Page 64 of 181
![RENAULT MEGANE 2000 X64 / 1.G Owners Manual Downloaded from www.Manualslib.com manuals search engine 2
1
Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\](/manual-img/7/1565/w960_1565-63.png "RENAULT MEGANE 2000 X64 / 1.G Owners Manual Downloaded from www.Manualslib.com manuals search engine 2
1
Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\")
Downloaded from www.Manualslib.com manuals search engine 2
1
Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T2.WIN 24/2/2001 14:29-page5
2.05
GEAR LEVER HANDBRAKE POWER STEERING
To select reverse
(vehicle stationary)
Move the lever to neutral, then
position the lever in reverse.
Ring1has to be lifted up to the gear
lever knob to select reverse gear.
The reversing lights will illuminate
as soon as reverse gear is selected
(ignition on).To release:
Pull the lever up slightly, press
button2and then lower the lever to
the floor.
Theredwarninglightonthe
instrument panel will illuminate if
you are driving with an incorrectly
released handbrake.
To apply:
Pull the lever up.
The lever should travel about 10
notches to hold the car. Your vehicle
is fitted with self-adjusting rear
brake shoes and the handbrake
should only be adjusted during a
brake overhaul.
When the vehicle is
stationary, make sure
that the handbrake is
properly applied so that
the vehicle does not move
unintentionally.
Make sure the handbrake is
properly released when driving,
otherwise overheating may
occur.When power assisted steering is
fitted, never leave the steering
wheel on full lock when the vehicle
is parked as this may damage the
pump.
Never switch off the
ignition when travelling
downhill, and avoid
doing so when driving in
general (power steering and
brake servo will not function).
Page 66 of 181
Downloaded from www.Manualslib.com manuals search engine Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T2.WIN 24/2/2001 14:29-page7
2.07
ADVICE ON ANTI-POLLUTION AND HOW TO ECONOMISE ON FUEL(continued)
Monitoring exhaust gas
The exhaust gas monitoring system
will detect any malfunctioning of
the vehicle’s exhaust gas
depollution system.
If this system malfunctions, toxic
substances may be released into the
atmosphere or mechanical damage
may occur.
This warning light on the
instrument panel will
indicate if there are any
problems with the system.
It illuminates when the ignition is
switched on and extinguishes
within 3 seconds.
- If it illuminates continuously,
consult your Renault Dealer as
soon as possible.
- If it flashes, reduce the engine
speed until the light stops
flashing. Consult your Renault
Dealer as soon as possible.
Driving
•Drive carefully for the first few
miles until the engine reaches its
normal operating temperature.
• Speed is expensive.
• “Snappy” driving uses a lot of
fuel: drive with a “light right
foot”.• Take your foot off the accelerator
pedal to slow down rather than
use the brakes wastefully and
judge the road well in advance.
• Avoid fierce acceleration.
•Donotoverrevtheengineinthe
intermediate gears.
Always use the highest ratio
possible without labouring the
engine.
On versions with an automatic
transmission, it is preferable to
keep your the gear lever inD.
•Donottrytomaintainthesame
speed up a hill; accelerate no
more than you would on the level.
Keep your foot in the same
position on the accelerator pedal.
• Double declutching and
accelerating before switching off
are superfluous actions in
modern cars.
• Bad weather, flooded roads
Do not drive through
floods if the depth of
water is above the lower
edge of the wheel rims.
Page 69 of 181
Downloaded from www.Manualslib.com manuals search engine A
Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T2.WIN 24/2/2001 14:30-page10
2.10
TYRE PRESSURE MONITORING SYSTEM
This system continuously monitors
the tyre pressures.
Tyre pressures should be adjusted
when the tyres are cold.
If tyre pressures cannot be checked
when the tyres arecold,assumean
increase of0.2to0.3bar.
Never deflate a hot tyre.
This function is an
additional driving aid.
However, the function
does not take the place of
the driver. It cannot, therefore,
under any circumstances replace
the vigilance or the
responsibility of the driver.
Check the tyre pressures,
including the emergency spare
wheel, once a month.
Operating principle
Each wheel (except the emergency
spare wheel) has a sensor,
implanted in the inflation valve
which periodically measures the
tyre pressure.
The driver is constantly informed of
the correct tyre pressures and
possible variations on displayA
and the instrument panel.
Page 70 of 181
Downloaded from www.Manualslib.com manuals search engine 1
D C
E F
2
1
Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T2.WIN 24/2/2001 14:30-page11
2.11
TYRE PRESSURE MONITORING SYSTEM(continued)
Non-interchangeability of
wheels
Each of the sensors
integrated in the valve1
is devoted to a single
wheel: under no
circumstances should you swap
the wheels.
There is a risk of false
information leading to serious
consequences.To mark the correct position of the
wheel, see the colour of the ring2
(after cleaning, if necessary) on each
valve:
-C: yellow ring
-D:blackring
-E:redring
-F:greenring
Fitting tyres
(replacing tyres or fitting winter
tyres)
As there are special precautions to
be taken when replacing tyres, we
advise you to consult your Renault
Dealer.
Reading the tyre pressures on
the instrument panel
(if fitted)
Once the car's tyre pressures have
been checked, warning messages on
the instrument panel are updated
once you exceed 15 mph (25 km/h).
Commercially available pressure
gauges will show variances in their
measurement of pressure (known as
tolerance).
Page 71 of 181
Downloaded from www.Manualslib.com manuals search engine A
Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T2.WIN 24/2/2001 14:30-page12
2.12
TYRE PRESSURE MONITORING SYSTEM(continued)
Spare wheel
The emergency spare wheel does
not have a sensor and is thus not
detected by the system.
When it is fitted in the place of
another wheel, the system detects a
fault.
Replacing wheels / rims...
This system requires special
equipment (wheels, hubcaps...).
Consult your Renault Dealer to find
out which accessories are
compatible with the system and
which are available from Renault
accessory outlets: use of any other
accessory may impair the operation
of the system.
Tyre repair aerosols
Asaresultofthespecialwheels,
only products approved by
Renault's Technical Department
may be used.
Display
The displayAand the warning
lights on the instrument panel
inform you of possible faults (flat
tyre, punctured tyre, system out of
service...):On the displayAthrough the
following warning lights:
and
On the instrument panel through
the following warning lights:
,and
The following pages show the
breakdown of the illumination of
various warning lights.
Page 72 of 181
Downloaded from www.Manualslib.com manuals search engine Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T2.WIN 24/2/2001 14:30-page13
2.13
TYRE PRESSURE MONITORING SYSTEM(continued)
Examples of illumination of warning lights on the instrument panel and display
flashing + lit up + faulty wheel(s) flashing
Meaning: the flashing wheel is slightly flat or over-inflated, check the tyre pressures.
flashing + lit up + faulty wheel(s) flashing
Meaning: the flashing wheel is very flat, stop as soon as possible and check the tyre pressures.
flashing + lit up + lit up + faulty wheel(s) flashing
Meaning: puncture, replace the wheel concerned or call your Renault Dealer.
lit up + faulty wheel(s) not lit up
Meaning: system fault (if, for example, the emergency spare wheel is fitted or winter tyres are fitted...).
lit up
Meaning: driving speed is not suited to the tyre pressures. Slow down or inflate the tyres to the full load pressure (see
the “tyre pressures” table.
Page 76 of 181
Downloaded from www.Manualslib.com manuals search engine Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T2.WIN 24/2/2001 14:30-page17
2.17
ANTI-LOCK BRAKING SYSTEM (ABS)(continued)
If the ABS system is faulty, two
possible situations may occur:
1 - The orange warning
light illuminated on the
instrument panel.
The braking system then
operates in the same way as a
vehicle not equipped with an
ABS system. Contact your
Renault Dealer as a matter of
urgency.
2-The orange
warning light and
the red brake circuit
incident warning light
illuminated on the instrument
panel.
This indicates that both the
braking system and the ABS
system are faulty. Your vehicle
brakes may still partially
operate. However, it is
dangerous to brake suddenly
and it is essential to stop
immediately, as soon as traffic
conditions allow. Contact your
Renault Dealer as a matter of
urgency.The braking modulation provided
by the anti-lock braking system is
independent of the effort applied to
the brake pedal. In an emergency,
applycontinuous pressureto the
brake pedal - there is no need to
pump it repeatedly.
Page 78 of 181
Downloaded from www.Manualslib.com manuals search engine A
B
1
G
I
F
Q X B I U D B * T [ G 3 D J H
MEGANE CABRIOLET NU 640-2C:\Documentum\Checkout
u640-2_eng_T2.WIN 24/2/2001 14:30-page19
2.19
PROACTIVE AUTOMATIC GEARBOX
Selector lever1
The position of selector lever1is
indicated on the displayFon the
instrument panel.
P:Park
R:Reverse
N: Neutral
D: Drive in automatic
(Gears authorised: 1, 2, 3 and 4)
2: 2nd gear hold (gears authorised:
1, 2)
1: 1st gear hold
Position D3 or 3rd gear hold(Gears authorised: 1, 2, 3)
With the selector lever in position
D, press buttonB. A tell-tale lightI
will illuminate on the instrument
panel. Press buttonBagain to
deselect this position. (The tell-tale
light will extinguish.)
Note:When the tell-tale light is
illuminated, the system will
prevent 4th gear being selected.For safety reasons, certain positions
may not be selected until the
mechanism is unlocked: press
buttonA.
Only engage D or R when the
vehicle is stationary, with your foot
on the brake and the accelerator
pedal released.
Driving
With the gear lever in position Por
N, switch on the ignition.
With your foot on the brake pedal,
move the lever from positionPorN.
For safety reasons, to move out of P
position it is essential to apply the
footbrake before pressing the
unlocking buttonA.