2001 HONDA ACCORD COUPE dead battery

State Emissions Testing

Testing of Readiness Codes
If you take your vehicle for a state
emissions test shortly after the
battery has been disconnected or
gone dead, it may not pass the test.
This is because of certain "readiness codes" that must be set in the on-
board diagnostics for the emissionssystems. These codes are erased
when the battery is disconnected, and set again only after several days
of driving under a variety of
conditions. If the testing facility determines that
the readiness codes are not set, you
will be requested to return at a later date to complete the test. If you must
get the vehicle re-tested within the next two or three days, you can
condition the vehicle for re-testing
by doing the following.
Make sure the gas tank is nearly,
but not completely, full (around 3/4).
Make sure the vehicle has been
parked with the engine off for 8
hours or more.
Make sure the ambient
temperature is between 20° and
95°
F.
Without touching the accelerator
pedal, start the engine and let it
idle for 20 seconds.
Keep the vehicle in Park (automatic transmission) or
Neutral (manual transmission). Increase the engine speed to 2,000
rpm and hold it there until the
temperature gauge rises to at least 1/4 of the scale (approximately 3

minutes).

Technical Information

Index

Setting the Clock........................... 101 The 5-speed Manual Transmission.......................... 195
Shift Lever Position Indicator...... 197
Shift Lock Release......................... 200
Side Airbags..................................... 45
How Your Side Airbags Work.... 45
How The Side Airbag IndicatorLight Works............................. 46
Side Marker Lights, Bulb Replacement............................... 279

Signaling Turns................................ 64

Snow Tires...................................... 273

Solvent-type Cleaners.................... 288
Sound System........................ 125, 153
Spare Tire
Inflating....................................... 297

Specifications............................. 330
Spark Plugs, Replacing........ 256, 258
Specifications Charts..................... 328
Speed Control...................................
68

Speed Limiter........................ 196, 200
Speedometer....................................

58

SRS, Additional Information........... 43
Additional Safety Precautions.... 23How Your Airbags Work..... 43, 45
How Your SRS Indicator
Works........................................43

SRS Components......................... 43
SRS Service................................... 48

SRS Indicator............................. 43, 55

START (Ignition Key Position) ..... 74
Starting the Engine........................

193

In Cold Weather at High
Altitude...................................

194

With a Dead Battery................. 306
Steam Coming from Engine......... 308
Steering Wheel Adjustment................................... 67
Anti-theft Column Lock.............. 73
Stereo Sound System........... 125,
153
Storing Your Car.............................
287


Sun Visor......................................... 105

Sunglasses Holder......................... 106
Supplemental Restraint System Servicing....................................... 48

SRS Indicator......................... 43, 55
System Components.................... 43
Synthetic Oil................................... 235 Tachometer...................................... 58
Taillights, Changing Bulbs in....... 281
Taking Care of the Unexpected .. 295
Tape Player ........................... 130, 160
Technical Descriptions DOT Tire Quality Grading....... 329
Emissions Control Systems...... 332
Oxygenated Fuels...................... 331
Three Way Catalytic Converter................................ 335
Temperature Gauge........................ 59
Tether Attachment Points.............. 37
Three Way Catalytic Converter... 335 Time, Setting the...........................

101

Timing Belt..................................... 267
Tire Chains..................................... 273
Tire, How to Change a Flat.......... 297

CONTINUED

Audio System

You can use any of four methods to
find radio stations on the selected
band: TUNE, SEEK, SCAN or the
Preset buttons.
TUNE — Use the TUNE knob to
tune the radio to a desired frequency.
Turn the knob clockwise to tune to a
higher frequency, or
counterclockwise to tune to a lower
frequency.
SEEK — The SEEK function
searches the band for a station with
a strong signal. To activate it, press
either SEEK button or then
release it. Depending on which
SEEK button you press, the system
scans upward or downward from the
current frequency. It stops when it
finds a station with a strong signal.
SCAN — The SCAN function
samples all the stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it. The system will scan
up the band for a station with a
strong signal. When it finds one, it
will stop and play that station for
approximately five seconds. If you do
nothing, the system will then scan
for the next strong station and play
that for five seconds. When it plays a
station that you want to continue
listening to, press the SCAN button

again.

Preset — You can store the
frequencies of your favorite radio
stations in the six preset buttons.
Each button will store one frequency

on the AM band, and two

frequencies on the FM band.
To store a frequency:
1. Select the desired band, AM or
FM. FM1 and FM2 let you store
two frequencies with each Preset
button.
2. Use the TUNE or SEEK function
to tune the radio to a desired

station.

3. Pick the Preset button you want
for that station. Press the button
and hold it until you hear a beep.
4. Repeat steps 1 to 3 to store a total
of six stations on AM and twelve
on FM.
Once a station's frequency is stored,
simply press and release the proper
preset button to tune to it.
The preset frequencies will be lost if
your vehicle's battery goes dead, is
disconnected, or the radio fuse is

removed.

CONTINUED

Comfort and Convenience Features

C