2001 Acura RL maintenance schedule

Engine Oil
The numbers on the container's label tell you the oil's viscosity or weight.Select the oil for your car according
to this chart.

An oil with a viscosity of 5W-30 is
preferred for optimum fuel economy

and year-round protection in your

Acura. You may use a 10W-30 oil if
the temperature in your area never

goes below 20°F(—7°C).
Synthetic Oil
You may use a synthetic motor oil if it meets the same requirements
given for conventional motor oil: it displays the API Certification Seal,
and it is the proper weight as shown
on the chart. When using synthetic
oil, you must follow the oil and filter
change intervals given in the
maintenance schedule. Additives
Your Acura does not need any oiladditives. Purchasing additives for
the engine or transmission will not increase your car's performance or
longevity. It only increases the cost of operating your car.
Maintenance
Ambient Temperature

Engine Oil

Changing the Oil and Filter
Always change the oil and filter according to the time and distance (miles/kilometers) recommenda-
tions in the maintenance schedule.
The oil and filter collect contami- nants that can damage your engine if
they are not removed regularly.
Changing the oil and filter requires
special tools and access from
underneath the car. The car should
be raised on a service station-type
hydraulic lift for this service. Unless
you have the knowledge and proper equipment, you should have this
maintenance done by a skilled

mechanic.
1. Run the engine until it reaches
normal operating temperature,
then shut it off.

2. Open the hood and remove the

engine oil fill cap. Remove the oil
drain bolt and washer from the
bottom of the engine. Drain the oil
into an appropriate container.

3. Remove the oil filter and let the

remaining oil drain. A special
wrench (available from your Acura
dealer) is required to remove the
filter.

CONTINUED

Maintenance

OIL DRAIN BOLT

WASHER
OIL FILTER

Cooling System
Replacing Engine Coolant
The cooling system should be completely drained and refilled with
new coolant according to the time
and distance recommendations in
the maintenance schedule. Only use Honda All Season Antifreeze/Coolant Type 2. Use of any non-
Honda coolant or plain water can
result in corrosion and deposits in
the cooling system.
Draining the coolant requires access
to the underside of the car. Unless
you have the tools and knowledge,
you should have this maintenance done by a skilled mechanic.
1. Turn the ignition ON (II). Turn
the heater temperature control
dial to maximum heat (climate
control to 90°F/32°C). Turn off
the ignition. Open the hood. Make
sure the engine and radiator are
cool to the touch.

2. Remove the radiator cap.
3. Loosen the drain plug on the
bottom of the radiator. The
coolant will come out through the
hole in the splash cover.

CONTINUED

Maintenance
DRAIN PLUG

Automatic Transmission Fluid, Differential Oil
6. Insert the dipstick back in thetransmission. Make sure the notch
fits in the dipstick guide and the dipstick is down all the way.
The transmission should be drained
and refilled with new fluid according
to the time and distance recommen- dations in the maintenance schedule.
Differential Oil

Check the oil in the differential with
the car sitting level. Remove the oil
filler plug and check that the oil level is up to the edge of the hole.
If it is not, slowly add oil until it
starts to run out of the hole. Reinstall
the filler plug and tighten it securely. Use a SAE 90 or SAE 80W-90
viscosity hypoid gear oil, API service classified GL4 or GL5 only, in the

differential.

Viscosity

SAE 90: above0°F(— 18°C)
SAE 80W-90: below 0°F ( — 8°C)
The differential oil should be drained
and refilled with new oil according to
the time and distance recommenda-
tions in the maintenance schedule.

CONTINUED

Maintenance

DRAIN PLUG

FILLER PLUG

Correct
level

Brake Fluid, Power Steering

Brake Fluid

Check the fluid level in the brake
fluid reservoir monthly.
The brake fluid should be replaced according to the time recommenda-
tion in the maintenance schedule.
Always use Honda Heavy Duty Brake Fluid DOT 3. If it is not
available, you should use only DOT 3
or DOT 4 fluid, from a sealed
container, as a temporary
replacement. However, the use of any non-Honda brake fluid can cause
corrosion and decrease the life of the
system. Have the brake system
flushed and refilled with Honda Heavy Duty Brake Fluid DOT 3 assoon as possible.
Brake fluid marked DOT 5 is not
compatible with your car's braking system and can cause extensive

damage.
Brake System
The fluid level should be between the MIN and MAX marks on the side
of the reservoir. If the level is at or
below the MIN mark, your brake system needs attention. Have the
brake system inspected for leaks or
worn brake pads. Power Steering
You should check the fluid level in the power steering reservoir at leastonce a year. Check the level when
the engine is cold. Look at the side of the reservoir. The fluid should be
between the UPPER LEVEL and LOWER LEVEL. If it is below the
LOWER LEVEL, add power steering
fluid to the UPPER LEVEL.

Maintenance
MAX
MIN
UPPER

LEVEL
LOWER

LEVEL

Power Steering, Hood Latch, Air Cleaner Element
Always use Honda Power Steering Fluid. If it is not available, you may
use another power steering fluid as
an emergency replacement.
However, continued use can cause
increased wear and poor steering in
cold weather. Have the power
steering system flushed and refilled
with Honda PSF as soon as possible.
A low power steering fluid level can indicate a leak in the system. Check
the fluid level frequently and have
the system inspected as soon as
possible.

Turning the steering wheel to full left
or right lock and holding it there can
damage the power steering pump.
Hood Latch

Clean the hood latch assembly with a
mild cleaner, then lubricate it with a
multipurpose grease. Lubricate all
the moving parts (as shown),
including the pivot. Follow the time
and distance recommendations in
the Maintenance Schedule. If you are not sure how to clean and grease
the latch, contact your Acura dealer.
Air Cleaner Element

The air cleaner element should be cleaned or replaced according to the
time and distance recommendations
in the maintenance schedule.
Cleaning (Severe Conditions)

Clean the air cleaner element by blowing compressed air through it in
the opposite direction to normal air
flow. If you do not have access tocompressed air (such as a servicestation), ask your Acura dealer to do
this service.
Follow the replacement procedure
for removal and reinstallation.

CONTINUED

Maintenance

NOTICE

PIVOTS
LATCH
ASSEMBLY

Spark Plugs
The spark plugs in your car are a special platinum-tipped design for
longer life. The spark plugs should
be replaced according to the time and distance recommendations in
the maintenance schedule. Replacement
1. Remove the two bolts and thethree nuts with a 7/16 inch (10
mm) wrench, then remove theengine cover.
2. Remove the two bolts and the four
nuts with a wrench and remove
the tower bar. Then remove the
A/C tube from the three clips.
3. Clean up any dirt and oil that have
collected around the ignition coils.

CONTINUED

Maintenance

BOLTS

NUTS

NUTS
BOLTS

NUTS

Timing Belt, Tires

Timing Belt
The timing belt and balancer belt should normally be replaced at the
intervals shown in the maintenance
schedule.

Replace these belts at 60,000 miles (U.S.) or 100,000 km (Canada) if you
regularly drive your car in one or
more of these conditions:
In very high temperatures
(over 110°F, 43°C).
In very low temperatures

(under — 20°F, — 29°C).

Tires
To safely operate your car, your tiresmust be the proper type and size, in
good condition with adequate tread, and correctly inflated. The following
pages give more detailed information on how and when to check air
pressure, how to inspect your tires
for damage and wear, and what to do
when your tires need to be replaced.
Inflation

Keeping the tires properly inflated
provides the best combination of
handling, tread life and riding comfort. Underinflated tires wear
unevenly, adversely affect handling
and fuel economy, and are more
likely to fail from being overheated. Overinflated tires can make your car
ride more harshly, are more prone to damage from road hazards, and wear

unevenly.

We recommend that you visually check your tires every day. If you
think a tire might be low, check it immediately with a tire gauge.

CONTINUED

Maintenance

Using tires that are excessively
worn or improperly inflated can
cause a crash in which you canbe seriously hurt or killed.
Follow all instructions in this

owner's manual regarding tire
inflation and maintenance.