.
It is recommended to close the lower vent.
For details about it, see page 88.
4
Floor/Windshield ± Air flows mainly
from the floor vents and windshield
vents.
It is recommended to close the lower vent.
For details about it, see page 88.
The selected mode is highlighted in green.
If quick heating or cooling is desired ±
UNG505
Push the ºTEMPº or ºPASSENGER TEMPº
button on either side and hold it until the max-
imum figure or minimum figure appears.If manual fan speed control is desired ±
UNG506
1
Fan speed at low
2
Fan speed at high
The fan speed can be set to your desired
speed by touching the appropriate air flow
control switch. The higher the fan speed is,
the more air is delivered. Pushing the ºOFFº
button turns off the fan.
To remove exterior windshield frost, use the
high speed setting.
The selected mode is highlighted in green.
Automatic Air Conditioning Controls
84If manual on±off of the air conditioning is
desired ±
Push the ºA/Cº button to turn the air condi-
tioning on and push it again to turn the air
conditioning off. If you turn off the air condi-
tioning manually, the EXHAUST GAS AUTO-
MATIC mode will be cancelled.
If the outside temperature is lowered down to
around 0C (32F), the air conditioning will
turn off automatically. At this time, the indica-
tor on the A/C button is off and the EXHAUST
GAS AUTOMATIC indicator light remains on.
However, the EXHAUST GAS AUTOMATIC
mode does not operate. When the air condi-
tioning turns on as with the raised tempera-
ture, the EXHAUST GAS AUTOMATIC
mode resumes.
If the system is used for ventilation, heating
in dry weather or removing frost or exterior
fog on the windshield, turn the air condition-
ing off once it is no longer required. This will
improve fuel economy. The air conditioning
can be used for year±round automatic tem-
perature control including cooling and dehu-
midifying operation.If the air conditioning compressor does not
operate, the indicator of the ºA/Cº button will
blink. If the indicator of the ºA/Cº button
blinks even when the ºA/Cº button is pushed
again, have the compressor checked by
your nearest Lexus dealer.
(b) Windshield defogging and
defrosting
UNG509
To remove interior fog on the windshield
±
Push the ºFRONT WINDSHIELDº button.
To remove frost or exterior fog on the
windshield ±
1. Push the upper side of the temperature
control button until maximum figure appears
on the temperature display.
2. Push the ºFRONT WINDSHIELDº but-
ton.
