Page 242 of 280
To install the new bulb:
Handle a halogen headlamp bulb carefully and keep out of
children's reach. Grasp the bulb only by its plastic base and do
not touch the glass. The oil from your hand could cause the bulb to
break the next time the headlamps are operated.
1. With the flat side of the new bulb's plastic base facing upward, insert
the glass end of the bulb into the lamp assembly. Turn the bulb left or
right to align the grooves in the plastic base with the tabs in the lamp
assembly. When the grooves are aligned, push the bulb into the lamp
assembly until the plastic base contacts the rear of the lamp assembly.
2. Install the bulb retaining ring over the plastic base until it contacts the
rear of the socket by rotating clockwise until you feel a ªstop.º
3. Connect the electrical connector into the rear of the plastic base until
it snaps, locking it into position.
4. Install the headlamp on vehicle by aligning the lamp with the rear
retainer, push rearward and secure with two retainer pins.
5. Turn the headlamps on and make sure they work properly. If the
headlamp was correctly aligned before you changed the bulb, you should
not need to align it again.
Maintenance and care
242
Page 243 of 280
Replacing front parking/turn signal bulbs
Note size and location of retainer
pins for installation.
1. At the back of the headlamp, pull
two retainer pins up to release the
headlamp assembly.
2. Pull headlamp assembly forward
disengaging the lamp from the rear
retainer to expose the back of the
bulb.
3. Remove bulb socket by turning it
counterclockwise, then slide it out
of the lamp assembly.
4. Carefully pull bulb straight out of
the socket and push in the new
bulb.
5. To complete installation, follow
removal procedure in the reverse
order.
Replacing tail lamp/backup lamp bulbs
1. Open the liftgate to expose the
tail lamp assemblies.
2. Remove the two screws from the
lamp assembly.
3. Carefully remove the lamp
assembly by pulling it rearward
about 45 degrees.
4. Rotate bulb socket
counterclockwise and remove from
lamp assembly.
5. Pull bulb straight out of socket and push in new bulb.
6. To complete installation, follow the removal procedure in the reverse
order.
Maintenance and care
243
Page 244 of 280
Replacing license plate lamp bulbs
1. Remove two screws and the
license plate lamp assembly from
the liftgate.
2. Remove bulb socket by pulling it
straight out of the lamp assembly.
3. Carefully pull the bulb out from
the socket and push in the new
bulb.
4. Push bulb socket in to the lamp
assembly.
5. Install the lamp assembly on
liftgate with two screws.
Replacing high-mount brakelamp bulbs
For bulb replacement, see a dealer or qualified technician.
Replacing cornering lamp bulbs
For bulb replacement, see a dealer or qualified technician.
Maintenance and care
244
Page 245 of 280
Using the right bulbs
Replacement bulbs are specified in the chart below. Headlamp bulbs
must be marked with an authorized ªD.O.T.º for North America and an
ªEº for Europe to assure lamp performance, light brightness and pattern
and safe visibility. The correct bulbs will not damage the lamp assembly
or void the lamp assembly warranty and will provide quality bulb burn
time.
Function Trade Number
Front park/turn lamps 3157 NAK (amber)
Cornering lamps 3156K
Headlamps 9007
Rear license plate lamps 168
High-mount brake lamp 921
Rear turn lamps 3156K
Backup lamps 3156K
Brake/tail lamps 3157K
Dome lamp 921
Cargo liftgate lamp T-562
Map lamps/dome 578 (opt)
Stepwell lamp T-562
Front seat footwell 194
Front door mounted courtesy lamp 168
Second row reading lamp 578
All replacement bulbs are clear in color except where noted.
To replace all instrument panel lights - see your dealer.
Maintenance and care
245
Page 275 of 280
gauge .........................................14
improving fuel economy ........235
low fuel warning light ................8
octane rating ....................234,257
quality ......................................234
running out of fuel .................235
safety information relating
to automotive fuels ................230
Fuses ...................................182,183
Garage door opener ...............93,99
Gas cap (see Fuel cap) ............233
Gas mileage
(see Fuel economy) .................235
Gauges .........................................14
engine coolant
temperature gauge ...................15
fuel gauge ..................................14
odometer ...................................15
speedometer .............................15
tachometer ................................14
trip odometer ............................16
GAWR
(Gross Axle Weight Rating) .....173
calculating ...............................175
definition .................................173
driving with a heavy load ......173
location ....................................173
GVWR (Gross
Vehicle Weight Rating) .............173
calculating ........................173,175
definition .................................173
driving with a heavy load ......173
location ....................................173
Hazard flashers .........................181
Head restraints ..................119,122
Headlamps ...................................26
aiming ...............................246,247
autolamp system .......................28
bulb specifications ..................245
daytime running lights .............26
flash to pass ..............................27
high beam ............................10,26replacing bulbs .......................241
turning on and off ....................26
warning chime ..........................13
Heating ........................................28
heater only system ...................28
rear seat controls .....................36
HomeLink universal
transceiver (see Garage
door opener) .....................93,95,96
Hood ..........................................204
Ignition .......................................257
positions of the ignition ...........81
Infant seats
(see Safety seats) .....................149
Inspection/maintenance
(I/M) testing ..............................240
Instrument panel
cleaning ...................................251
cluster ...................................8,251
lighting up
panel and interior .....................27
location of components ..............8
Jump-starting your vehicle ......197
Keyless entry system
autolock ...................................113
Keys
key in ignition chime ...............13
positions of the ignition ...........81
Lamps
autolamp system .......................28
bulb replacement
specifications chart ................245
cargo lamps ...............................27
daytime running light ...............26
headlamps .................................26
headlamps, flash to pass ..........27
instrument panel, dimming .....27
interior lamps ...............98,99,100
replacing bulbs ..240,241,243,244
Lane change indicator
(see Turn signal) ........................85
Liftgate ...............................117,118
Index
275
