TEST TC-14AREPAIRING - BATTERY VOLTAGE SRC HIGH EXCEEDED
Perform TEST DTC Before Proceeding
*Perform Verification TEST VER-2A. **Check connectors - Clean / repair as necessary.
INCREASE ENGINE REPAIR CHARGING
START TEST SPEED TO 2000 RPM. IS THE VOLTAGE YES SYSTEM FOR
TC-14A. MEASURE THE ABOVE 17.0 VOLTS? OVERCHARGING
VOLTAGE AT THE CONDITION.*
BATTERY.
NO
NOTE: PERFORM THE USE THE SCHEMATIC AS REPAIR CHARGING
FOLLOWING STEP A GUIDE AND WIGGLE IS THE VOLTAGE YES SYSTEM FOR
WITH THE ENGINE THE ALTERNATOR ABOVE 17.0 VOLTS? OVERCHARGING
SPEED AT 2000 RPM. CONNECTOR & HARNESS. CONDITION.*
NO
USING THE DRB,
ERASE CODES. RUN USING THE DRB, DOES THE DRB YES REPLACE THE ENGINE
THE ENGINE AT IDLE READ CODES. DISPLAY "BATTERY CONTROL MODULE.*
AND 2500 RPM FOR VOLTAGE HIGH"?
SEVERAL MINUTES.
NO
AT THIS TIME, THE USING THE
CONDITION REQUIRED SCHEMATIC AS A WERE ANY PROBLEMS YES REPAIR AS
TO SET THE CODE IS GUIDE, INSPECT THE FOUND? NECESSARY.*
NOT PRESENT. WIRING AND
FIG.1 CONNECTORS.
NO
REFER TO GENERAL
INFORMATION 3.3.2
FOR ADDITIONAL TEST COMPLETE.*
INFORMATION ON
INTERMITTENT CODES.
T
R
O
U
B
L
E
C
O
D
E
T
E
S
T
S
61
ProCarManuals.com
