2001 HONDA ACCORD SEDAN seats

Protecting Children

Small Children
Placing a forward-facing child seat in the front seat of a vehicle equipped
with a passenger's front airbag can

be hazardous. If the vehicle seat is
too far forward, or the child's head is
thrown forward during a collision, an inflating front airbag can strike the
child with enough force to kill orvery seriously injure a small child.

Larger Children Children who have outgrown child
seats are also at risk of being injured
or killed by an inflating passenger's

front airbag. Whenever possible,

larger children should sit in the back seat, properly restrained with a seat
belt. (See page 34 for important information about protecting larger
children.)
U.S. Models

To remind you of the passenger's front airbag hazards, and thatchildren must be properly restrained
in the back seat, your car has
warning labels on the dashboard and on the driver's and front passenger's
visors. Please read and follow the instructions on these labels.

Driver and Passenger Safety

Protecting Children

Canadian Models
To remind you of the front airbag hazards, your car has warning labelson the driver's and front passenger's
visors. Please read and follow the instructions on these labels. If You Must Drive with Several
Children
Your car has three seating positionsin the back seat where children can
be properly restrained.
If you ever have to carry more than
three children in your car:
Place the largest child in the frontseat, provided the child is large
enough to wear a seat belt
properly (see page 34).
Move the vehicle seat as far to the
rear as possible (see page 12).
Have the child sit upright and well
back in the seat (see page 16).
Make sure the seat belt is properly
positioned and secured (see page 14).

Driver and Passenger Safety

CAUTION

TO AVOID SERIOUS INJURY:

FOR MAXIMUM SAFETY PROTECTION IN
ALL TYPES OF CRASHES, YOU MUST
ALWAYS WEAR YOUR SAFETY BELT.
DO NOT INSTALL REARWARD-FACING
CHILD SEATS IN ANY FRONT
PASSENGER SEAT POSITION.
DO NOT SIT OR LEAN UNNECESSARILY

CLOSE TO THE AIR BAG.
DO NOT PLACE ANY OBJECTS OVER THE
AIR BAG OR BETWEEN THE AIR BAG
AND YOURSELF.
SEE THE OWNER'S MANUAL FOR FURTHER INFORMATION AND EXPLANATIONS. PRECAUTION:

POUR EVITER DES BLESSURES GRAVES:

POUR PROFITER D'UNE PROTECTION
MAXIMALE LORS D'UNE COLLISION BOUCLEZ
TOUJOURS VOTRE CEINTURE DE SECURITE. N'lNSTALLEZ JAMAIS UN SIEGE POUR
ENFANTS FAISANT FACE A L'ARRIERE SUR
LE SIEGE DU PASSAGER AVANT.
NE VOUS APPUYEZ PAS ET NE VOUS ASSEYEZ
PAS PRES DU COUSSIN GONFLABLE.NE DEPOSEZ AUCUN OBJET SUR LE COUSSIN
GONFLABLE OU ENTRE LE COUSSIN
GONFLABLE ET VOUS. LISEZ LE GUIDE UTILISATEUR POUR DE
PLUS AMPLES RENSEIGNEMENTS.

Protecting Children

Lock all doors and the trunk when
your car is not in use. Children
who play in cars can accidentally get trapped inside the trunk.
Teach your children not to play in or around cars. Know how to
operate the emergency trunk
opener (see page 81) and decide if your children should be shownhow to use this feature.

Keep car keys and remotetransmitters out of the reach of

children. Even very young
children learn how to unlock
vehicle doors, turn on the ignition, and open the trunk, which can
lead to accidental injury or death. General Guidelines for Using
Child Seats
The following pages give general guidelines for selecting and installing
child seats for infants and smallchildren.

Selecting a Child Seat

To provide proper protection, a child seat should meet three
requirements:

1. The child seat should meet safety
standards. The child seat should
meet Federal Motor Vehicle Safety Standard 213 (FMVSS 213)or Canadian Motor Vehicle Safety
Standard 213 (CMVSS 213). Look
for the manufacturer's statement of compliance on the box and seat.
2. The child seat should be of the

proper type and size to fit the child.

Infants: Children up to about one
year old should be restrained in a rear-facing, reclining child seat. Only
a rear-facing seat provides the
proper support to protect an infant's
head, neck, and back. See page 28 for additional information on
protecting infants.

Driver and Passenger Safety

Protecting Children

Small Children: A child who is too

large for a rear-facing child seat, and
who can sit up without support,
should be restrained in a forward-

facing child seat. See page 31 for
additional information on protecting

small children.
3. The child seat should fit the
vehicle seating position (or
positions) where it will be used.
Due to variations in the design of
child seats, vehicle seats, and seat
belts, all child seats will not fit all

vehicle seating positions.

However, Honda is confident that
one or more child seat models can fit
and be properly installed in all
recommended seating positions in
your car. Before purchasing a child seat, we
recommend that parents test the
child seat in the specific vehicle
seating position (or positions) where
they intend to use the seat. If a previously purchased child seat does
not fit, you may need to buy adifferent one that will fit.
Your car has lower anchorages installed for use with Child Restraint
Anchorage System-compatible child seats. For more information, see
page 38 .
Driver and Passenger Safety

Protecting Children

Placing a Child Seat
This page briefly summarizes Honda's recommendations on where
to place rear-facing and forward-
facing child seats in your car.
Front Passenger's Seat

Infants: Never in the front seat, due to the front airbag hazard.

Small children: Not recommended,
due to the front airbag hazard. If a
small child must ride in front,
move the vehicle seat to the rear-most position and secure a front-
facing child seat with the seat belt. (see page 32).
Back Seats

Infants: Recommended positions.
Properly secure a rear-facing
child seat (see page 28).

Small children: Recommended
positions. Properly secure a front-
facing child seat (see page 32).
Driver and Passenger Safety
CONTINUED

Airbags Pose Serious
Risks to Children
The passenger's front airbag inflates with enough force to killor seriously injure an infant in a
rear-facing child seat.
A small child in a forward-facing child seat is also at risk. If the
vehicle seat is too far forward, or the child's head is thrown
forward during a collision, an
inflating front airbag can kill orseriously injure the child.
If a small child must ride in the
front, follow the instructions
provided in this section.

Protecting Children

Installing a Child Seat

After selecting a proper child seat, and a good position to install the seat,
there are three main steps in
installing the seat:

1. Properly secure the child seat to
the car. All child seats are
designed to be secured to the car
with the lap part of a lap/shoulder belt. Some child seats can be secured to the vehicle's lower
anchorages instead. A child whose seat is not properly secured to the
car can be endangered in a crash.
See pages 29, 32 and 38 for
instructions on how to properly secure child seats in this car. 2. Make sure the child seat is firmly

secured. After installing a child

seat, push and pull the seat
forward and from side to side to
verify that it is secure.
To provide security during normal driving maneuvers as well as during
a collision, we recommend that
parents secure a child seat as firmly as possible.
However, a child seat does not need
to be "rock solid." In some vehicles or seating positions, it may be
difficult to install a child seat so that
it does not move at all. Some side-to- side or back-and-forth movement can
be expected and should not reduce
the child seat's effectiveness. If the child seat is not secure, try
installing it in a different seating
position, or use a different style of
child seat that can be firmly secured
in the desired seating position.
3. Secure the child in the child seat. Make sure the child is properlystrapped in the child seat
according to the child seat maker's
instructions. A child who is not
properly secured in a child seat
can be thrown out of the seat in a
crash and be seriously injured.
Storing a Child Seat When you are not using a child seat, either remove it and store it in a safe
place, or make sure it is properly secured. An unsecured child seat can
be thrown around the car during a
crash or sudden stop and injure
someone.

Driver and Passenger Safety

Protecting Children
Protecting Infants
Child Seat Type
Only a rear-facing child seat provides
proper support for a baby's head, neck, and back. Infants up to aboutone year of age must be restrained in
a rear-facing child seat.
Two types of seats may be used: a seat designed exclusively for infants,
or a convertible seat used in the rear-
facing, reclining mode. We recommend that an infant be
restrained in a rear-facing child seat
until the infant reaches the seat
maker's weight or height limit and isable to sit up without support.
Rear-Facing Child Seat Placement

In this car, a rear-facing child seat
can be placed in any seating position
in the back seat, but not in the front
seat.

Never put a rear-facing child seat in
the front seat. If the passenger's
front airbag inflates, it can hit the
back of the child seat with enough
force to kill or seriously injure an infant. If an infant must be closely
watched, we recommend that another adult sit in the back seat
with the baby.

Do not put a rear-facing child seat in
a forward-facing position. If placed

facing forward, an infant could be
very seriously injured during a frontal collision.

Driver and Passenger Safety
Placing a rear-facing child seat
in the front seat can result in
serious injury or death if the passenger's front airbag inflates.
Always place a rear-facing child
seat in the back seat, not the

front.

Protecting Children

When properly installed, a rear- facing child seat may prevent thedriver or a front-seat passenger from
moving the seat as far back as
recommended (see page 12). Or it
may prevent them from locking the seat-back in the desired upright
position (see page 13).
In either case, we recommend that
you place the child seat directly behind the front passenger seat,
move the front seat as far forward as
needed, and leave it unoccupied. Or
you may wish to get a smaller child seat that allows you to safely carry a
front passenger.
Rear-Facing Child Seat Installation

The lap/shoulder belts in the back seats have a locking mechanism that
must be activated to secure a child

seat.

The following pages provide instructions and tips on how tosecure a rear-facing child seat with
this type of seat belt.
If you have a child seat designed to
attach to the vehicle's lower
anchorages, follow the instructions
on page 38. 1. With the child seat in the desired
back seating position, route the
belt through the child seat according to the seat maker's
instructions, then insert the latch
plate into the buckle.

CONTINUED

Driver and Passenger Safety