2000 Lexus ES300 lights

SWITCHES
32To turn the lights on, twist the knob on the end of the
lever.
FIRST CLICKSTOP: Only the parking, tail, license
plate, side marker and instrument panel lights turn on.
SECOND CLICKSTOP: Headlights also turn on.
THIRD CLICKSTOP (ªAUTOº): The headlights and all
other lights automatically turn on depending on the
darkness of the surroundings.
Vehicles sold in U.S.A.:
When the headlights are on,
the headlight indicator lights up in the instrument cluster.
Vehicles sold in Canada: When the tail lights are on,
the tail light indicator lights up in the instrument cluster.
Manually twist the knob to the second clickstop to
turn on the headlights if they are needed
immediately when entering a dark tunnel, parking
structure, etc. When
the headlight switch is turned to the first or second
clickstop, the brightness of the instrument cluster will be
reduced slightly unless the instrument panel light control
knob is turned fully on.
12E045

SWITCHES
33
The automatic light control sensor is on top of the
driver's side instrument panel.
Do not place anything on the instrument panel, and/or do
not affix anything on the windshield to block this sensor.
When the headlights come on, the lights automatically
turn off about 30 seconds after any of the doors is
opened and closed with the ignition key turned to the
ªACCº or ªLOCKº position. To turn them on again, turn
the ignition key to the ªONº position, or turn the headlight
switch off
and then twist the knob until the first or second
clickstop. If you are going to park for over one week,
make sure the headlight switch is off. Daytime Running Light System
The headlights turn on at reduced intensity when the
parking brake is released with the engine started, even
with the light switch in the ªOFFº position. They will not
go off until the ignition switch is turned off.
To turn on the other exterior lights and instrument panel
lights, twist the knob to the first clickstop.
Twist the knob to the second clickstop to turn on the
headlights to full intensity for driving at night.
When setting the knob to the third clickstop (ªAUTOº),
the headlights will automatically adjust to full intensity
and/or turn on the other lights depending on the
darkness of the surroundings. Likewise, as the
surroundings
become brighter, the headlights will turn to
reduced intensity, ultimately turning off the other lights.
NOTICE
To prevent the battery from being discharged, do not leave the lights on longer than necessarywhen the engine is not running.

SWITCHES
34
Automatic headlight leveling system
(Vehicles with discharge headlight only)
12E044
As the headlight beam level is always maintained
automatically at the proper level in all loading conditions,
your headlights do not dazzle other road users.
If this system fails, the warning light in the instrument
cluster comes on. If this occurs, have your vehicle
checked by Lexus dealer.HEADLIGHT DIMMER ANDTURN SIGNAL SWITCH
12E003±1

SWITCHES
36For signaling
turns, move the lever up or down in the
conventional manner.
The ignition key must be in the ªONº position.
The turn signal is self±cancelling after a turn, but after a
lane change, you may have to cancel it by hand. You can
also signal a lane change by moving the turn signal lever
partway and holding it there.
If the green light in the instrument cluster flashes faster
than normal, it indicates that the front or rear turn signal
bulb has burned out. If this indicator light does not come
on, the fuse or the indicator light itself has probably
failed.
FOG LIGHT SWITCH
12E005±1
To turn on the fog lights, turn the switch to the ªONº
position. The fog lights come on only when the
headlights are on low beam.WINDSHIELD WIPER AND WASHER SWITCH

SWITCHES
44
Operating the driver's and front
passenger's switch
To lower the window, push the switch halfway down.
Pull it up to raise the window. The window glass
moves as long as the switch is operated.
Automatic operation: To fully raise or lower the
window automatically, pull the switch fully up or push it
fully down.
To stop the window partway, lightly push or pull the
switch in the opposite direction and then release it.
Operating the rear passengers' switches
To lower the window, push the switch down. Pull it
up to raise the window. The window moves as long
as the switch is operated.
Operating the window lock switch
12E013±2

Indicator light
With the window lock switch pressed in, only the
driver's window can be raised or lowered.
The indicator lights on the switch tell you which of the
switches can be operated.

SWITCHES
49
To turn on the emergency flashers, push the switch.
All the turn signal lights will flash. The emergency
flashers
will work with the engine running or off and with
or without the ignition key.
Turn on the emergency flashers to warn other drivers if
you must stop your vehicle where it might be a traffic
hazard.
Always pull your vehicle as far off the road as possible.
The turn signal light switch will not work when the
emergency flashers are in operation.
NOTICE
To prevent the battery from being discharged, do not leave the switch on longer than necessarywhen the engine is not running.
SEAT HEATER SWITCHES
12E042

GAUGES, METERS AND SERVICE REMINDER INDICATORS
65
(h) ªABSº Warning Light
The light comes on with the ignition key turned to ªONº.
If the anti±lock brake system and the brake assist
system work properly, the light goes out after a few
seconds. Thereafter, if either of the systems
malfunctions, the light comes on.
When the ªABSº warning light is on (and the brake
system warning light is off), the anti±lock brake system,
the brake assist system, the traction control system
and/or the vehicle skid control system do/does not
operate, but the brake system still operates
conventionally.
When the ªABSº warning light is on (and the brake
system warning light is off), the anti±lock brake system
does not operate so that the wheels could lock up during
a sudden braking or braking on slippery road surfaces.
If the following conditions occur, this indicates a
malfunction somewhere in the parts monitored by
the warning light system. Contact your Lexus
dealer as soon as possible to service the vehicle.
 The light does not come on with the ignition key
turned to ªONº, or remains on.
 The light comes on while driving.
If the light lit during driving goes out and does not come
on again, it is a normal operation.
(i) Open Door Warning Light
This light remains on until all the doors are completely
closed.
(j) Rear Light Failure Warning Light
If this light comes on when the headlight switch is turned
on (at the first or second clickstop), it indicates that one
or more of the tail lights are burned out.
If it comes on when the brake pedal is depressed, one
or more stop lights are burned out.
Have defective bulbs replaced as soon as possible.
(k) Vehicle Skid Control System Warning Lights (Vehicles with Vehicle Skid
Control System only)
These lights warn that there is a problem somewhere in
the vehicle skid control system, traction control system
and brake assist system.
The lights will come on when the ignition key is turned to
ªONº, and will go off after a few seconds.
If the ªVSCº warning light and ªVSC OFFº indicator light
come on, the vehicle skid control system, traction control
system and brake assist system do not work. However,
as conventional braking operates when applied, there is
no problem to continue your driving.

GAUGES, METERS AND SERVICE REMINDER INDICATORS
69
INSTRUMENT PANEL LIGHTCONTROL
13E005
To adjust the brightness of the instrument panel
lights, turn the knob.