TVIP V3 RS3200 SYSTEM PROGRAMMING INSTRUCTIONS
9 of 10
9
e
g
a
P
G
N
I
M
M
A
R
G
O
R
P
M
E
T
S
Y
S
P
I
V
T
A
T
O
Y
O
T
P ASS IVE ARMING ON/ OFF SELE CTIO N AND ENTRY DEL AY TIME SELEC TION
The RS3200 is fa ctory set to not passi vely ar m. To cha nge the system’s operation for passive arming,
as well as to adjust the entry delay time, f ollow the procedure below .
1. Before you begin:
Close all the doors and the trunk or hatch, unlock all th e doors with the inside
lock switch, then remove the key fro m th e igni tion switc h.
a.
Using a remote control,
lock, then unlock the
doors 3 times.
2.
Start the programming procedure. (Co mplete these steps within 30 seconds. ) b. Open the dr iv er’s door.c. Lock, then unlock the
dri ver’s door ins ide lock
butt on 3 time s.
d. The system locks the door
in 2 seconds; i f th is does
not happen, start o ver. e. Unlock the driver’s door
inside lock button.
a. Close, then open the door :
2 t im es= passi ve arming off
3 times= passi ve arming on,
0 sec. entr y delay.
4 ti mes= passi ve arming on,
15 sec. entry delay.
5 ti mes= passi ve arming on,
30 sec. entry delay.
b.
Lock, then unlock the
driver’s door inside
lock button 1 time. c. The system locks the
door in 2 seconds;
Programming is now
complete . If this does not
happen, start o ver.
3. Select the operating mode and entry time delay, and co mplete the
programming ste ps.
TVIP V3 RS3200 SYSTEM PROGRAMMING INSTRUCTIONS
10 of 10
Page 10 TOYOTA TVIP S YSTEM PROGRAMMING −RS3200
IGNITI ON−CON TROLLED AU TOMA TIC DOOR LOCK/ UNLO CK
W hen al l doors are c losed, the RS3200 is fac tory set to auto matically loc k the v ehic le’s door when the
igni tion key is turned to ON or START , and unlock them (open or not) when the key is turned bac k to
ACC or LOCK . Follow the procedure below to change t his feature’s operation mode .
1. Before you begin:
Open the dr iv er’s door and remo ve the key
f rom the ign ition switch .
2.
Start the programming procedure. (Co mplete these step s within 30 seconds.)
a. Insert the key into the
igni tion switch and turn it
from LOCK to ON 5 times
(ending a t ON).
b.
The ta il and marker lig hts
flash 1 time, and the b uzzer
c hirps 1 time. c. The status mon itor’s LED
(or the engine immobi lizer
system’s LED) turns on
for 30 seconds.
Note: I f the s
ystem does not act iv ate the lights and buzzer, start over .
3. Select the operating mode and co mplete the programming steps.
a. Close the door: Ig nition
controlled door locks on .
Close, then o pen and close
the door: Ignition controlled
door locks off. b.
Turn the ignition key
back to lock. c. The ta il and marker l ights flas h 1
time, and t he buzzer chirps 1 time
i f the system was set for I G door
lock co ntrol ON, twice f or IG door
lock control OFF. I f this does not
happen, start o ver: otherwise,
program ming is now complete .
