2000 TOYOTA AVALON light

'00 AVALON U (L/O9908)
325
Checking and replacing fuses
Ty p e AGood Blown
Ty p e B
Good
Good Blown
Blown
Ty p e C
If the headlights or other electrical
components do not work, check the
fuses. If any of the fuses are blown,
they must be replaced.
See Fuse locationsº in Section 7- 1 for
locations of the fuses.
Turn the ignition switch and inoperative
component off. Pull a suspected fuse
straight out and check it.
Determine which fuse may be causing the
problem. The lid of the fuse box shows
the name of the circuit for each fuse. See
Section 8 of this manual for the functions
controlled by each circuit. Type A fuses can be pulled out by the
pull- out tool. The location of the pull- out
tool is shown in the illustration.
If you are not sure whether the fuse has
blown, try replacing the suspected fuse
with one that you know is good.
If the fuse has blown, push a new fuse
into the clip.
Only install a fuse with the amperage rat-
ing designated on the fuse box lid.
If you do not have a spare fuse, in an
emergency you can pull out the RADIOº,
HTRº or A/Cº fuse, which may be
dispensable for normal driving, and use it
if its amperage rating is the same.
If you cannot use one of the same amper-
age, use one that is lower, but as close
as possible to the rating. If the amperage
is lower than that specified, the fuse
might blow out again but this does not
indicate anything wrong. Be sure to get
the correct fuse as soon as possible and
return the substitute to its original clip.
It is a good idea to purchase a set of
spare fuses and keep them in your ve-
hicle for emergencies.
ProCarManuals.com

'00 AVALON U (L/O 9908)
326
If the new fuse immediately blows out,
there is a problem with the electrical sys-
tem. Have your Toyota dealer correct it as
soon as possible.
CAUTION
Never use a fuse with a higher am-
perage rating, or any other object, in
place of a fuse. This may cause ex-
tensive damage and possibly a fire.
Adding washer fluid
If any washer does not work or low
windshield washer fluid level warning
light comes on, the washer tank may be
empty. Add washer fluid.
You may use plain water as washer fluid.
However, in cold areas where tempera-
tures range below freezing point, use
washer fluid containing antifreeze. This
product is available at your Toyota dealer
and most auto parts stores. Follow the
manufacturer 's directions for how much to
mix with water.
NOTICE
Do not use engine antifreeze or anyother substitute because it may dam-age your vehicle's paint.
Replacing light bulbsÐ
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
CAUTION
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if scratched
or dropped. Hold a bulb only by its
plastic or metal case. Do not touch
the glass part of a bulb with bare
hands.
NOTICE
Only use a bulb of the listed type.
ProCarManuals.com

'00 AVALON U (L/O9908)
327
Light bulbsBulbNo.WTy p e
Headlights
(low beam)900651A
Headlights
(high beam)900560B
Front fog lights900651A
Front turn signal/
parking lights1157 NA27/8C
Rear turn signal
lights744021D
Stop/tail lights744321/5D
Rear side marker
lights1684.9D
Back- up lights92118D
License plate lightsW5W5D
High mounted
stoplight92118D
Interior lightÐ7E
Front personal
lightsÐ7E
Rear personal
lightsÐ5E
Vanity lightsÐ2E
Light bulbsBulbNo.WTy p e
Glove box lightÐ1.2D
Door courtesy
lightsÐ6E
Trunk lightÐ3E
A: HB4 halogen bulbs
B: HB3 halogen bulbs
C: Single end bulbs
D: Wedge base bulbs
E: Double end bulbs
ÐHeadlights
1. Unplug the connector while depress-
ing the lock release.
If the connector is tight, wiggle it.
ProCarManuals.com

'00 AVALON U (L/O 9908)
328
2. Turn the bulb and remove it.3. Install a new bulb and the connectorinto the mounting hole.
Aiming is not necessary after replacing
the bulb. When aiming adjustment is nec-
essary, contact your Toyota dealer. If either the left or right front fog or
front turn signal/parking lights burns
out, contact your Toyota dealer.
NOTICE
Do not try to replace the front fog or
front turn signal/parking light bulbsby yourself. You may damage the ve-hicle.
ÐFront fog and front turn
signal/parking lights
ProCarManuals.com

'00 AVALON U (L/O9908)
329
Use a flat- bladed screw driver.a: Stop/tail light
b: Rear turn signal light
c: Rear side marker light
ÐBack- up lights
Remove and install the cover clips as
shown in the following illustrations.
ÐRear turn signal, stop/tail
and rear side marker lights
ProCarManuals.com

'00 AVALON U (L/O 9908)
330
Removing cover clips
Installing cover clips
ÐLicense plate lights
Remove and install the cover clips as
shown in the following illustrations.
ProCarManuals.com

'00 AVALON U (L/O9908)
331
Removing cover clips
Installing cover clips
ÐHigh mounted stoplight
(type A)
ProCarManuals.com

'00 AVALON U (L/O 9908)
332
ÐHigh mounted stoplight
(type B)
ProCarManuals.com