2000 RENAULT CLIO light

18IUB*DT[G      3DJH 
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T4.WIN 16/10/2000 11:23-page12
4.12
BODYWORK MAINTENANCE
Protection against the action of
corrosive agents
Although your vehicle has been
treated with very effective
anti-corrosion products, it is still
subject to the action of:
• corrosives in the atmosphere
- atmospheric pollution (urban
and industrial areas),
- saline atmosphere (near the sea,
particularly in hot weather),
- seasonal and humid climatic
conditions, especially road salt
in winter.
• abrasives
- wind-carried dust and sand, mud,
road grit thrown up by other
vehicles.
• minor impacts
To avoid losing the benefits of this
protection, a minimum number of
precautions should be taken to
ensure against this risk.
What you must not do
• Wash the vehicle in bright sunlight
or in freezing temperatures.
• Scrape off mud or dirt without
pre-wetting.
• Allow external dirt to accumulate.
• Allow rust to form after minor
impacts.
• Use solvents not recommended
by Renault's Technical Department
to remove spots as they may
damage the paintwork.
• Drive frequently in snow or muddy
conditions without periodically
washing the car, particularly
under the wheel arches and under
the body.• Degrease or clean mechanical
components (e.g. engine
compartment), underneath the
bodywork, parts with hinges (e.g.
inside the fuel tank flap, sunroof)
and painted plastic external
fittings (e.g. bumpers) using high
pressure cleaning apparatus or
spraying on products which are
not approved by our Technical
Department as this could give rise
to corrosion or incorrect operation.

18IUB*DT[G      3DJH 
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T4.WIN 16/10/2000 11:23-page13
4.13
BODYWORK MAINTENANCE(continued)
What you should do
• Wash your car frequently, using our
recommended cleaning products
anduseahighpressurejettorinse
off the wheel arches and under the
body to get rid of:
- spots of tree resin and industrial
grime;
-bird droppings, which contain
chemicals whichrapidly
discolour paintwork and may
even cause the paint to peel off;
The vehiclemustbe washed
immediately to remove these
marks since they cannot be
removed by polishing;
- salt from the wheel arches and
under the body, after the vehicle
has been driven in areas where
the roads are chemically treated;
- mud forming damp patches in
the wheel arches and under the
body.• Keep well away from the vehicle
in front when driving on a freshly
laid surface to avoid damage to
your paintwork.
• Have patches where the paint has
been damaged repaired quickly to
avoid corrosion spreading.
• If your vehicle is covered by the
Renault anti-corrosion warranty,
remember to visit the bodyshop
periodically. Refer to your vehicle’s
Warranty and Servicing booklet.
• Respect local regulations relating
to washing your vehicle (e.g. do
not wash your vehicle on a public
highway).• Before using a revolving brush
type car wash, check the mounting
of exterior equipment, additional
headlights and rear view mirrors.
Secure the wiper blades and radio
aerial with adhesive tape.
Remove the car phone aerial if the
vehicle has one.
• If mechanical components such
as hinges have to be cleaned, their
protection must be reapplied by
spraying on products approved
by Renault's Technical Department.
We have selected special products
to care for your vehicle which
may be obtained from Renault
Accessory Outlets.

18IUB*DT[G      3DJH 
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T4.WIN 16/10/2000 11:23-page14
4.14
INTERIOR TRIM MAINTENANCE
Whatever type of stain is on the
trim, use soapy water (if necessary
warm) based on:
• natural soap,
• washing up liquid (1 part
washing up liquid to 200 parts of
water)
Rinse with a soft, damp cloth.
Special points
Instrument glass(e.g. instrument
panel, clock, external temperature
display, radio display, etc.).
Use a soft cloth or cotton wool.
If this does not clean the glass, use a
soft cloth (or cotton wool) slightly
dampened with soapy water then
rinse with a soft cloth or damp
cotton wool.
Carefullydry with a soft dry cloth.
Cleaning products containing
alcohol may not be used under any
circumstances.Seat belts
These must be kept clean.
Use products selected by Renault's
Technical Department (Renault
Accessory Outlet) or use warm
soapy water with a sponge and dry
with a dry cloth.
Do not use cleaning agents or dyes
under any circumstances.
We have selected special products
to care for your vehicle which
may be obtained from Renault
Accessory Outlets.

18IUB*DT[G      3DJH 
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T5.WIN 16/10/2000 11:24-page1
5.01
Section 5: Practical advice
Emergency spare wheel .................................................................................................................................... 5.02
Tool kit (Jack - Wheelbrace - Wheel spanners, etc.) ...................................................................................... 5.03
Wheel embellishers .......................................................................................................................................... 5.04
Changing a wheel ............................................................................................................................................. 5.05
Tyres (tyre safety, wheels, winter precautions) ................................................................................. 5.06
¬5.08
Wiper blades ..................................................................................................................................................... 5.09
Replacing bulbs: ................................................................................................................................... 5.10
¬5.17
Headlights ........................................................................................................................................... 5.10 - 5.11
Fog lights ....................................................................................................................................................... 5.12
Rear lights ........................................................................................................................................... 5.13 - 5.14
Side repeaters ................................................................................................................................................ 5.15
Interior lights ...................................................................................................................................... 5.16 - 5.17
Battery ..................................................................................................................................................... 5.18 - 5.19
Fuses ....................................................................................................................................................... 5.20 - 5.21
Remote control locking device (replacing batteries) ..................................................................................... 5.22
System for cutting off the fuel supply in the event of a severe impact ...................................................... 5.23
Towing (breakdown - trailer) ................................................................................................................ 5.24 - 5.26
Fitting a radio/accessories .................................................................................................................... 5.27 - 5.28
Operating incidents ............................................................................................................................. 5.29
¬5.34

1
3
2
18IUB*DT[G      3DJH 
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T5.WIN 16/10/2000 11:24-page5
5.05
CHANGING A WHEEL
•Remove the wheel embellisher
(see section on embellishers).
• Use the wheelbrace1to loosen
the wheel bolts slightly. Fit it so
that you press downwards and
not upwards.
• Offer up the jack horizontally, the
jack head must be slid
underneath the jacking point
under the body, nearest the wheel
concerned.
• Screw up the jack by hand at first
to align the base plate (which
should be inclined further
inwards than the jack head). Use a
piece of wood under the base
plate if on soft ground.• Insert the end of the wheelbrace2
into the jack3and turn a few
times to lift the wheel off the
ground:
• Remove the bolts.
• Take off the wheel.
• Position the emergency spare
wheel on the central hub and turn
it to locate the mounting holes in
the wheel and the hub.
• Tighten the bolts and lower the
jack.
• Tighten the bolts fully when the
wheel is on the ground.Park your vehicle on firm,
flat ground (if necessary,
placing a plank under the
base of the jack).
Switch on the hazard warning
lights.
Apply the handbrake and engage a
gear (first or reverse, orPon an
automatic gearbox).
Ask all the passengers to get out of
the vehicle and keep them away
from moving traffic.
If you have a puncture,
replace the wheel as soon
as possible.
A tyre which has been
punctured should always be
inspected (and repaired if possible)
by a specialist.

1
A
2
3
4
18IUB*DT[G      3DJH 
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T5.WIN 16/10/2000 11:24-page10
5.10
SINGLE HEADLIGHTS: replacing the bulbs
Main beam / dipped beam
headlights
Remove the bulb connector1.
Remove the plastic coverA.
Release the spring4and remove the
bulb.
Type of halogen bulb: H4, approved
by our Technical Department (see
box).
Never touch the glass of a halogen
bulb. Hold it by the base.
Once the bulb has been replaced,
refit the coverA.
Front side light
Turn bulb holder2a quarter turn to
reach the bulb.
Bulb type: W 5 W.
Direction indicator
Turn bulb holder3a quarter turn
and remove the bulb.
Bulb type: orange pear shaped
bulb, bayonet fitting, 21 W.
Cleaning the headlights
As the headlights have plastic
lenses, use a soft cloth or cotton
wool.
If this is not sufficient, use a soft
cloth (or cotton wool) dampened
with soapy water then rinse using a
soft cloth or cotton wool.
Carefullydry off using a soft, dry
cloth.
Alcohol based cleaning products
must not be used under any
circumstances.
As the headlights have
plastic lenses, anti-UV H4
type bulbs approved
by Renault's Technical
Department must be used.
(The headlight may be damaged if
any other type of H4 bulb is used.)
We recommend you obtain an
emergency kit including a box of
spare bulbs.

1
2
BA
3
4
18IUB*DT[G      3DJH 
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T5.WIN 16/10/2000 11:24-page11
5.11
DUAL HEADLIGHTS: replacing the bulbs
Main beamA/ Dipped beamB
headlights
Remove the bulb connector1or2.
Turn the bulb holder a quarter of a
turn and remove the bulb.
Type of halogen bulb:A
¶H7
B¶HB3
Anti-UV (see box).
Never touch the glass of a halogen
bulb. Hold it by the base.
Once the bulb has been replaced,
make sure the bulb holder is refitted
in the correct position.
Front side light
Turn the bulb holder4aquarterofa
turn to reach the bulb.
Type of bulb: W 5 W.
Direction indicator
Turn the bulb holder3aquarterofa
turn and remove the bulb.
Type of bulb: orange pear-shaped
bulb, bayonet fitting: 21 W.
Cleaning the headlights
As the headlights have plastic
lenses, use a soft cloth or cotton
wool.
If this is not sufficient, use a soft
cloth (or cotton wool) dampened
with soapy water then rinse using a
soft cloth or cotton wool.
Carefullydry off using a soft, dry
cloth.
Alcohol based cleaning products
must not be used under any
circumstances.
As the headlights have
plastic lenses, anti-UV
H7 and HB3 type bulbs
approved by Renault's
Technical Department must be
used.
(The headlight may be damaged
if any other type of H7 and HB3
bulb is used.)
We recommend you obtain an
emergency kit including a box of
spare bulbs.

1
1
2
3
18IUB*DT[G      3DJH 
X65 - CLIOC:\Documentum\Checkout_47\Nu607-8gb_T5.WIN 16/10/2000 11:24-page12
5.12
FOG LIGHTS: replacing the bulbs
• Remove the mounting bolts1.
• Remove the light unit from the
front.
• Disconnect the wires.
• Remove cover2by turning it.
• Remove the bulb connector.
• Release spring3.
• Remove the bulb.
•Holding the new bulb in a cloth or
piece of paper,slide it into its
mounting.
Type of halogen bulb: H1Adjusting the lights
Contact your Renault Dealer for
adjusting the lights.
Take care when working
under the bonnet as
the engine cooling fan
may cut in at any
moment.
Additional lights
If you wish to fit fog lights or long
range headlights to your vehicle,
consult your Renault Dealer.
Any operation on (or
modification to) the
electrical system must be
performed by a Renault
Dealer since an incorrect
connection might damage the
electrical installation (harness,
components and in particular, the
alternator). In addition, your
Dealer has available all the parts
required for fitting these units.