2001 HONDA ACCORD COUPE radiator

Cooling System

6-cylinder models

3. Loosen the drain plug on the
bottom of the radiator. The
coolant will drain through the
splash guard. Loosen the drain
bolt. 4. Remove the reserve tank from its
holder by pulling it straight up.Drain the coolant, then put the
tank back in its holder. 6-cylinder models
When removing the reserve tank, first remove the cruise control cableand the ground cable from their clips.
After installing the tank back in place, put the cables back in their

clips.

CONTINUED

Maintenance
DRAIN PLUG
RESERVE TANKRESERVE TANK CAP

HOLDER

DRAIN BOLT
4-cylinder models
6-cylinder models
6-cylinder models

Cooling System

5. When the coolant stops draining, tighten the drain plug at the
bottom of the radiator.

6. 4-cylinder models
Put a new washer on the drain bolt,
then reinstall the drain bolt in the
engine block. Tighten it securely.
Tightening torque:
61 Ibf.ft (83 N.m , 8.5 kgf.m)
6-cylinder models

Tighten the drain bolt at the rear of the engine cylinder block
securely.

Tightening torque:
7 Ibf.ft (10 N.m, 1.0 kgf.m)
7. 4-cylinder models

Loosen the bleeder bolt on top of
the engine.
Pour Honda All Season
Antifreeze/Coolant Type 2 into the radiator. This coolant is a
mixture of 50 percent anti-freezeand 50 percent water. Pre-mixing
is not required.
Tighten the bleeder bolt when coolant comes out in a steadystream with no bubbles.

Maintenance

RESERVE TANK
RESERVE TANK CAP
HOLDER

6-cylinder models 4-cylinder models

Fill up to here
FILLER NECK
FILLER NECK
Fill up to here

6-cylinder models

Cooling System

6-cylinder models

Pour coolant into the radiator up

to the base of the filler neck.

The cooling system capacity is:
With 5-speed manual transmission:
1.45 US gal (5.5 ,1.21 Imp gal)

With automatic transmission:
1.43 US gal (5.4 ,1.19 Imp gal)
6-cylinder models 1.48 US gal (5.6 ,1.23 Imp gal) 8. Start the engine and let it run for
about 30 seconds. Then turn off
the engine.
9. Fill the radiator with coolant up to the base of the filler neck.
10. Fill the reserve tank to the MAX mark. Install the reserve tank cap.
11.Install the radiator cap, and tighten it to the first stop.
12.Start the engine and let it run until the radiator cooling fan comes onat least twice. Then stop the

engine.

13.Remove the radiator cap. Pour coolant into the radiator up to the
base of the filler neck and into the
reserve tank up to the MAX mark. 14.Start the engine and hold it at
1,500 rpm until the cooling fan
comes on. Turn off the engine. Check the coolant level in the
radiator and add coolant if needed.
15.Install the radiator cap, and tighten it fully.
16.If necessary, fill the reserve tank to the MAX mark. Install thereserve tank cap.

Maintenance

4-cylinder models

BLEEDER BOLT

Air Conditioning System
Optional for U.S. DX model

Your car's air conditioning is a sealed system. Any major maintenance,
such as recharging, should be done
by a qualified mechanic. You can do a couple of things to make sure the
air conditioning works efficiently.
Periodically check the engine's
radiator and air conditioning condenser for leaves, insects, and
dirt stuck to the front surface. These
block the air flow and reduce cooling efficiency. Use a light spray from a
hose or a soft brush to remove them.

The condenser and radiator fins bend

easily. Only use a low-pressure spray

or soft-bristle brush to clean them.
AIR CONDITIONING CONDENSER

Run the air conditioning at least once
a week during the cold weather
months. Run it for at least ten
minutes while you are driving at a steady speed with the engine at
normal operating temperature. This
circulates the lubricating oil con-
tained in the refrigerant.
If the air conditioning does not get as

cold as before, have your dealer

check the system. Recharge the

system with Refrigerant HFC-134a

(R-134a). (See Specifications on page 328.)

Whenever you have the air conditioning

system serviced, make sure the service

facility uses a refrigerant recycling
system. This system captures the
refrigerant for reuse. Releasing
refrigerant into the atmosphere can

damage the environment.

Maintenance

NOTICE
NOTICE

Lights

Headlight Aiming

The headlights were properly aimed when your car was new. If youregularly carry heavy items in the
trunk, readjustment may be required.
Adjustment of the headlights should be performed by a Honda technicianor other qualified mechanic.
Replacing a Headlight Bulb
Your car has two bulbs on each side, four in total. Make sure you arereplacing the bulb that is burned out.
Your car uses halogen headlight bulbs. When replacing a bulb, handleit by its plastic case and protect the
glass from contact with your skin or
hard objects. If you touch the glass,clean it with denatured alcohol and a
clean cloth.
BULB

1. Open the hood. If you need to change a bulb on
the passenger's side (on the driver's side on 6-cylinder models),
remove the radiator reserve tank.
2. Remove the electrical connector from the bulb by squeezing theconnector to unlock the tab, thenslide the connector off the bulb. 3. Remove the bulb by turning it
approximately one-quarter turn
counterclockwise.
4. Insert the new bulb into the hole and turn it one-quarter turn clock-
wise to lock it in place.
5. Push the electrical connector back onto the bulb. Make sure it is on
all the way.
6. Turn on the headlights to test the new bulb.
7. (Passenger's side on 4-cylinder models, driver's side on 6-cylindermodels)
Reinstall the radiator reserve tank.

Halogen headlight bulbs get very hot when lit. Oil, perspiration, or a scratch
on the glass can cause the bulb to
overheat and shatter.

Maintenance
NOTICE

TAB

If Your Engine Overheats
4. If the temperature gauge stays at the red mark, turn off the engine.
5. Wait until you see no more signs of steam or spray, then open the

hood.

6. Look for any obvious coolant leaks, such as a split radiator hose.
Everything is still extremely hot,so use caution. If you find a leak, it
must be repaired before you
continue driving (see Emergency
Towing on page 320).
7. If you don't find an obvious leak, check the coolant level in the
radiator reserve tank (see page 184). If the level is below the
MIN mark, add coolant to halfway
between the MIN and MAX marks.
8. If there was no coolant in the reserve tank, you may also have to
add coolant to the radiator. Let the
engine cool down until the pointer reaches the middle of the tempera-
ture gauge, or lower, before check- ing the radiator.
9. Using gloves or a large heavy cloth, turn the radiator cap
counterclockwise, without pushing
down, to the first stop. This
releases any remaining pressure in
the cooling system. After the
pressure releases, push down on
the cap and turn it until it comes
off. 10. Start the engine and set the
temperature control dial tomaximum (climate control to
FULL AUTO at 90°F/32°C). Add
coolant to the radiator up to the
base of the filler neck. If you do
not have the proper coolant mixture available, you can add
plain water. Remember to have
the cooling system drained and refilled with the proper mixture as
soon as you can.

11. Put the radiator cap back on tightly. Run the engine and watch
the temperature gauge. If it goes
back to the red mark, the engine
needs repair. (See Emergency
Towing on page 320.)
12. If the temperature stays normal, check the coolant level in the
radiator reserve tank. If it has
gone down, add coolant to the MAX mark. Put the cap back on

tightly.

Taking Care of the Unexpected
Removing the radiator cap

while the engine is hot can

cause the coolant to spray out, seriously scalding you.

Always let the engine and radiator cool down before

removing the radiator cap.

Index

Parking Brake................................ 101
Parking Lights.................................. 63
Parking Over Things that Burn... 335
PGM-FI System.............................. 334
Polishing and Waxing................... 289
Pre-Drive Safety Checklist............. 11
Pregnancy, Using Seat Belts.......... 17
Protecting Adults............................. 12 Additional Safety Precautions.... 18
Advice for Pregnant Women...... 17
Protecting Children......................... 19
Protecting Infants........................ 28
Protecting Larger Children........ 34
Protecting Small Children.......... 31Using Child Seats with
Tethers......................................37

Radiator Overheating.................... 309
Radio/Cassette Sound System.... 125
Rear Lights, Bulb Replacement... 281
Rear Seat Armrest........................... 94
Rear Seat, Folding........................... 93
Rear View Mirror............................. 99 Rear Window Defogger.................. 66 Reclining the Seat Backs......... 88, 91
Recommended Shift Speeds ........
196
Reminder Lights.............................. 53
Remote Transmitter........................ 75
Replacement Information
Air Cleaner Element.................. 253Coolant........................................ 241
Engine Oil and Filter................. 235

Fuses...........................................318
Light Bulbs................................. 278
Schedule..................................... 224

Spark Plugs ....................... 256, 258

Tires............................................ 271 Wiper Blades.............................. 263
Replacing Seat Belts After a
Crash.............................................42

Reserve Tank, Coolant.................. 184
Restraint, Child................................

19

Reverse Gear Position................... 198

Rotation, Tire................................. 271

Safety Belts......................................... 8

Safety Defects, Reporting* .......... 344
Safety Features.................................. 7
Airbags............................................ 9Door Locks................................... 10
Head Restraints........................... 10

Seat Belts........................................ 8
Seats & Seat-Backs...................... 10

Safety Labels, Location of.............. 50

Safety Messages................................ ii

Seat Belts............................................ 8
Additional Information................ 40
Automatic Seat Belt Tensioners................................ 41
Cleaning...................................... 292
Lap/Shoulder Belt....................... 40

Maintenance................................. 42

Reminder Light and
Beeper................................. 40, 54

System Components.................... 40 Use During Pregnancy................ 17

Seats, Adjusting the......................... 88

Security System............................. 175
Serial Number................................ 324
Service Intervals............................ 224
Service Manual*............................ 345
Service Station Procedures .......... 178