2000 YAMAHA XJ600N checking oil

R
PERIODIC MAINTENANCE AND MINOR REPAIR
/Net/layout8/layout_G2/work/Imai_work/OM-PS/AA9156_XJ600SN-E6/English/E-6TOC.-
Tool kit ................................................................ 6-1
Periodic maintenance and lubrication................. 6-2
Panel removal and installation ........................... 6-5
Panel A ............................................................... 6-5
Spark plug inspection ......................................... 6-6
Engine oil............................................................ 6-7
Air filter ............................................................. 6-10
Carburetor adjustment ...................................... 6-11
Idle speed adjustment ...................................... 6-12
Throttle cable free play inspection .................... 6-12
Valve clearance adjustment ............................. 6-13
Tires ................................................................. 6-13
Wheels ............................................................. 6-15
Clutch lever free play adjustment ..................... 6-15
Rear brake pedal height adjustment ................ 6-17
Brake light switch adjustment ........................... 6-17
Checking the front and rear brake pads ........... 6-18
Inspecting the brake fluid level ......................... 6-19
Brake fluid replacement .................................... 6-20
Drive chain slack check .................................... 6-20
Drive chain slack adjustment ............................ 6-21Drive chain lubrication....................................... 6-21
Cable inspection and lubrication ....................... 6-22
Throttle cable and grip lubrication ..................... 6-22
Brake and shift pedal lubrication ....................... 6-22
Brake and clutch lever lubrication ..................... 6-23
Center and sidestand lubrication ...................... 6-23
Rear suspension lubrication.............................. 6-23
Front fork inspection ......................................... 6-24
Steering inspection ........................................... 6-24
Wheel bearings ................................................. 6-25
Battery............................................................... 6-25
Fuse replacement ............................................. 6-26
Headlight bulb replacement (for XJ600S) ......... 6-27
Headlight bulb replacement (for XJ600N) ......... 6-29
Front wheel removal ......................................... 6-31
Front wheel installation ..................................... 6-31
Rear wheel removal .......................................... 6-33
Rear wheel installation ...................................... 6-34
Troubleshooting ................................................ 6-34
Troubleshooting chart ....................................... 6-35

L
6-7
PERIODIC MAINTENANCE AND MINOR REPAIR
/Net/layout8/layout_G2/work/Imai_work/OM-PS/AA9156_XJ600SN-E6/English/E-6.frame
When installing a spark plug, the gas-
ket surface should always be cleaned
and a new gasket used. Any grime
should be wiped off from the threads
and the spark plug tightened to the
specified torque.
NOTE:
If a torque wrench is not available when
installing a spark plug, a good estimate
of the correct torque is 1/4 to 1/2 turn
past finger tight. The spark plug should
be tightened to the specified torque as
soon as possible.Tightening torque:
Spark plug:
12.5 Nm (1.25 mákg)
1. Level window
2. Maximum level mark
3. Minimum level mark
EAU02938
Engine oil
Oil level inspection
1. Place the motorcycle on the cen-
terstand. Warm up the engine for
several minutes.
NOTE:
Be sure the motorcycle is positioned
straight up when checking the oil level.
A slight tilt toward the side can result in
false readings.
1. Engine oil filler cap
2. With the engine stopped, check
the oil level through the level win-
dow located at the lower part of
the right side crankcase cover.
NOTE:
Wait a few minutes until the oil level
settles before checking.
3. The oil level should be between
the maximum and minimum
marks. If the level is low, fill the en-
gine with sufficient oil to reach the
specified level.

L
6-19
PERIODIC MAINTENANCE AND MINOR REPAIR
/Net/layout8/layout_G2/work/Imai_work/OM-PS/AA9156_XJ600SN-E6/English/E-6.frame
1. Minimum level mark
EAU00732
Inspecting the brake fluid
level
Insufficient brake fluid may let air enter
the brake system, possibly causing the
brakes to become ineffective.
Before riding, check that the brake fluid
is above the minimum level and fill
when necessary.
Observe these precautions:
lWhen checking the fluid level,
make sure the top of the master
cylinder is level by turning the han-
dlebars.
1. Minimum level mark
l
Use only the designated quality
brake fluid. Otherwise, the rubber
seals may deteriorate, causing
leakage and poor brake perfor-
mance.
NOTE:
If DOT 4 is not available, DOT 3 can be
used.Recommended brake fluid: DOT 4
lRefill with the same type of brake
fluid. Mixing fluids may result in a
harmful chemical reaction and
lead to poor brake performance.
lBe careful that water does not en-
ter the master cylinder when refill-
ing. Water will significantly lower
the boiling point of the fluid and
may result in vapor lock.
lBrake fluid may deteriorate paint-
ed surfaces or plastic parts. Al-
ways clean up spilled fluid
immediately.
lHave a Yamaha dealer check the
cause if the brake fluid level goes
down.

L
INDEX
/Net/layout8/layout_G2/work/Imai_work/OM-PS/AA9156_XJ600SN-E6/English/EEIX.frame
A
Air filter .................................................6-10
B
Battery ..................................................6-25
Brake and clutch lever lubrication ........6-23
Brake and shift pedal lubrication ..........6-22
Brake fluid replacement ........................6-20
Brake light switch adjustment ...............6-17
C
Cable inspection and lubrication ..........6-22
Carburetor adjustment ..........................6-11
Care ........................................................7-1
Center and sidestand lubrication ..........6-23
Checking the front and rear brake
pads ...................................................6-18
Clutch lever ............................................3-9
Clutch lever free play adjustment .........6-15
Controls/Instruments (XJ600N) ..............2-6
Controls/Instruments (XJ600S) ..............2-3
D
Dimmer switch ........................................3-7
Drive chain lubrication ..........................6-21
Drive chain slack adjustment ................6-21
Drive chain slack check ........................6-20
E
Engine break-in ......................................5-5
Engine oil ................................................6-7
Engine stop switch .................................3-9
F
Front brake lever ................................. 3-10
Front fork inspection ............................ 6-24
Front wheel installation ........................ 6-31
Front wheel removal ............................ 6-31
Fuel ...................................................... 3-12
Fuel cock ............................................. 3-13
Fuel tank breather hose
(for Germany only) ............................ 3-12
Fuel tank cap ....................................... 3-11
Fuse replacement ................................ 6-26
G
Give safety the right of way ................... 1-1
H
Handlebar switches ............................... 3-7
Dimmer switch ................................. 3-7
Engine stop switch ........................... 3-9
Hazard switch .................................. 3-8
Horn switch ...................................... 3-8
Lights switch .................................... 3-9
Pass switch ...................................... 3-7
Start switch ...................................... 3-9
Turn signal switch ............................ 3-8
Hazard switch ........................................ 3-8
Headlight bulb replacement
(for XJ600N) ...................................... 6-29
Headlight bulb replacement
(for XJ600S) ...................................... 6-27
Helmet holders ..................................... 3-15
High beam indicator light ....................... 3-3
Horn switch ............................................ 3-8
I
Identification number records ................ 9-1
Idle speed adjustment .......................... 6-12
Indicator lights ........................................ 3-3
High beam indicator light .................. 3-3
Neutral indicator light ....................... 3-3
Oil level indicator light ...................... 3-3
Turn indicator lights .......................... 3-3
Inspecting the brake fluid level ............ 6-19
K
Key identification number
(for XJ600N) ........................................ 9-1
Key identification number
(for XJ600S) ........................................ 9-1
L
Left view (XJ600N) ................................ 2-4
Left view (XJ600S) ................................. 2-1
Lights switch .......................................... 3-9
Luggage strap holders ......................... 3-16
M
Main switch ............................................ 3-1
Model label ............................................ 9-2
N
Neutral indicator light ............................. 3-3