2001 CHEVROLET TRACKER ECU

2-9
To Open a Rear Door With the Security Lock
If you want to open a rear door when the security lock is
on, unlock the door from the inside, then open the door
from the outside.
If you don't cancel the security lock feature, adults or
older children who ride in the rear won't be able to open
the rear door from the inside. You should let adults and
older children know how these security locks work, and
how to cancel the locks.
To Cancel the Rear Door Lock
1. Unlock the door from the inside and open the door
from the outside.
2. Move the lever up to disengage the lock.
3. Do the same for the other rear door.
The rear door locks will now work normally.
Leaving Your Vehicle
If you are leaving the vehicle, take your key, open your
door and set the locks from inside. Then get out and
close the door.
Remote Keyless Entry System
(If Equipped)
If your vehicle has this feature, you can lock and unlock
your doors from about 3 feet (1 m) up to 30 feet (9 m)
away using the remote keyless entry transmitter supplied
with your vehicle.
Your remote keyless entry system operates on a
radio frequency subject to Federal Communications
Commission (FCC) Rules and with Industry Canada.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
This device complies with RSS
-210 of Industry Canada.
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation of the device.
Changes or modifications to this system by other than
an authorized service facility could void authorization to
use this equipment.

2-12
To replace the battery in the transmitter do
the following:
1. Use a coin or flat
-tip screwdriver to separate the
bottom half from the top half of the transmitter.
2. Remove the battery and replace it with the new one.
Make sure the positive (+) side of the battery faces
down. For battery replacement, use a 3
-volt battery,
type CR2032 or equivalent.
3. Read the instructions inside the case.
4. Put the two halves back together. Make sure the
cover is on tight so water won't get in.
5. Check the operation of the transmitter with your
vehicle. If the transmitter does not work, try
resynchronizing the transmitter with the receiver.
Resynchronization
Your remote keyless entry system is equipped with a
security system that prevents anyone from recording and
playing back your signal. The transmitter does not send
the same signal twice to the receiver. The receiver will
not respond to a signal that has been sent to it more
than once.
To resynchronize your transmitter and receiver, follow
these directions:
1. Stand close to your vehicle.
2. Press and hold the LOCK and UNLOCK buttons
on the transmitter at the same time.
3. Hold the buttons for at least seven seconds. During
this time, the doors should lock and unlock once.
This confirms the resynchronization. If the doors
do not lock and unlock, see your dealer for service.

2-47 Lockable Storage Compartment and Cargo
Cover (Option)
If you have a two-door vehicle and it has the optional
lockable storage compartment, you can use it to cover
and secure items in the cargo area of your vehicle.
The closeout panel can be removed to allow for
extra cargo space.
To remove the close
-out panel, do the following:
1. Remove the two
attaching bolts from
each lower corner
of the cargo area.2. Release the tension bows on both sides of the
convertible top. See ªConvertible Topº later in
this section for more information.
3. Loosen the lower rear corners of the convertible top.

2-48
4. Remove the rear window. See ªRemoving and
Installing Your Rear Windowº later in this section.
5. Carefully lift the panel out of the cargo area.
6. Put the bolts back into the mounting holes for
storage while the panel is out of the vehicle.
CAUTION:
An improperly stored cargo cover could be
thrown about the vehicle during a collision or
sudden maneuver. You or others could be
injured. If you remove the cover, always store
it outside of the vehicle. When you put it back,
always be sure that it is securely reattached.
Luggage Carrier (Option)
CAUTION:
If you try to carry something on top of your
vehicle that is longer or wider than the luggage
carrier
-- like paneling, plywood, a mattress, and
so forth
-- the wind can catch it as you drive
along. This can cause you to lose control. What
you are carrying could be violently torn off, and
this could cause you or other drivers to have a
collision, and of course damage your vehicle. You
may be able to carry something like this inside.
But, never carry something longer or wider than
the luggage carrier on top of your vehicle.

2-49
The luggage carrier has side rails and crossrails attached
to the roof to secure cargo. To install the crossrails,
follow these steps:
1. Turn the screw cover
lock to the unlocked
position and lower
the cover.
2. Turn the screw counterclockwise to loosen the
mounting attachment so it can fit over the side rails.

2-50
3. Mount the crossrails onto the side rails and adjust
their position so the cargo can be mounted properly.
Make sure the crossrails are not slanted.4. Tighten the screws securely, taking care not
to overtighten them. Then raise and lock the
screw covers.

2-51
Be sure the cargo is properly loaded. Follow
these guidelines:

Carrying small, heavy loads on the roof is
not recommended.

Do not load cargo directly on the roof panel.

If you need to carry long items, move the crossrails
as far apart as possible. Tie the load to the tie downs
provided. Also tie the load to the bumpers. Do not
tie the load so tightly that the crossrails or side rails
are damaged.
NOTICE:
Loading cargo that weighs more than 100 lbs.
(45 kg) on the luggage carrier may damage
your vehicle. When you carry large things,
never let them hang over the rear or the sides
of your vehicle.
Put the cargo against the side rails and fasten
it securely to the luggage carrier. Put the main
weight as far forward as possible to keep the
load from shifting.
Don't exceed the maximum vehicle capacity when
loading your vehicle. For more information on vehicle
capacity and loading, see ªLoading Your Vehicleº
in the Index.
To prevent damage or loss of cargo as you're driving,
check now and then to make sure the luggage carrier
and cargo are still securely fastened.
To reduce unnecessary windnoise generated by air flow
over the crossrails, remove them from the vehicle when
not in use. The original shipping carton may be retained
for storage of the roof rack cross rails.
To remove your crossrails, do the following:
1. Insert the crossrail cover key and turn the screw
cover lock to the unlocked position and lower the
cover (all four covers).
2. Turn the screw counterclockwise to loosen the
mounting attachment so that it can fit over the
side rails (all four mounting attachments).
3. Remove the crossrails and store them in the box.

2-56
6. Wrap the holding strap around the canvas top
and snap it to the front top bow retaining strap.
7. Push the front top bow latches down until
they ªclick.º
8. Swing your sun visors up and raise your antenna.
Reverse the steps to close your sunroof. Be sure your
front top bow is latched securely.
Removing and Installing Your
Rear Window
The rear window on your vehicle is removable.
This allows you to open the back opening all the way
or to replace the window if it becomes deteriorated.
To remove the rear window do the following:
1. Open the rear gate all the way.
2. Unfasten the canvas flaps at the lower corners of the
rear window to uncover the zipper pull.
3. Unzip the rear window.