2000 SUBARU IMPREZA change time

1-8
Keyless entry system (if equipped)
CAUTION
Do not expose the transmitter to severe shocks, such as those
experienced as a result of dropping or throwing. Do not take the transmitter apart except when replacing the
battery. Do not get the transmitter wet. If it gets wet, wipe it dry with a
cloth immediately. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept anyinterference received, including interference that may causeundesired operation.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user ’s authority to
operate the equipment.
The keyless entry system has the following func tion s.
Loc king and unloc king the d oors (and rear g ate on t he wag on and
OUTBACK SPORT) without a key Arming and d isarming the sec urity system (if your v ehic le is eq uip p ed
with an op tional sec urity system). See the next sec tion “Sec urity system
(if eq uip p ed ) ” for d etailed information.
The rec eiver insid e your vehic le ’s keyless entry system and the remote
c ontrol transmitters are d esig ned tog ether to have an averag e op erating
rang e of 25 to 50 feet (8 to 15 meters) d uring id ea l c ond itions. Althoug h
at times you may exp erienc e rang e g reater than that , there may b e oc c a-
sions when rang e is less than normal. Atmosp heric c ond itions or interfer-
enc e from other RF-emitting d evic es c an effec tively red uc e transmitter
rang e.

Doors and locks1-11
–
CONTINUED –
This ind ic ates that the system is in the Transmitte
r Prog ramming
Mod e. Do not release the Programming button.
4. Press the “LOCK ” b utton on the new transmitter. The d oor loc ks will
c yc le onc e.
5. Rep eat step 4 for any ad d itional transmitters.
6. Exit the Transmitter Prog ram Mod e b y releasing th e Prog ramming
b utton and turning the vehic le ig nition off. Test a ll remote transmitters
to ensure that they work p rop erly. n To delete a lost or stolen transmitter
1. Follow step 1 to 3 as d esc rib ed ab ove.
2. Re-p rog ram the remaining transmitters as d esc rib e d in step 4.
If there is only one remaining transmitter, p erform step 4 four
times .
If there are two remaining transmitters, p erform st ep 4 twice for
eac h transmitter. System maintenance
Your keyless entry system d oes not req uire any sp ec ific maintenanc e
exc ep t for oc c asionally c hang ing the transmitter b a ttery. The 12-volt
b attery in the remote transmitter should last ap p ro ximately one year,
d ep end ing on usag e. When the b attery b eg ins to weak en, you will
notic e a d ec rease in rang e, or the d istanc e from yo ur vehic le that the
remote transmitter will op erate. n To change the remote transmitter battery CAUTION
Do not let dust, oil or water get on or in the transmitter when
replacing the battery.

Instruments and controls3-13
–
CONTINUED –
lever.
first p osition
Parking lig hts, instrument p anel illumination, tail lig hts, sid e marker
lig hts and lic ense p late lig ht are on.
sec ond p osition
Head lig hts, p arking lig hts, instrument p anel illumi nation, tail lig hts,
sid e marker lig hts and lic ense p late lig ht are on. High/low beam change (dimmer)
To c hang e from low b eam to hig h b eam, p ush the turn sig nal lever
forward . When the head lig hts are on hig h b eam, the hig h b eam ind i-
c ator lig ht “a ” on the instrment p anel is also on.
To switc h b ac k to low b eam, p ull the lever b ac k to the d etent p osition.
Headlight flasher CAUTION
Do not hold the lever in the flashing position for more than just a few seconds.
To flash the head lig hts, p ull the lever toward you and then release it.
The hig h b eam will stay on for as long as you hold the lever. The
head lig ht flasher works even thoug h the lig hting sw itc h is in the “OFF ”
p osition.
When the head lig hts are on hig h b eam, the hig h b eam ind ic ator lig ht
“ a ” on the instrment p anel also c omes on.
Daytime running light system (for CANADA models)
WARNING
The tail lights, parking lights, and side marker lights are not turned on by the daytime running light system. The light switchmust always be turned to the “a ” position when it is dark out-
side.

6-14
Dome light
ON mode: Pressing the “ON ” switc h 7 will turn on main d ome lig ht.
DOOR mode: Pressing the “DOOR ” switc h 6 will allow all three lig hts
to fully illuminate when d oor is op ened and then fa d e out onc e d oor is
c losed . OFF mode: Pressing the “OFF ” switc h
5 will p revent all lig hts from
illuminating when the d oor is op ened . Rear map reading light
n Turn ON or OFF
Press the “MAP ON/OFF ” switc h
4 onc e to turn on the map lig ht at
full intensity. Press a sec ond time to turn it off.n Map light dimming
This area 2 will vary the intensity of the map lig ht d ep end ing on
whic h d imming zone area is p ressed . NOTE The switch color will change to indicate position setting.
Green indicates current switch while the other switches will be
Red . (Map light switches will be Yellow regardless of setting).
Switch indicator lights will shut off when not in use, but will
come back on when any switches are touched. The light assembly is equipped with a time delayed-off feature.
The lights will remain on for a few seconds after all vehicle doorsare closed. If a map light is in use and the door is opened, the map light
will maintain its current setting even after the door is closed. The light assembly is equipped with a 1 hour sleep mode timer
that will turn off any light that may be accidentally left on. Touch-ing any switch will reactivate the unit and allow for continued op-
eration.

6-22
Barometer
HS6004CB
The d isp lay ind ic ates atmosp heric p ressure in the p asseng er
c omp artment. Range : 21.26 to 30.86 inHg or 720 to 1045 hp a
NOTE The reading may change during air-conditioner operation,
door window operation, driving in a tunnel, and so forth. All barometric readings reported in local weather reports are
corrected to a sea-level reading regardless of altitude. The Gauge
Pack displays true local air pressure and hence may differ signifi-cantly from local weather reports (especially at higher altitudes).The barometer is not adjustable. Since air pressure changes with altitude, the barometric read-
ing will vary when the vehicle is moving up or down an incline.For accurate barometric trending, the vehicle should be station-
ary. Altimeter
The altimeter has two mod es, Stand ard elevation mod e and Relative
elevation mod e.

6-24NOTE
The indication may change during air-conditioner operation,
door window operation, driving in a tunnel, and so forth. Adjustable elevation is 780 ft ( 300 m).
To cancel the adjustment and return to the default altimeter
reading, press the “ SET” and “ ” switch together for 1 second
or more. n Relative elevation mode
HS6015BB
The altimeter ind ic ates the relative elevation.
1. The “MODE ” switc h c hang es the stand ard elevation mod e to the
relative elevation mod e.
2. Press the “ SET ” switc h for the “0 ” ft ” ( “0 m ”) setting .
3. The d isp lay shows the c urrent elevation relative to the starting
elevation. Range : up to 9800 ft (3000 m) at a p itc h of 20 ft (5 m)