Page 150 of 240
IDENTIFYING COMPONENTS IN THE ENGINE
COMPARTMENT
3.8L OHV V6 engine
1. Engine oil filler cap
2. Engine oil dipstick
3. Brake fluid reservoir
4. Power distribution box
5. Windshield washer fluid reservoir
6. Battery
7. Power steering fluid reservoir
8. Engine coolant reservoir
9. Air filter assembly
10. Automatic transmission fluid dipstick (if
equipped)
6
1023
4
5
789
1
Maintenance and care
150
Page 151 of 240
4.6L SOHC V8 engine
1. Engine oil dipstick
2. Brake fluid reservoir
3. Power distribution box
4. Windshield washer fluid reservoir
5. Battery
6. Engine coolant reservoir
7. Power steering fluid reservoir
8. Engine oil filler cap
9. Air filter assembly
10. Automatic transmission fluid dipstick (if
equipped)
ENGINE OIL
Checking the engine oil
Refer to the scheduled maintenance guide for the
appropriate intervals for checking the engine oil.
1. Make sure the vehicle is on level ground.
2. Turn the engine off and wait 5 to 10 minutes for
the oil to drain into the oil pan.
56798
23
4
110
Maintenance and care
151
Page 152 of 240
3. Set the parking brake and ensure the gearshift is
securely latched in P (Park) (automatic
transmissions) or 1 (First) (manual transmissions).
4. Open the hood. Protect yourself from engine heat.
5. Locate and carefully remove the engine oil level
indicator (dipstick).
²3.8L V6 engine
²4.6L SOHC V8
engine
6. Wipe the indicator clean. Insert the indicator fully,
then remove it again.
²If the oil level isbetween the MINÐMAX
marks,the oil level is acceptable.DO NOT ADD
OIL.
²If the oil level is below the MIN mark, add enough
oil to raise the level within the MINÐMAX range.
MAX MIN
Maintenance and care
152
Page 153 of 240
²3.8L V6 engine
²4.6L SOHC V8
engine
²Oil levels above the MAX mark may cause engine
damage. Some oil must be removed from the
engine by a service technician.
7. Put the indicator back in and ensure it is fully
seated.
Adding engine oil
1. Check the engine oil. For instructions, refer to
Checking the engine oilin this chapter.
2. If the engine oil level is not within the normal
range, add only certified engine oil of the
recommended viscosity. Remove the engine oil filler
cap and use a funnel to pour the engine oil into the
opening.
3. Recheck the engine oil level. Make sure the oil
level is not above the MAX mark on the engine oil
level indicator (dipstick).
4. Install the indicator and ensure it is fully seated.
Maintenance and care
153
Page 209 of 240

Item Ford part name Ford part
numberFord
specification
Automatic
transmission fluidMotorcraft
MERCONtVATF
2
XT-5-QM MERCONtV
3.8L Manual
transmission fluidMotorcraft
MERCONtAT FXT-2-QDX MERCONt
4.6L Manual
transmission fluidMobil 1
SynthetictAT FN/A N/A
Disc brake caliper
railsSilicone Brake
Caliper Grease
and Dielectric
CompoundD7AZ-19A331-A
(Motorcraft
WA-10)ESE-M1C171-A
Windshield
washer fluidUltra-clear
Windshield
Washer
ConcentrateC9AZ-19550-AC ESR-M17P5-A
1Add 118 ml (4 oz.) of Additive Friction Modifier
C8AZ-19B546-A or equivalent meeting Ford specification
EST-M2C118-A for complete refill of Traction-Lok axles.
Ford design rear axles contain a synthetic lubricant that
does not require changing unless the axle has been
submerged in water.
2Ensure the correct automatic transmission fluid is used.
Transmission fluid requirements are indicated on the
dipstick or on the dipstick handle. MERCONtand
MERCONtV are not interchangeable. DO NOT mix
MERCONtand MERCONtV. Refer to your scheduled
maintenance guide to determine the correct service
interval.
ENGINE DATA
Engine 3.8L OHV V6 engine 4.6L SOHC V8 engine
Cubic inches 232 281
Required fuel 87 octane 87 octane
Firing order 1-4-2-5-3-6 1-3-7-2-6-5-4-8
Spark plug gap 1.3-1.4 mm
(0.052-00.056 inch)1.3-1.4 mm
(0.052-00.056 inch)
Ignition system EDIS Coil on plug
Compression ratio 9.4:1 9.4:1
Capacities and specifications
209
Page 230 of 240

The Dispute
Settlement
Board ..................... 216
Utilizing the
Mediation/Arbitration
Program ................. 219
D
Daytime running lamps
(see Lamps) .............. 18
Defrost
rear window ............ 19
Dipstick
automatic transmission
fluid ........................ 167
engine oil ............... 151
Doors
lubricant
specifications ........ 208
Driving under special
conditions
through water ....... 128
E
Emergencies, roadside
jump-starting ........ 141
Emission control
system ...................... 190
Engine .............. 209±210
check engine/service
engine soon light ...... 9
cleaning ................. 202
coolant ................... 157
idle speed
control ................... 171
lubrication
specifications. 208±209refill capacities ...... 206
service
points ............. 150±151
starting after a
collision ................. 130
Engine block
heater ....................... 106
Engine oil ................ 151
checking and
adding .................... 151
dipstick .................. 151
filter,
specifications. 154, 206
recommendations.. 154
refill capacities ...... 206
specifications. 208±209
Exhaust fumes ........ 107
F
Floor mats ................. 60
Fluid capacities ....... 206
Foglamps ................... 19
Fuel .......................... 180
calculating fuel
economy ................ 186
cap ................... 11, 182
capacity ................. 206
choosing the
right fuel ................ 183
comparisons with EPA
fuel economy
estimates ............... 190
detergent in fuel ... 185
filling your vehicle
with
fuel ......... 180, 182, 186
filter,
specifications. 185, 206
Index
230
Page 239 of 240

Item Information
Required fuel Unleaded fuel only - 87
octane
Fuel tank capacity 59.4L (15.7 gallons)
Engine oil capacity (includes
filter change)4.7L (5.0 quarts). Use
Motorcraft SAE 5W-20 Super
Premium Motor Oil, Ford
specification WSS-M2C153-H
Tire size and pressure See label on inside of glove
box door.
Hood release Pull handle under the left
side of the instrument panel.
Coolant capacity-3.8L OHV
V6 engine
111.2L (11.8 quarts)
Coolant capacity-4.6L SOHC
V8 engine
113.3L (14.1 quarts)
Power steering fluid capacity Fill to line on reservoir or
dipstick. Use Motorcraft
MERCONtAT F.
Manual transmission fluid
capacity-3.8L OHV V6 engine
2
2.6L (5.6 pints). Use
Motorcraft MERCONtAT F.3
Manual transmission fluid
capacity-4.6L SOHC V8
engine
2
3.8L (8.0 pints). Use Mobil 1
SynthetictAT F.3
Automatic transmission fluid
capacity-3.8L OHV V6 engine
2
13.1L (13.9 quarts). Use
Motorcraft MERCONtV ATF.
4
Automatic transmission fluid
capacity-4.6L SOHC V8
engine
2
12.0L (12.8 quarts). Use
Motorcraft MERCONtV ATF.
4
Windshield washer fluid 3.8L (4.0 quarts). Use
Ultra-Clear Windshield
Washer Concentrate.
1Use either green-colored Motorcraft Premium Engine
Coolant or yellow-colored Motorcraft Premium Gold
Engine Coolant. DO NOT USE Ford Extended Life Engine
Coolant (orange in color). Refer toAdding engine
coolant, in the Maintenance and Care chapter.
2Ensure the correct automatic transmission fluid is used.
Transmission fluid requirements are indicated on the
dipstick or on the dipstick handle. MERCONtand
Filling station information
239