2000 HONDA PRELUDE ignition

Key
s an d Lock s

START (III ) — Use this position
only to start the engine. The switch
returns to ON (II) when you let go of
the key.
The engine will not start if the Immobilizer System does not
recognize the key's coding (see page 71).
You will hear a reminder beeper if you leave the key in the ignition switch in the LOCK (0) or
ACCESSORY (I) position and open the driver's door. Remove the key to
turn off the beeper. Powe
r Doo r Lock s
Each door has a master door lock switch. This switch locks and
unlocks both doors. Push the switch down to lock both doors and up to
unlock them. Each door has a lock tab next to the
inside door handle. When you push
in the lock tab on the driver's door,
both doors lock. Pulling out the lock
tab on the driver's door only unlocks
that door. The lock tab on the
passenger's door only locks and
unlocks that door.
Instrument s an d Control s

Key
s and Locks

To lock the passenger'
s doo
r when
getting out of the car, push the lock
tab in and close the door. To lock the driver's door, remove the key from
the ignition switch and push the lock
tab in or push the master switch down, then close the door.
Both doors can be locked from the
outside by using the key in either

door.

To unlock only the driver's door from the outside, insert the key in
the driver's door lock, turn the key and release it. If you turn the key
and hold it, both doors will unlock.
Both doors will unlock when you
unlock the passenger's door with the
key. Lockout Prevention
If you forget and leave the key in the
ignition switch, Lockout Prevention
will not allow you to lock the driver's door. With the driver's door open
and the key in the ignition, both
master door lock switches are disabled. However, if the driver's
door is not open, the master door
lock switches are not disabled. Pushing the switch down on the
open passenger's door will lock both
doors. If you try to lock an open driver's door by pushing in the lock
tab, the tabs on both doors pop out. Pushing in the lock tab on the
passenger's door only locks that door. You can lock and unlock your car
with the remote transmitter. Whenyou push the LOCK button, both doors lock.
When you push the UNLOCK button once, only the driver's door unlocks.
The passenger's door unlocks when you push the button a second time.

CONTINUED

Instrument s an d Control s
Remot
e Transmitte r

LOCK

BUTTO N

UNLOC K

BUTTO N
LED

Key
s an d Locks

The ceiling light (if the ceiling light switch is in the center position) will
come on when you press the
UNLOCK button. If you d
o not open
either door, the light will go out in
about 10 seconds and the doors will
automatically relock. If

you reloc
k
the doors with the remote
transmitter before 10 seconds have elapsed, the light will go off
immediately.
You cannot lock or unlock the doors with the remote transmitter if eitherdoor is not fully closed or the key is
in the ignition switch.
Replacing the Battery

When the remote transmitter's battery begins to get weak, it maytake several pushes on the button to
lock or unlock the doors, and the LED will get dim. Replace the
battery as soon as possible.
Battery type: CR2025
To replace the battery, remove the
round cover on the back of the trans-mitter by turning it counterclockwise
with a coin.
Remove the old battery and note the
polarity. Make sure the polarity of
the new battery is the same (
+ side
facing up), then insert
it in the
transmitter.

Instrument s an d Control s
Ope
n

Clos e
BATTER
Y
ROUN
D

COVE R

CUSHIO N
RIN G

Sea
t Heater s
On Canadian models

Both front seats are equipped with seat heaters. The ignition switch
must be ON (II) to use them. Push
the front of the switch, HI, to rapidly
heat up the seat. After the seat
reaches a comfortable temperature, select LO by pushing the back of the
switch. This will keep the seat warm. The HI or LO indicator lights and
remains lit until you turn it off by
pushing the opposite side of theswitch lightly. The indicator will turn

off.
In HI, the heater turns off when the
seat gets warm, and turns back on
after the seat's temperature drops. It
continues to cycle as long as you
leave it set on HI. The HI indicator
remains lit as a reminder that you
have the heater on.
In LO, the heater runs continuously.
It does not cycle with temperature

changes.
Follow these precautions whenever

you use the seat heaters:
Use the HI setting only to heat the

seats quickly. Select the LO

setting when the seats feel warm.

The HI setting draws large amounts of current from the

battery.
Do not use the seat heaters, even

on the
LO setting, i
f the engine is
left idling for an extended period.

They can weaken the battery,
causing hard starting.
Instrument s an d Control s

SEA
T HEATE R

Foldin
g Rea r Seat , Powe r Window s

Make sure both rear shoulder belts
are positioned in front of the rear seat-back whenever the seat-back is
in its upright position.
Make sure all items in the trunk, or
items extending through the opening
into the back seat, are secured.
Loose items can fly forward and
cause injury if you have to brake
hard. See Carrying Carg o on page
135.
Never drive with the seat-back
folded down and the trunk lid open. See Carbo n Monoxid e Hazar d on

page 49.
Powe
r Window s
Your car's windows are electrically- powered. Turn the ignition switch toON (II) to raise or lower any window.
Each door has a switch that controls
its window. To open the window,
push the switch down and hold it. Release the switch when you want
the window to stop. Close the
window by pulling back on the switch and holding it.
The driver's armrest has a masterpower window control panel. Toopen the passenger's window, pushdown on the switch and hold it down
until the window reaches the desired position. To close the window, pull
back on the window switch. Release
the switch when the window gets to
the position you want.

CONTINUED

Instrument s an d Control s
DRIVER'
S WINDO W

SWITC H
MAI
N

SWITC H

Powe
r Window s

The master control panel also con-tains these extra features:
AUT O — To open the driver's
window fully, push the window switch firmly down and release it.
The window automatically goes all the way down. To stop the window
from going all the way down, pull
back on the window switch briefly.
To open the driver's window only partially, push the window switchdown lightly and hold it. The window
will stop as soon as you release the
switch.

The AUTO function only works to lower the driver's window. To raise
the window, you must pull back on
the window switch and hold it until
the window reaches the desired
position.
The MAIN switch controls power to
the passenger's window. With thisswitch off, the passenger's window
cannot be raised or lowered. The
MAIN switch does not affect the driver's window. Keep the MAIN
switch off when you have children in
the car so they do not injure them- selves by operating the window
unintentionally.
The power window system has a key- off delay function. The windows will
still operate for up to ten minutes
after you turn off the ignition.
Opening either door cancels the
delay function. You must turn the
ignition ON (II) again before you can
raise or lower the windows.
Instrument s an d Control s

Closing a power window on
someone's hands or fingers can
cause serious injury.
Make sure your passengers are
away from the windows before
closing them.

Moonroo
f

Use the switch on the dashboard to
open and close the moonroof. The
ignition switch must be ON (II). Push and hold the switch to
open the moonroof. Release the
switch when the moonroof reaches
the desired position. To close the moonroof, press and hold the
switch.
The moonroof has a key-off delay.
You can still open and close the
moonroof for up to ten minutes after
you turn off the ignition. The key-off delay cancels as soon as you open
either door. You must then turn the
ignition ON (II) for the moonroof to
operate.
If you try to open the moonroof in
below-freezing temperatures, or when it is covered with snow or ice, you can
damage the moonroof panel or motor.

Instrument s an d Control s

MOONROO
F
SWITC H
Closin
g the moonroof on
someone's hands or fingers can
cause serious injury.
Make sure passengers are
clear of the moonroof before
closing it.
NOTIC
E

Mirror
s
Keep the inside and outside mirrors
clean and adjusted for best visibility.
Be sure to adjust the mirrors before
you start driving.
The inside mirror has day and night positions. The night position reduces
glare from headlights behind you. Flip the tab on the bottom edge of
the mirror to select the day or night
position. Adjustin
g th e Powe r Mirror s
Adjust the outside mirrors with the adjustment switch on the driver's
door armrest:
1. Turn the ignition switch ON (II).
2. Move the selector switch to L (driver's side) or R (passenger's

side).
3. Push the appropriate edge of the
adjustment switch to move the

mirror right, left, up or down.

4.
When you finish, mov
e the
selector switch to the center (off)
position. This turns off the adjustment switch so you can't
move a mirror out of position by accidentally bumping the switch.

Instrument s an d Control s

TA
B SELECTO
R SWITC H