2000 YAMAHA TW125 ECO mode

Carburetor adjustment ..................................6-14
Idle speed adjustment ...................................6-14
Throttle cable free play inspection ...............6-15
Valve clearance adjustment ..........................6-15
Tires.................................................................6-16
Wheels ............................................................6-18
Clutch lever free play adjustment .................6-19
Front brake lever free play adjustment ........6-19
Rear brake pedal height and free play
adjustment ......................................................6-20
Brake light switch adjustment.......................6-21
Checking the front brake pads and
rear brake shoes .............................................6-22
Inspecting the brake fluid level .....................6-22
Brake fluid replacement.................................6-23
Drive chain slack check ..................................6-24
Drive chain slack adjustment ........................6-24
Drive chain lubrication...................................6-25
Cable inspection and lubrication ..................6-26
Throttle cable and grip lubrication ...............6-26
Brake and shift pedal lubrication ..................6-27
Brake and clutch lever lubrication ................6-27
Sidestand lubrication .....................................6-27
Rear suspension lubrication..........................6-28
Front fork inspection ......................................6-28
Steering inspection ........................................6-29
Wheel bearings ..............................................6-29Battery .............................................................6-30
Fuse replacement ...........................................6-31
Headlight bulb replacement ..........................6-32
Turn signal and taillight bulb
replacement ....................................................6-33
Supporting the motorcycle ...........................6-34
Front wheel removal ......................................6-35
Front wheel installation .................................6-36
Rear wheel removal .......................................6-36
Rear wheel installation ..................................6-37
Troubleshooting .............................................6-38
Troubleshooting chart ...................................6-39
MOTORCYCLE CARE AND STORAGE ..............7-1
Care ...................................................................7-1
Storage..............................................................7-4
SPECIFICATIONS................................................8-1
How to use the conversion table ....................8-5
CONSUMER INFORMATION .............................9-1
Identification numbers record.........................9-1
Key identification number ...............................9-1
Vehicle identification number .........................9-1
Model label .......................................................9-2
TABLE OF CONTENTS
1
2
3
4
5
6
7
8
9
7
8
9
5EK-9-E1 (TW125)<3.1> 4/6/0 11:50 PM Page 6

6-18
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
EAU00681
w
8Operating the motorcycle with
excessively worn tires
decrease riding stability and
can lead to loss of control.
Have excessively worn tires
replaced by a Yamaha dealer
immediately. Brakes, tires, and
related wheel parts replace-
ment should be left to a
Yamaha Service Technician.
8Patching a punctured tube is
not recommended. If it is
absolutely necessary to do so,
use great care and replace the
tube as soon as possible with
a good quality replacement.
EAU00685
Wheels
To ensure maximum performance,
long service, and safe operation,
note the following:
8Always inspect the wheels
before a ride. Check for cracks,
bends or warpage of the
wheel. Be sure the spokes are
tight and undamaged. If any
abnormal condition exists in a
wheel, consult a Yamaha deal-
er. Do not attempt even small
repairs to the wheel. If a wheel
is deformed or cracked, it must
be replaced.
8Tires and wheels should be
balanced whenever either one
is changed or replaced. Failure
to have a wheel balanced can
result in poor performance,
adverse handling characteris-
tics, and shortened tire life.8Ride at moderate speeds after
changing a tire since the tire
surface must first be broken in
for it to develop its optimal
characteristics.
5EK-9-E1 (TW125)<3.1> 4/6/0 11:50 PM Page 48

8-1
EAU01038
SPECIFICATIONS
1
2
3
4
5
6
7
8
9
Specifications
Model TW125
Dimensions
Overall length 2,140 mm
Overall width 810 mm
Overall height 1,120 mm
Seat height 805 mm
Wheelbase 1,330 mm
Ground clearance 260 mm
Minimum turning radius 2,100 mm
Basic weight (with oil and full
fuel tank)125 kg
Engine
Engine type Air-cooled 4-stroke, SOHC
Cylinder arrangement Forward inclined
single cylinder
Displacement 124 cm
3
Bore ´Stroke 57.0 ´48.8 mm
Compression ratio 10:1
Starting system Electric starter
Lubrication system Wet sumpEngine oil
Type
Recommended engine oil
classification API Service SE, SF, SG type
or higher
cC
Be sure to use motor oils that do not contain anti-friction
modifiers. Passenger car motor oils (often labeled “Energy
Conserving”) contain anti-friction additives which will cause
clutch and/or starter clutch slippage, resulting in reduced
component life and poor engine performance.
Capacity
Periodic oil change 1.0 L
With oil filter replacement 1.1 L
Total amount 1.3 L
Air filterWet type element
–10° 0° 10° 20° 30°
40°
SAE 10W/30
SAE 10W/40
SAE 20W/40
SAE 20W/50
–20°
SAE 15W/40 50°C
5EK-9-E1 (TW125)<3.1> 4/6/0 11:50 PM Page 75

Fuel
Type Regular unleaded gasoline
Fuel tank capacity 7.0 L
Reserve amount 1.0 L
Carburetor
Type/quantity Y24P/1
Manufacturer TEIKEI
Spark plug
Manufacturer / Type NGK / DR8EA
Spark plug gap 0.6 ~ 0.7 mm
Clutch typeWet, multiple-disc
Transmission
Primary reduction system Spur gear
Primary reduction ratio 74/20 (3.700)
Secondary reduction system Chain drive
Secondary reduction ratio 50/14 (3.571)
Transmission type Constant mesh 5-speed
Operation Left foot operationGear ratio 1st 2.250
2nd 1.476
3rd 1.125
4th 0.926
5th 0.793
Chassis
Frame type Diamond
Frame type Pressed and steel tube frame
Caster angle 26°
Trail 95 mm
Tires
Type With tube
Front
Size 130/80-18 66P
Manufacturer/ BRIDGESTONE / TW31
model
Rear
Size 180/80-14M/C 78P
Manufacturer/ BRIDGESTONE / TW34
model
Maximum load* 180 kg
Air pressure (cold tire)
up to 80 kg load*
SPECIFICATIONS
1
2
3
4
5
6
7
8
9
8-2
5EK-9-E1 (TW125)<3.1> 4/6/0 11:50 PM Page 76

EAU01039
CONSUMER INFORMATION
1
2
3
4
5
6
7
8
9
9-1
EAU02944Identification number
records
Record the key identification num-
ber, vehicle identification number
and model label information in the
spaces provided for assistance
when ordering spare parts from a
Yamaha dealer or for reference in
case the vehicle is stolen.
1. KEY IDENTIFICATION
NUMBER:
2. VEHICLE IDENTIFICATION
NUMBER:
3. MODEL LABEL INFORMATION:
EAU01041Key identification number
The key identification number is
stamped on the key tag.
Record this number in the space
provided and use it for reference
when obtaining a new key.
1. Key identification number
EAU01043Vehicle identification
number
The vehicle identification number
is stamped into the steering head
pipe.
Record this number in the space
provided.
NOTE:
The vehicle identification number
is used to identify your motorcycle
and may be used to register your
motorcycle with the licensing
authority in your state.
1. Vehicle identification number
1
1
1
6
5EK-9-E1 (TW125)<3.1> 4/6/0 11:50 PM Page 80

CONSUMER INFORMATION
1
2
3
4
5
6
7
8
9
9-2
EAU01049Model label
The model label is affixed to the
location shown in the figure.
Record the information on this
label in the space provided. This
information will be needed to
order spare parts from your
Yamaha dealer.
1. Model label
1
5EK-9-E1 (TW125)<3.1> 4/6/0 11:50 PM Page 81