7-14tral. Hold the c lutc h p ed al to the floor while star
ting the eng ine. The
starter motor will only op erate when the c lutc h p ed al is p ressed fully
to the floor.
4. Turn the ig nition switc h to the “ON ” p osition and c hec k the op era-
tion of the warning and ind ic ator lig hts. Refer to “Warning and ind ic a-
tor lig hts ” sec tion (Chap ter 3).
5. Turn the ig nition switc h to the “START ” p osition without d ep ressing
the ac c elerator p ed al. Release the key immed iately after the eng ine
has started .
If the eng ine d oes not start within ten sec ond s, wa it a while and then
turn the ig nition switc h to the “START ” p osition ag ain while d ep ressing
the ac c elerator p ed al half way d own.
6. Confirm that all warning and ind ic ator lig hts hav e g one off after the
eng ine has started . The fuel injec tion system autom atic ally lowers the
id le sp eed as the eng ine warms up . Automatic transmission vehicles CAUTION
If you restart the engine while the vehicle is moving, shift the se- lector lever into the “N” position. Do not attempt to place the se-
lector lever of a moving vehicle into the “P” position.
1. Ap p ly the p arking b rake.
2. Turn off unnec essary lig hts and ac c essories.
3. Shift the selec tor lever to the “P ” or “N ” p osition (p referab ly “P ”
p osition).
The starter will only op erate when the selec t lever is at the “P ” or “N ”
p osition.
4. Turn the ig nition switc h to the “ON ” p osition and c hec k the op era-
tion of the warning and ind ic ator lig hts. Refer to “Warning and ind ic a-
tor lig hts ” sec tion (Chap ter 3).
5. Turn the ig nition switc h to the “START ” p osition without depress-
ing the accelerator pedal . Release the key immed iately after the en-
g ine has started .
Starting and operating7-19
–
CONTINUED –
Automatic transmission
WARNING
Do not shift from the “P” or “N” position into the “D”, “3”, “2”,
“1” or “R” position while depressing the accelerator pedal. This
may cause the vehicle to jump forward or backward.
CAUTION
Shift into the “P” or “R” position only after the vehicle is com-
pletely stopped. Shifting while the vehicle is moving may cause
damage to the transmission. Do not race the engine for more than five seconds in any posi-
tion except the “N” or “P” position when the brake is set or the
tires are on blocks. This may cause the automatic transmissionfluid to overheat. Avoid shifting from one of the forward driving positions into
the “R” position or vice versa until the vehicle has completely
stopped. Such shifting may cause damage to the transmission.
The automatic transmission is elec tronic ally c ontro lled with 4-forward
sp eed s and 1-reverse sp eed .
NOTE
Immediately after a disconnected battery is reconnected or ATF (au- tomatic transmission fluid) is replaced, you may feel that the auto-matic transmission operation is somewhat unusual.This results from erasure or invalidation of data which the on-boardcomputer has collected and stored in memory to allow the transmis-sion to shift at the most appropriate times for the current conditionof your vehicle. Optimized shifting will be restored as the vehiclecontinues to be driven for a while.