TEST SK-9AREPAIRING - VIN MISMATCH
Perform TEST SK-1A Before Proceeding
*Perform Verification TEST VER-1A. **Check connectors - Clean / repair as necessary.
START TEST USING THE DRB,
SK-9A. ERASE SKIM CODES.
TURN IGNITION OFF. USING THE DRB, DOES THE DRB YES CONTINUE TEST
WAIT 10 SECONDS. READ SKIM CODES. DISPLAY THIS CODE? SK-9A ON THE
TURN IGNITION ON.NEXT PAGE.
NO
AT THIS TIME THE USING THE
CONDITION REQUIRED SCHEMATIC AS A WERE ANY PROBLEMS YES REPAIR AS
TO SET THE CODE IS GUIDE, INSPECT THE FOUND? NECESSARY.*
NOT PRESENT. WIRING AND
FIG.1 CONNECTORS.
NO
REFER TO GENERAL
INFORMATION 3.3.2
FOR ADDITIONAL TEST COMPLETE.*
INFORMATION ON
INTERMITTENT CODES.
S
E
N
T
R
Y
K
E
Y
I
M
M
O
B
I
L
I
Z
E
R
S
Y
S
T
E
M
319
ProCarManuals.com
TEST SC-1ACONTINUED - CHECKING SPEED CONTROL OPERATION
*Perform Verification TEST VER-3A. **Check connectors - Clean / repair as necessary.
TEST SC-1A
CONTINUED FROM
THE PREVIOUS TURN IGNITION OFF.
PAGE.
USING THE SCHEMATIC
AS A GUIDE, INSPECT WERE ANY PROBLEMS YES REPAIR AS
THE WIRING AND FOUND? NECESSARY.*
CONNECTORS.
FIG.1
NO
CHECK THE BRAKE LAMP ARE THE BRAKE LAMP
SWITCH AND CLUTCH SWITCH AND CLUTCH NO ADJUST OR REPLACE
PEDAL SWITCH PEDAL SWITCH AS NECESSARY.*
ADJUSTMENTS. ADJUSTED CORRECTLY?
YES
REPLACE THE ENGINE
CONTROL MODULE.*
S
P
E
E
D
C
O
N
T
R
O
L
T
E
S
T
S
375
ProCarManuals.com
