2001 HONDA CIVIC drain bolt

[x] Cancel search: drain bolt

Page 206 of 319

HONDA CIVIC 2001 7.G Owners Manual Remove the oil f ilter and let the 
remaining oil drain. A special
wrench (available from your
Honda dealer) is required to
remove the f ilter. 
Install a new oil f ilter according to 
instructions th

Page 207 of 319

HONDA CIVIC 2001 7.G Owners Manual Put a new washer on the drain bolt, 
then reinstall the drain bolt.
Tighten it to:Replace the engine oil f ill cap.
Start the engine. The oil pressure
indicator light should go out within
f ive second

Page 210 of 319

HONDA CIVIC 2001 7.G Owners Manual CONT INUED
Remove the radiator cap.
Turn the ignition ON (II). Turn 
the temperature control dial to
maximum heat. Turn of f the
ignition. Open the hood. Make
sure the engine and radiator are
cool to

Page 211 of 319

HONDA CIVIC 2001 7.G Owners Manual µ
´ ´ µ
Disconnect the battery cables
f rom the terminals. Disconnect
the negative ( ) cable first, then
the positive ( ) cable. 
Remove the bolt and nut, then 
remove the battery case. Remove

Page 212 of 319

HONDA CIVIC 2001 7.G Owners Manual Tightening torque:
When the coolant stops draining, 
tightenthedrainpluginthe
bottom of the radiator. Apply non-
hardening sealant to the drain bolt
threads, put a new washer on the
drain bolt, and re

Page 216 of 319

HONDA CIVIC 2001 7.G Owners Manual If Honda MTF is not available, you 
may use an API service SG, SH or SJ
grade motor oil with a viscosity of
SAE 10W-30 or 10W-40 as a
temporary replacement. An SG
grade is pref erred, but an SH or SJ