Automatic Air Conditioning Controls
80The automatic air conditioning auto-
matically maintains the set tempera-
ture.
This air conditioning features automatic
fan speed and air flow control which auto-
matically selects the most suitable fan
speed and air flow to control the tempera-
ture. The ignition key must be in the ºONº
position.
CLIMATE: Push this button to display
switches for automatic air conditioning con-
trols.
NOTICE
To prevent the battery from being dis-
charged, do not leave the air condition-
ing on longer than necessary when the
engine is not running.
(a) Climate control
SETTING OPERATION ± automatic con-
trol
UNG502
1. Push the ºAUTOº button.
Air flow quantity, switching of the diffusers,
on±off of the air conditioning, and switching
of the air intake between RECIRCULATED
AIR and OUTSIDE AIR are automatically ad-
justed. The operation status is shown by
each indicator.
When one of the manual control buttons is
depressed while operating in automatic
mode, the mode relevant to the depressed
button is set. Other conditions continue to be
adjusted automatically.Push the ºOFFº button to turn the air condi-
tioning off.
It is recommended to close the lower vent.
For details about it, see page 88.
Automatic Air Conditioning Controls
82SETTING OPERATION ± manual control
When one of the manual control buttons
is depressed while operating in automat-
ic mode, the mode relevant to the de-
pressed button is set. Other conditions
continue to be adjusted automatically.
If manual air flow selection is desired ±
UNG504
The outlets from which air is delivered can be
selected manually by touching the switch.
The function of each mode is as follows:
1
Panel ± Air flows mainly from the instru-
ment panel vents.
2
Bi±level ± Air flows from both the floor
vents and the instrument panel vents.
3
Floor ± Air flows mainly from the floor
vents.
It is recommended to close the lower vent.
For details about it, see page 88.
4
Floor/Windshield ± Air flows mainly
from the floor vents and windshield
vents.
It is recommended to close the lower vent.
For details about it, see page 88.
The selected mode is highlighted in green.
If quick heating or cooling is desired ±
UNG505
Push the ºTEMPº or ºPASSENGER TEMPº
button on either side and hold it until the max-
imum figure or minimum figure appears.If manual fan speed control is desired ±
UNG506
1
Fan speed at low
2
Fan speed at high
The fan speed can be set to your desired
speed by touching the appropriate air flow
control switch. The higher the fan speed is,
the more air is delivered. Pushing the ºOFFº
button turns off the fan.
To remove exterior windshield frost, use the
high speed setting.
The selected mode is highlighted in green.
