2000 SUBARU LEGACY brake light

[x] Cancel search: brake light

Page 122 of 413

SUBARU LEGACY 2000 3.G Owners Manual 3
Instruments and controls Ignition switch3-3
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 
Key reminder chime 3-5
. . . .

Page 131 of 413

SUBARU LEGACY 2000 3.G Owners Manual 3-10Warning and indicator lights 
Several of the warning  and  ind ic ator lig hts c ome on
 momentarily and
then g o out when the ig nition switc h is initially t urned  to the “ON ” p osi-
tion.

Page 135 of 413

SUBARU LEGACY 2000 3.G Owners Manual 3-14NOTE 
If the warning light behavior is as shown below, the ABS system may be considered normal.�
The warning light comes on right after the engine is started but
goes out immediately, remaining of

Page 229 of 413

SUBARU LEGACY 2000 3.G Owners Manual  Interior equipment6-13
–
 CONTINUED  –
�
Front ashtray
To op en the ashtray, p ull the lid  out. � Rear ashtray
The rear ashtray is loc ated  on the up p er sid e of th e b ac k of the c enter
c

Page 262 of 413

SUBARU LEGACY 2000 3.G Owners Manual Starting and operating7-25
–
 CONTINUED  –
but goes out immediately, remaining off. �
The warning light remains on after the engine has been
started, but it goes out when the vehicle speed reaches

Page 333 of 413

SUBARU LEGACY 2000 3.G Owners Manual 10-2Exterior care �
Washing
CAUTION
� When washing the vehicle, the brakes may get wet. As a result,
the brake stopping distance will be longer. To dry the brakes, drive the vehicle at a safe speed wh

Page 392 of 413

SUBARU LEGACY 2000 3.G Owners Manual  Maintenance and service11-53
–
 CONTINUED  –
5. Install a new b ulb  in the soc ket. 
6. Set the b ulb  soc ket into the rear c omb ination lig
ht assemb ly and
turn it c loc kwise until it loc k

Page 393 of 413

SUBARU LEGACY 2000 3.G Owners Manual 11-543. Using  a Phillip s sc rewd river, remove the up p er an
d  lower sc rews
that sec ure the sid e c over of the rear c omb ination  lig ht assemb ly.
4. Remove the b ulb  soc ket from the rear c
Page:   1-8 9-16 next >