2001 Lexus ES300 Page 31

COMFORT ADJUSTMENT
203
16E211
Fix the child restraint system with the seat belt.
Latch the hook onto the anchor bracket and tighten
the top strap.
For instructions to install the child restraint system, see
ªChild restraint systemº on page 178.
CAUTION
Make sure the top strap is securely latched, and check
that the child restraint system is securely by pushing
and pulling it in different directions. Follow all the
installation instructions provided by its manufacturer.

AUDIO
240
1Turning the system on and adjusting volume
(See page 241 for details.)
2Stopping and ejecting a cassette tape
(See page 250 for details.)
3Function buttons
1 ± 6: Station selector buttons
(See page 247 for details.)
SCAN: Scan tuning
(See page 250 for details.)
P. SCAN: Preset scan tuning (See page 250 for details.)
4Display of functions in TAPE mode

:
Side change
(See page 252 for details.)
: DOLBY NR
(See page 252 for details.)
 :Rewinding
(See page 253 for details.)


:Fast forwarding
(See page 253 for details.)
RPT: Automatic repeat
(See page 254 for details.)
SKIP: Automatic skip of blank portions of tape
(See page 254 for details.)
4
Display of functions in CD mode
:Disc selection
(See page 260 for details.)
 :Reversing
(See page 264 for details.)


:Fast forwarding
(See page 264 for details.)
RPT: Automatic repeat
(See page 265 for details.)
RAND: Random access
(See page 265 for details.)
SCAN: Scan selection
(See page 262 for details.)
5
Mode selectors
(See page 242 for details.)
6Cassette tape slot
(See page 250 for details.)
7Tone and balance knobs
(See page 243 for details.)
8Radio mode: Frequency tuning
( S e e p a g e 246 o r 248 f o r
details.)
TAPE mode: Direct access to a desired
program (See page 255 for details.)
CD mode: Direct access to a desired

AUDIO
241
program
(See page 263 for details.)
Using your audio system: some basics
This section describes some of the basic features of the
Lexus audio system. Some information may not pertain
to your system.
Your audio system works when the ignition key is in the
ªACCº or ªONº position.
NOTICE
To prevent the battery from being discharged, do not leave the car audio on longer than necessarywhen the engine is not running.
(a) Turning the system on and off
20E101
Push this knob to turn the audio system on and off.
Turn this knob to adjust the volume.
The system turns on in the last mode used.
20E102

STARTING AND DRIVING
280ªSTARTº ± Starter motor on. The key will return to
the ªONº position when released.
For starting tips, see page 283.
ªONº ± Engine on and all accessories on.
This is the normal driving position.
NOTICE
Do not leave the key in the ªONº position if the
engine is not running. The battery will dischargeand the electronic ignition system could bedamaged.
ªACCº ± Accessories such as the radio operate, but
the engine is off. If you leave the key in the ªACCº or ªLOCKº position and
open the driver's door, a buzzer will remind you to
remove the key.
31E070

STARTING AND DRIVING
281
ªLOCKº ± Engine is off and the steering wheel is
locked. The ignition key can be removed only at this
position.
You must push in the key to turn it from ªACCº to the
ªLOCKº position. The selector lever must be put in the
ªPº position before turning the key to the ªLOCKº
position.
Once you remove the key, the engine immobiliser
system is automatically set. See ªEngine immobiliser
systemº on page 12.
When
starting the engine, the key may seem stuck at the
ªLOCKº position. To free it, first be sure the key is
pushed all the way in, and then rock the steering wheel
slightly while turning the key gently.
If, in an emergency, you must turn the engine off while
the vehicle is moving, turn the key only to ªACCº.
PARKING BRAKE
31E080

STARTING AND DRIVING
283
HOW TO START THE ENGINE
Before cranking
1. Apply the parking brake firmly.
2. Turn off unnecessary lights and accessories.
3. Put the selector lever in ªPº. If you need to restart the
engine while the vehicle is moving, put the selector lever
in ªNº. A starter safety device will prevent the starter
from operating if the selector lever is in any drive
position.
4. Depress the brake pedal and hold it to the floor until
driving off.
Starting the engine
Before starting the engine, be sure to follow the
instructions in ªBefore crankingº.
Normal starting procedure
The multiport fuel injection system/sequential multiport
fuel injection system in your engine automatically
controls the proper air±fuel mixture for starting. You can
start a cold or hot engine as follows:
1. With your foot off the accelerator pedal, crank the
engine by turning the key to ªSTARTº. Release it when
the engine starts.
2. After the engine runs for about 10 seconds, you are
ready to drive. If the weather is below freezing, let the engine warm up
for a few minutes before driving. Do not leave the vehicle
while the engine is warming up.
If the engine stalls ...
Simply restart it , using the correct procedure given in
normal starting.
If the engine will not start
See ªIf your vehicle will not startº on page 343.
NOTICE
Do not crank for more than 30 seconds at a
time. This may overheat the starter and wiringsystems.
Do not race a cold engine.
If the engine becomes difficult to start or stallsfrequently, have the engine checkedimmediately.

STARTING AND DRIVING
285
2Overdrive switch
For selecting either a three±speed or four±speed
transmission.
When the cruise control is being used, even if you
downshift the transmission by turning off the
overdrive switch, engine braking will not be
enabled because the cruise control is not
cancelled. For the operation to decrease the
vehicle speed, see page 300.
3Shift position indicator
The shift position is also displayed on the
instrument cluster.
P:Parking, engine starting and key removal
position
R: Reverse position
N: Neutral position
D: Normal driving (with overdrive on) position
2: Position for stronger engine braking
L: Position for maximum engine braking Correct use of the automatic transmission is
explained in the following parts.
(a) Overdrive switch
(b) Normal driving
(c) Using engine braking
(d) Using the ª2º and ªLº positions
(e) Backing up
(f) Parking
(g) Good driving practice
(h) Rocking your vehicle if stuck
(i) If you cannot shift the selector lever out of ªPº
position

STARTING AND DRIVING
286
(a)Overdrive switch
31E082
You can select either third gear (with overdrive off) or
fourth gear (with overdrive on) by pushing this switch.
To turn the overdrive off, push the switch. The ªO/D
OFFº indicator light should come on. To turn the
overdrive on again, push the switch again. The ªO/D
OFFº indicator light should go off.
Always drive your vehicle with the overdrive on for better
fuel economy and quieter driving.
If the engine is turned off when the overdrive is off and
restarted, the overdrive will automatically be on.
When the cruise control is being used, even if you
downshift the transmission by pushing and releasing the
overdrive switch, engine braking will not be enabled
because the cruise control is not cancelled.
For ways to decrease the vehicle speed, see page 300.