Page 136 of 502
EXTERIOR EQUIPMENT
11 9
15L025b
1Tilt up 2Lower
To tilt up the rear end of the moon roof fully, push the
switch on the rear side or on the front side to lower
it.
To operate the moon roof, the ignition key must be in the
ºONº position.
Key off operation: Even if the ignition key is turned to
the ºACCº or ºLOCKº position, the moon roof can be
operated until any of the doors is opened (or for about 45
seconds).
Page 137 of 502
EXTERIOR EQUIPMENT
120
Operating the moon roof from outside
the vehicle
The moon roof can be closed or opened using an ignition
key.*
Insert the ignition key into the key hole on the
driver's door.
To close the moon roof: Turn the key in the locking
direction and hold it.
After the door is locked, the moon roof begins to close.
To stop in the middle, return the key.
To open the moon roof: Turn the key in the unlocking
direction and hold it.
After the door is unlocked, the moon roof begins to open.
To stop in the middle, return the key.
NOTE: *This feature can be set inoperative, or sliding open or tilting up can be selected. Ask your Lexusdealer for details.
Jam protection function
During closing operation, the moon roof stops and is
open if something gets caught into the roof opening.
If the moon roof receives a strong impact, this function
may work even if nothing is caught.
Page 163 of 502
COMFORT ADJUSTMENT
146
Replace the belt assembly (including bolts) if it
has been used in a severe impact. The entire
assembly should be replaced even if damage is
not obvious.Front seat belt buckle illumination
16L020
Opening the driver's door lights up the driver's seat
belt buckle for easy use. The same applies for the
front passenger's door and seat belt buckle.
The light remains on for 15 seconds after the door is
closed, but goes off immediately when all doors are
locked.
Page 204 of 502

COMFORT ADJUSTMENT
187
A forward±facing child restraint system should
be allowed to be put on the front seat only when
it is unavoidable. Always move the seat as far
back as possible, because the force of a
deploying airbag could cause death or serious
injury to the child. Do not allow the child to lean
over the front door or around the front door
even if the child is seated in a child restraint
system. It is dangerous if the side airbag
inflates, and the impact could cause death or
serious injury to the child.
After installing the child restraint system, make
sure it is secured in place according to the
manufacturer's instructions. If it is not
restrained securely, it may cause death or
serious injury to the child in the event of a
sudden stop or accident.
When not using the child restraint system, keep it
secured with the seat belt or place it in the trunk or
somewhere other than in the passenger compartment.
This will prevent it from injuring passengers in the event
of a sudden stop or accident.
Your vehicle has anchors for securing the top strap of a
child restraint system.
For instructions about how to use the anchor bracket,
see ªUsing a top strapº on page 207. To install an anchor bracket, use an 8 mm X 30 mm X
1.25 mm coarse thread metric bolt and a 15 mm (0.6 in.)
spacer
for the outer anchors or a 10 mm (0.4 in.) spacer
for the center anchor. Note that the bolts accompanying
many child restraint systems are not metric. You can
damage the anchor nuts on your vehicle if you force
bolts with different thread into the anchor nuts.
For instructions about how to install the anchor bracket,
see ºTop strap anchors and locationsº.
If your child restraint system does not provide any of the
necessary parts, you can purchase the following items
from your Lexus dealer.
CRS installation kit (Part No. 04731±22012)
± contains 1 bolt, 3 types of spacer and 1 locking clip.
Bolt (Part No. 91511±60830)
Page 233 of 502
THEFT DETERRENT
216
THEFT DETERRENT SYSTEM
To deter theft of the vehicle, this system is designed
to give an alarm if any of the doors, trunk or hood is
forcibly unlocked or the battery terminal is
disconnected and then reconnected while the
vehicle is locked.*
NOTE: *The system operating condition can bechanged. Ask your Lexus dealer for details.
The alarm blows the horn intermittently and flashes the
headlights, tail lights and other exterior lights.
17L001
Page 234 of 502

THEFT DETERRENT
217
Setting the system
1. Turn the ignition key to the ºLOCKº position and
remove it.
The indicator light flashes by means of the engine
immobiliser system.
2. Close and lock all the doors, trunk and hood
using an ignition key or wireless remote control.If you lock them with wireless remote control, the turn
signals flash once.*NOTE: *The turn signals can be set not to flash. Ask
your Lexus dealer for details.
The flashing indicator light will change to stay on when
all the doors, trunk and hood are closed and locked.
3. After 30 seconds, the indicator flashes and the
system is set.
Cancelling the system
When you unlock any door or trunk using an ignition
key or wireless remote control, the system is
cancelled.
If you unlock any door or trunk with wireless remote
control, the turn signals flash twice.*
NOTE: *The turn signals can be set not to flash. Ask your Lexus dealer for details.
Activating the system
The alarm sounds for 60 seconds if any of the following
are operated:
Unlocking any door or trunk without using an ignition
key or wireless remote control.
Opening the hood forcibly.
Reconnecting the battery.
Page 235 of 502

THEFT DETERRENT
218If any door is unlocked and the ignition key is not in the
ignition switch during the alarm sounding, its door is
automatically locked.
To stop the alarm:
Use either of the following methods.
Unlock the door or trunk using an ignition key or
wireless remote control.
Turn the ignition switch on.
Testing the system
1. Open all the windows.
2. Set the system as described above.
The front doors should be locked with the ignition key or
wireless remote control. Be sure to wait until the
indicator light starts flashing.
3. Unlock one of the doors from the inside.
The system should activate the alarm.
4. Unlock any of the doors with a key or the wireless
remote control to cancel the system.
5. Repeat this operation for the other doors and
hood.
When testing the hood, also check that the system is
activated when the battery terminal is disconnected and
then reconnected.
If the system does not work properly, have it checked by your Lexus dealer.
NOTICE
Disconnecting the battery may result in the
erasure of information you have set in thecomputer memory. After reconnecting thebattery, check that the memorized data has beenretained. If it has been erased, input it into thecomputer once more.
Page 300 of 502
STARTING AND DRIVING
283
Keep the trunk lid closed while driving. An
open or unsealed trunk lid may cause exhaust
gases to be drawn into the vehicle.
To allow proper operation of your vehicle's
ventilation system, keep the inlet grilles in front
of the windshield clear of snow, leaves, or other
obstructions.
If you smell exhaust fumes in the vehicle, drive
with the windows open and the trunk lid closed.
Have the cause immediately located and
corrected.BEFORE STARTING THE ENGINE
1. Check the area around the vehicle before entering it.
2. Adjust seat position, seatback angle, head restraint
height and steering wheel angle.
3. Adjust the inside and outside rear view mirrors.
4. Lock all doors.
5. Fasten seat belts.
Remember to check that the service reminder indicators
function when turning the key to ºONº, and check the fuel
gauge to see that you have sufficient fuel.