2001 HONDA ODYSSEY radiator

[x] Cancel search: radiator

Page 57 of 363

HONDA ODYSSEY 2001 RA6-RA9 / 2.G Owners Manual These labels are in the locations 
shown. They warn you of potential
hazards that could cause serious
injury. Read these labels caref ully. 
If a label comes of f or becomes hard 
to read, contact you

Page 200 of 363

HONDA ODYSSEY 2001 RA6-RA9 / 2.G Owners Manual Refer toon page f or inf ormation
on checking other items in your 
Honda.
Look at the coolant level in the
radiator reserve tank. Make sure it is
between the MAX and MIN lines. If
it is below the MIN

Page 246 of 363

HONDA ODYSSEY 2001 RA6-RA9 / 2.G Owners Manual µµ µ
µ
µ
µ µ
Youshouldcheckthefollowing 
items at the specif ied intervals. If
you are unsure of how to perf orm
any check, turn to the page given.
Engine oil level Check every
time you

Page 252 of 363

HONDA ODYSSEY 2001 RA6-RA9 / 2.G Owners Manual If the coolant level in the reserve 
tank is at or below the MIN line, add
coolant to bring it up to the MAX line.
Inspect the cooling system f or leaks.
This coolant should always be a
mixtureof 50pe

Page 253 of 363

HONDA ODYSSEY 2001 RA6-RA9 / 2.G Owners Manual Make sure the engine and radiator 
are cool. 
Turn the radiator cap counter- 
clockwise, without pressing down
on it, until it stops. This relieves
any pressure remaining in the
cooling system. 
Remov

Page 254 of 363

HONDA ODYSSEY 2001 RA6-RA9 / 2.G Owners Manual CONT INUED
Loosen the drain plug on the 
bottom of the radiator. The
coolant will drain through the
splash guard. Loosen the drain
bolt.
Turn the ignition ON (II). Turn
the heater temperature control

Page 255 of 363

HONDA ODYSSEY 2001 RA6-RA9 / 2.G Owners Manual When the coolant stops draining, 
tightenthedrainplugatthe
bottom of the radiator. 
Tighten the drain bolt at the rear 
of the engine cylinder block
securely.
Tightening torque:
Remove the reserve tan

Page 256 of 363

HONDA ODYSSEY 2001 RA6-RA9 / 2.G Owners Manual Fill the reserve tank to the MAX 
mark. Install the reserve tank cap. 
Install the radiator cap, and 
tighten it to the first stop. 
Start the engine and let it run until 
the radiator cooling f an co
Page:   1-8 9-16 next >