2000 YAMAHA XV125S brake pads

Carburetor adjustment ..................................6-15
Idle speed adjustment ...................................6-15
Throttle cable free play adjustment..............6-16
Valve clearance adjustment ..........................6-16
Tires.................................................................6-17
Wheels ............................................................6-19
Clutch lever free play adjustment .................6-19
Front brake lever free play adjustment ........6-20
Rear brake pedal height and free play
adjustment ......................................................6-21
Brake light switch adjustment.......................6-22
Checking the front brake pads and rear brake
shoes ...............................................................6-22
Inspecting the brake fluid level .....................6-23
Brake fluid replacement.................................6-24
Drive chain slack check ..................................6-24
Drive chain slack adjustment ........................6-25
Drive chain lubrication...................................6-26
Cable inspection and lubrication ..................6-27
Throttle cable and grip lubrication ...............6-27
Brake and shift pedal lubrication ..................6-28
Brake and clutch lever lubrication ................6-28
Sidestand lubrication .....................................6-28
Front fork inspection ......................................6-29
Steering inspection ........................................6-29
Wheel bearings ..............................................6-30Battery .............................................................6-30
Fuse replacement ...........................................6-32
Headlight bulb replacement ..........................6-33
Turn signal light bulb replacement ..............6-34
Taillight bulb replacement ............................6-35
Supporting the motorcycle ...........................6-36
Front wheel removal ......................................6-36
Front wheel installation .................................6-37
Rear wheel removal .......................................6-38
Rear wheel installation ..................................6-39
Troubleshooting .............................................6-40
Troubleshooting chart ...................................6-41
MOTORCYCLE CARE AND STORAGE ..............7-1
Care ...................................................................7-1
Storage..............................................................7-4
SPECIFICATIONS................................................8-1
How to use the conversion table ....................8-5
CONSUMER INFORMATION .............................9-1
Identification number records.........................9-1
Key identification number ...............................9-1
Vehicle identification number .........................9-1
Model label .......................................................9-2
TABLE OF CONTENTS
1
2
3
4
5
6
7
8
9
7
8
9
5AJ-9-E3 (XV125S)<3.1E> 4/5/0 5:01 PM Page 6

PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
6-3
EAU00473PERIODIC MAINTENANCE AND LUBRICATION
Every
Every
6,000 km 12,000 km
No. ITEM CHECKS AND MAINTENANCE JOBSINITIAL or or
1,000 km 6 months 12 months
(Whichever (Whichever
comes first) comes first)
1 * Fuel line 9Check fuel hoses and vacuum hose for cracks or damage.
ÖÖ
9Replace if necessary.
2 Spark plugs9Check condition.
ÖÖÖ
9Clean, regap or replace if necessary.
3 * Valves 9Check valve clearance.
ÖÖÖ
9Adjust if necessary.
4 Air filter9Clean or replace if necessary.ÖÖ
9Check electrolyte level and specific gravity.
5 * Battery9Correct or recharge if necessary.ÖÖ
9Make sure that the breather hose is properly routed.
6 Clutch9Check operation.
ÖÖÖ
9Adjust or replace cable.
9Check operation, fluid level and vehicle for fluid leakage.
7 * Front brake (See NOTE on page 6-5.)
ÖÖÖ
9Correct accordingly.
9Replace brake pads if necessary.
8 * Rear brake 9Check operation.
ÖÖÖ
9Adjust brake pedal freeplay and replace brake shoes if necessary.
9 * Wheels 9Check balance, runout, spoke tightness and for damage.
ÖÖ
9Tighten spokes and rebalance, replace if necessary.”
9Check tread depth and for damage.
10 * Tires9Replace if necessary.
ÖÖ
9Check air pressure.
9Correct if necessary.
5AJ-9-E3 (XV125S)<3.1E> 4/5/0 5:01 PM Page 34

1
2
3
4
5
6
7
8
9
6-22
PERIODIC MAINTENANCE AND MINOR REPAIR
EW000106
w
8Brake pedal free play should
be checked whenever the
chain is adjusted or the rear
wheel is removed and then
reinstalled.
8Check the operation of the
brake light after adjusting the
rear brake.
8If it is impossible to make
proper adjustment, consult a
Yamaha dealer.
EAU00713Brake light switch
adjustment
The rear brake light switch is acti-
vated by the brake pedal and is
properly adjusted when the brake
light comes on just before braking
takes effect. To adjust the rear
brake light switch, hold the switch
body so it does not rotate while
turning the adjusting nut.
Turn the adjusting nut in direction
ato make the brake light come on
earlier.
Turn the adjusting nut in direction
bto make the brake light come on
later.
1. Brake light switch
2. Adjusting nut
1
2
a
b
EAU00720Checking the front brake
pads and rear brake shoes
EAU00725
Front brake
A wear indicator groove is provid-
ed on each brake pad. This indica-
tor allows checking of brake pad
wear without disassembling the
brake. Inspect the groove. If the
groove has almost disappeared,
ask a Yamaha dealer to replace the
pads.
1. Indicator groove
1
5AJ-9-E3 (XV125S)<3.1E> 4/5/0 5:01 PM Page 53

6-37
1
2
3
4
5
6
7
8
9
3. Make sure the slot in the
speedometer gear unit fits
over the stopper on the front
fork outer tube.
4. Install the wheel axle and let
the motorcycle down.
PERIODIC MAINTENANCE AND MINOR REPAIR
2. Loosen the pinch bolt and
wheel axle.
3. Elevate the front wheel by
placing a suitable stand under
the engine.
4. Remove the wheel axle and
the front wheel.
NOTE:
Do not depress the brake lever
when the disc and caliper are sepa-
rated.
1. Pinch bolt
2. Wheel axle
EAU01547Front wheel installation
1. Install the speedometer gear
unit into the wheel hub. Make
sure the wheel hub and the
speedometer gear unit hous-
ing are installed with the pro-
jections meshed into the slots.
2. Lift up the wheel between the
front fork legs and guide the
brake disc between the brake
pads. Make sure there is
enough gap between the brake
pads before inserting the brake
disc.
2
1
5AJ-9-E3 (XV125S)<3.1E> 4/5/0 5:01 PM Page 68