EAU01114
PRE-OPERATION CHECKS
1
2
3
4
5
6
7
8
9
4-1
The condition of a vehicle is the ownerís responsibility. Vital components can start to deteriorate quickly and unexpect-
edly, even if the vehicle remains unused (for example, as a result of exposure to the elements). Any damage, fluid leak-
age or loss of tire air pressure could have serious consequences. Therefore, it is very important, in addition to a thor-
ough visual inspection, to check the following points before each ride.
EAU00340*
Pre-operation check list
ITEM CHECKS PAGE
Front brake9Check operation, free play, fluid level and vehicle for fluid leakage.
3-5, 6-20–6-21, 6-23–6-25
9Add DOT 4 brake fluid if necessary.
Rear brake9Check operation and free play.
3-6, 6-21–6-23
9Adjust if necessary.
Clutch9Check operation and free play.
3-5, 6-19–6-20
9Adjust if necessary.
Throttle grip and housing9Check smooth operation.
6-15
9Lubricate.
Engine oil9Check oil level.
6-9–6-10
9Add oil if necessary.
Drive chain9Check chain slack and condition.
6-25–6-27
9Adjust if necessary.
Wheels and tires9Check tire pressure, wear, damage and spoke tightness.
6-16–6-19
9Tighten spokes if necessary.
Control and meter cable9Check smooth operation.
6-28
9Lubricate if necessary.
Brake and shift pedal shafts9Check smooth operation.
6-28
9Lubricate if necessary.
Brake and clutch lever pivots9Check smooth operation.
6-29
9Lubricate if necessary.
5JX-9-E0 4/9/0 4:11 AM Page 22
1
2
3
4
5
6
7
8
9
6-27
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU03006
Lubricating the drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly
wear out, especially when riding in
dusty or wet areas. Service the drive
chain as follows.
EC000097
cC
The drive chain must be lubricated
after washing the motorcycle or
riding in the rain.
1. Clean the drive chain with
kerosene and a small soft brush.
ECA00053
cC
To prevent damaging the O-rings,
do not clean the drive chain with
steam cleaners, high-pressure
washers or inappropriate solvents.
EC000096
cC
Improper drive chain slack will
overload the engine as well as
other vital parts of the motorcycle
and can lead to chain slippage or
breakage. To prevent this from
occurring, keep the drive chain
slack within the specified limits.
3. Tighten both locknuts, and then
tighten the axle nut to the speci-
fied torque.
4. Adjust the brake pedal free play.
(See page 6-22 for brake pedal
free play adjustment proce-
dures.)
EW000103
w
After adjusting the brake pedal
free play, check the operation of
the brake light.
Tightening torque:
Axle nut:
104 Nm (10.4 m·kg)
2. Wipe the drive chain dry.
3. Thoroughly lubricate the drive
chain with a special O-ring chain
lubricant.
ECA00052
cC
Do not use engine oil or any other
lubricants for the drive chain, as
they may contain substances that
could damage the O-rings.
5JX-9-E0 4/9/0 4:11 AM Page 55
