39-100
Installing
Installation is reverse of removal, noting the
following:
Notes:
After removing driveshaft, always remove any
remaining locking fluid from thread holes in the
transmission drive flanges and the rear final
drive. Otherwise there is a possibility that the
new bolts may get jammed when installed and
shear when removed.
Cleaning can be performed with a tap.
Always replace seal between drive flange and
driveshaft (remove protective film and attach
seal to drive flange). Adhesive surface must be
free of grease.
Replace driveshaft bolts (self-locking).
- Determine radial run-out at flange/driveshaft if a
factory marking is present at the driveshaft
page 39
-86
and adjust color marking at
driveshaft to new marking at flange.
Pa
ge 6 of 7 Tor
que tube, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.7
