2001 LAND ROVER FREELANDER engine

GENERAL DATA
04-16
Fuel system - Td4 Diesel
System Common rail, direct injection
Fuel specification EN590 diesel*
⇒ Pump output 250 kPa (2.5 bar, 36.3 lbf.in
2)
Fuel pump
⇒ Up to 03 MY
⇒ Pump output
⇒ 03 MY onwardsElectric - submersible in fuel tank
250 kPa (2.5 bar, 36.3 lbf.in
2)
Fuel tank pump deleted, replaced by auxiliary delivery pump located
in RH rear wheel arch
Auxiliary delivery pump
⇒ Up to 03 MY
⇒ 03 MY onwardsElectrical - in line, located in engine compartment
Electrical - in line, located in RH rear wheel arch
Maximum delivery volume 240 litres per hour (52.75 imp. gallons) @ 12V
Fuel high pressure pump Bosch Cp1 mechanical high pressure, 3 radial piston
⇒ Drive Chain driven from crankshaft at 0.75 x engine speed
⇒ Pressure control Mounted on CP1, controlled by DDE 4.0
Pressure regulator
⇒ Up to 03 MY
⇒ 03 MY onwardsLocated in engine compartment between fuel filter and injection pump
Incorporated with in-tank suction and sender module
⇒ Pressure (nominal) 2.4 to 2.8 bar (34.8 to 40.6 lbf.in
2)
Injectors:
⇒ Make
⇒ Nozzle type
⇒ Position
⇒ Impedance
⇒ Injector operating pressureBosch CRI 0445 110 030
DSLA 145P 868
Central
14.5 Ω ± 5% @ 20%
250 - 1350 bar (3625 - 19575 lbf.in
2)
Injection begins:
⇒ Pre-injection (maximum) 60° BTDC
⇒ Main injection (maximum) 25° BTDC
⇒ Post injection 100 - 200° crank ATDC
Injection timing Controlled by Bosch DDE 4.0 engine management system for
common rail injection
Injection quantity 1 - 80 mm
3
Pre-delivery fuel pressure sensor
⇒ Up to 03 MY
⇒ 03 MY onwardsBosch / DS-K-400/50, located in filter head
Bosch /DS-K-400kPa, in-line, located in engine compartment
⇒ Pressure 400 kPa (58.0 lbf/in
2)
Fuel rail pressure sensor:
⇒ Measuring range 0 - 1500 bar (0-21750 lbf/in
⇒ Over pressure (max.) 1800 bar (26100 lbf/in
2)
⇒ Burst pressure 3000 bar (43500 lbf/in
2)
⇒ Temperature range -40°C to +120°C (-40°F to +248°F)
Fuel filter
⇒ Up to 03 MY
⇒ From 03 MYIn-line between auxiliary fuel pump and high-pressure fuel injection
pump, located in engine compartment
In-line, located in RH rear wheel arch

GENERAL DATA
04-20
Clutch
Type Maintenance free hydraulic system
Pressure plate diameter (all variants) 228 mm (8.976 in.)
Drive plate diameter (all variants) 228 mm (8.976 in.)
Clutch plate friction material Valeo F808
Diaphragm finger height when clamped on a thick
gauge plate28.58 - 31.54 mm (1.125 - 1.242 in.)
Diaphragm finger clearance (service limit) 1.0 mm (0.039 in)
Clutch plate thickness under 6600 N (1484 lb) axial
load:
⇒ New 6.9 - 7.5 mm (0.272 - 0.295 in.)
⇒ Service limit (K1.8/PG1) 5.60 mm (0.220 in.)
⇒ Service limit (Td4/Getrag) 5.60 mm (0.220 in.)
Rivet depth:
⇒ New 1.2 mm (0.047 in.) above rivet head
⇒ Service limit 0.20 mm (0.008 in.) above rivet head
Clutch plate run-out:
⇒ New 0.4 mm (0.016 in.)
⇒ Service limit 0.4 mm (0.016 in.)
Pressure plate warpage (Service limit):
⇒ K1.8 engine with PG1 gearbox 0.18 mm (0.0071 in.)
⇒ Td4 engine with Getrag gearbox 0.18 mm (0.0071 in.)

GENERAL DATA
04-24
Intermediate Reduction Drive (IRD)
Ratios:
⇒IRD input shaft to IRD countershaft 0.828 : 1
⇒ IRD countershaft to Front driveshaft 1.762 : 1
⇒ IRD countershaft to Propeller shaft 0.553 : 1
IRD ratio:
⇒ Td4 engines
⇒ K1.8 engines
⇒ KV6 engines1.467 : 1
1.467 : 1
1.359 : 1
Oil cooler Connected to vehicle cooling system

GENERAL DATA
04-25
Automatic Gearbox - Jatco
Gear Ratios - Td4 engine:
⇒ First 3.801:1
⇒ Second 2.131:1
⇒ Third 1.364:1
⇒ Fourth 0.935:1
⇒ Fifth 0.685:1
⇒ Reverse 2.970:1
Gear ratios - KV6 engine
⇒ First 3.474 : 1
⇒ Second 1.948 : 1
⇒ Third 1.247 : 1
⇒ Fourth 0.854 : 1
⇒ Fifth 0.685 : 1
⇒ Reverse 2.714 : 1
Final drive ratio:
⇒ Td4 engine
⇒ KV6 engine2.91 : 1
3.66 : 1
Torque converter lock-up
Td4
KV6Engaged in fourth and fifth gears.
50% throttle - 80 Kph (50 mph) in normal drive mode
50% throttle - 110 Kph (69 mph) in normal drive mode

GENERAL DATA
04-26
Rear Axle and Final Drive
Rear Axle
Type Hypoid gear, centreline of drive pinion below centre of ring gear
Differential carrier material Aluminium
Ring gear to Pinion gear backlash tolerance 0.13 to 0.20 mm (0.005 - 0.008 in)
Propeller shaft to rear driveshaft ratio 3.214 : 1
Final Drive
Ratios:
⇒ Td4 engine with manual gearbox 3.182 : 1
⇒ Td4 engine with automatic gearbox 2.91 : 1
⇒ K1.8 engine 4.200 : 1
⇒ KV6 engine 3.66 : 1
Hill Descent Control (HDC) speeds:
Minimum forward 9.6 km/h (6.0 mph)
Minimum reverse 6.5 km/h (4.0 mph)
Viscous coupling
Rating:
⇒ Max 440 Nm (325 lbf.ft) @ 75 rpm
⇒ Min 360 Nm (265 lbf.ft) @ 75 rpm

GENERAL DATA
04-32
Wheels and tyres
Tyre pressures
Wheel type and size:
⇒ Standard 51/2 J x 15" steel
⇒ Option 51/2 J x 15" alloy
⇒ Option 6.0 J x 16" alloy
⇒ Option 6.0 J x 16" alloy
Tyre sizes
5
1/2 J x 15" Wheels 195/80 R15 'Multi terrain' tyre
6 J x 16" Wheels 225/55 R17 'Multi terrain' tyre
7 J x 17" Wheels 225/55 R17 'Multi terrain' tyre
Front and rear – all engine variations
⇒ Normal driving conditions (up to 4 passengers and
luggage)2.1 bar (30 lbf/in
2)
⇒ Maximum Gross Vehicle Weight 2.1 bar (30 lbf/in
2)
⇒ Towing 2.1 bar (30 lbf/in
2)

GENERAL DATA
04-33
Heating and Ventilation
Air Conditioning
PTC heater - Td4 engine - if fitted
⇒ Make/Type Catem, 900 Watt output, 12 volt supply, located in Hevac unit
FBH - Td4 engine - if fitted
⇒ Make/Type Webasto Thermotop C, self-regulating, 5 kW output
System CFC free, sealed, closed-loop system
Refrigerant HFC - R134a
Refrigerant charge quantity:
All models except LHD KV6
LHD KV6 models540 ± 25 grammes
430 ± 25 grammes
Compressor, up to 04MY (some very early 04MY
vehicles may be fitted with this type of compressor):
⇒ Type Denso - variable displacement, 7-cylinder swash plate unit
⇒ High Pressure Blow-off valve 35.3 bar (3.53 MPa, 512 lbf/in
2)
⇒ Displacement (Min.) 5%
⇒ Displacement (Max.) 95%
Compressor, 04MY onwards
⇒ Type Sanden PXV16 - variable displacement, 7-cylinder swash plate unit
⇒ High Pressure Blow-off valve 35.3 bar (3.53 MPa, 512 lbf/in
2)
⇒ Displacement (Min.) 3%
⇒ Displacement (Max.) 100%
Lubricating oil Nippon Denso ND-8
Evaporator thermostat:
⇒ Opens
⇒ Closes+2 °C (+36 °F)
-4 °C (+25 °F)
Condenser fan control PWM signal from ECM to cooling fan control unit
Refrigerant Pressure Sensor
Low pressure limit:
⇒ A/C on (pressure rising) 2.25 ± 0.2 bar (32.6 ± 2.9 lbf/in
2)
⇒ A/C off (pressure falling) 1.96 ± 0.2 bar (28.4 ± 2.9 lbf/in
2)
High pressure limit:
⇒ A/C off (pressure rising) 31.4 ± 2.0 bar (455.3 ± 29 lbf/in
2)
⇒ A/C on (pressure falling) 25.5 ± 2.0 bar (369.8 ± 29 lbf/in
2)

GENERAL DATA
04-34
Electrical - Td4 engine
Electrical - K1.8 engine
Electrical - KV6 engine
System 12 volt, negative earth
Battery:
⇒ Type
⇒ CapacityH6, sealed for life
75 amp /hour
⇒ Type
⇒ CapacityH7, sealed for life (cold climates)
80 amp /hour
Alternator:
⇒ Type
⇒ Maximum output
⇒ Maximum output (models with PTC heater)Nippon Denso K-frame
105 amp
150 amp
System 12 volt, negative earth
Battery:
⇒ Type
⇒ CapacityH5, sealed for life
55 amp/hour
Alternator
⇒ Type
⇒ Maximum outputNippon Denso K-frame
105 amp
System 12 volt, negative earth
Battery:
⇒ Type
⇒ CapacityH6, sealed for life
75 amp/hour
Alternator:
⇒ Type
⇒ Maximum outputNippon Denso L-frame
120 amp