2000 SUBARU IMPREZA coolant level

7-10Preparing to drive
You should p erform the following c hec ks and ad justm
ents every d ay b e-
fore you start d riving .
1. Chec k that all wind ows, mirrors, and lig hts are c lean and unob -
struc ted .
2. Chec k the ap p earanc e and c ond ition of the tires. Also c hec k tires for
p rop er inflation. 3. Look und er the vehic le for any sig n of leaks.
4. Chec k that the hood , trunk and rear g ate are full y c losed .
5. Chec k the ad justment of the seat.
6. Chec k the ad justment of the insid e and outsid e mi rrors.
7. Fasten your seat b elt. Chec k that your p asseng ers have fastened
their seat b elts.
8. Chec k the op eration of the warning and ind ic ator lig hts when the ig ni-
tion switc h is turned to the “ON ” p osition.
9. Chec k the g aug es, ind ic ator and warning lig hts af ter starting the en-
g ine. NOTE Engine oil, engine coolant, brake fluid, washer fluid and other fluid
levels should be checked daily, weekly or at fuel stops.
Driving in foreign countries
When p lanning to use your vehic le in another c ountr y:
Confirm the availab ility of the c orrec t fuel. (Refe r to the “Fuel req uire-
ment ” sec tion in this c hap ter.)
Comp ly with all reg ulations and req uirements of eac h c ountry.
Periodic inspections
To keep your vehic le in the b est c ond ition at all t imes, always have the
rec ommend ed maintenanc e servic es listed in the main tenanc e sc hed ule
in the “Warranty and Maintenanc e Booklet ” p erformed at the sp ec ified
time or mileag e intervals.

Maintenance and service10-13
–
CONTINUED –

Engine coolant Checking the coolant level
Chec k the c oolant level at eac h fuel stop .
HG0114
“
FULL ”
level mark
“ LOW ”
level mark
1. Chec k the c oolant level on the outsid e of the res ervoir while the
eng ine is c ool.
2. If the level is c lose to or lower than the “LOW ” level mark, ad d
c oolant up to the “FULL ” level mark. If the reserve tank is emp ty, re-
move the rad iator c ap and refill as req uired .
HG0115
Rubber gaskets
3. After refilling the reserve tank and the rad iator , reinstall the c ap s
and c hec k that the rub b er g askets insid e the rad iat or c ap are in the
p rop er p osition.

Maintenance and service10-15
–
CONTINUED –
HG0114
OM-H0197
“ FULL ”
level mark
“ LOW ”
level markFiller neck
Fill up to here
3. Slowly p our the c oolant and fill to the rad iator filler nec k and to the
reserve tank ’s “FULL ” level mark. Do not p our the c oolant too q uic kly,
as this may lead to insuffic ient air b leed ing and t rap p ed air in the sys-
tem.
Coolant c ap ac ity: 6.2 US q t (5.8 liters, 5.2 Imp q t )
HG0115
Rubber gaskets
4. Put the rad iator c ap b ac k on and tig hten firmly. At this time, make
sure that the rub b er g askets in the rad iator c ap ar e c orrec tly in p lac e.
5. Start and run the eng ine for more than five minut es at 2,000 to
3,000 rp m.
6. Stop the eng ine and wait until the c oolant c ools d own (122 to
140 F [ 50 to 60 C] ). If there is any loss of c oolant, ad d c oolant t o the
rad iator ’s filler nec k and to the reserve tank ’s “FULL ” level.

Maintenance and service10-31
–
CONTINUED –
Windshield washer fluid
CAUTION
Never use engine coolant as washer fluid because it could cause paint damage.
Chec k the level of the washer fluid at eac h fuel st op . If the level is low, fill
the fluid up to the nec k of the reservoir.
Use wind shield washer fluid . If wind shield washer f luid is unavailab le use
c lean water.
In areas where water freezes in winter, use an anti -freeze typ e wind shield
washer fluid . SUBARU Wind shield Washer Fluid c ontai ns 58.5% methyl
alc ohol and 41.5% surfac tant, b y volume. Its freezi ng temp erature varies
ac c ord ing to how muc h it is d iluted , as ind ic ated b elow.
Washer Fluid Concentration
Freezing Temperature
30% 50%
100%10.4 F(–12 C)
–4 F(–20 C)
–49 F(–45 C)
HG0122