2000 AUDI A6 AEB ATW Engines Lubrication System Components Workshop Manual

17-20

Tightening torques

Component

Tightening
torques
Oil pan to engine block M6 10 Nm (7 ft lb)
M10 45 Nm (33 ft lb)
Oil pan to transmission 45 Nm (33 ft lb)
Engine mount to subframe 25 Nm (18 ft lb)
Torque support to bracket on
engine 25 Nm (18 ft lb)
Torque support bracket to
engine
25 Nm (18 ft lb)
Side brace to bracket for
torque support 25 Nm (18 ft lb)
Side brace to engine support 20 Nm (15 ft lb)
Oil drain plug 50 Nm (37 ft lb)
Oil return line to oil pan 10 Nm (7 ft lb)
Transmission mount to
subframe 23 Nm (17 ft lb)
Pa
ge 25 of 33 Lubrication s
ystem com
ponents, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.17.1

17-21

Oil pump, removing and installing


Removing

- Remove oil pan Page 17
-9 .

- Unhinge baffle plate and remove.

Installing
Installation is the reverse of removal, noting the following:
Installing oil pan Page 17
-18
.
Tightening torque - Remove bolts (arrows).
- Press down on subframe and remove oil pump.
Component
Tightening torques
Oil pump to engine block 25 Nm (18 ft lb)
Pa
ge 26 of 33 Lubrication s
ystem com
ponents, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.17.1

17-22

Oil pressure and oil pressure switch,
checking


Function of dynamic oil pressure warning
system

Warning lamp, checking
With engine switched off and ignition on (terminal
15 on), oil pressure warning lamp will be lit (not
for vehicles with Auto Check system).

Warning criteria

Engine switched off and oil pressure switch
closed.
Coolant temperature less than 60 C (140
F), engine speed higher than 300 RPM and
oil pressure switch open.

Coolant temperature greater than 60 C
(140 F).

At engine speeds greater than 5000 RPM,
an active oil warning won't be erased
independent of oil pressure switch setting.
A Diagnostic Trouble Code (DTC) is
recognized when oil pressure switch is open
Pa
ge 27 of 33 Lubrication s
ystem com
ponents, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.17.1

for more than 0.5 seconds at engine speeds
greater than 1500 RPM. If condition occurs
more than three times during a drive,
warning will remain active even at engine
speeds less than 1300 RPM.
Pa
ge 28 of 33 Lubrication s
ystem com
ponents, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.17.1

17-23

Special tools and equipment

VAG1342 oil pressure tester
VAG1527B voltage tester
VAG1594A measuring appliance adapter

Test conditions
Oil level OK
Oil pressure warning light -K3- must light up
when ignition is switched on.
For vehicles with Auto Check system, "i.O"
indicator must be lit (call up symbol)
Engine oil temperature approximately 80 C
(176 F)
Pa
ge 29 of 33 Lubrication s
ystem com
ponents, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.17.1

17-24

Oil pressure switch, checking

- Disconnect line from oil pressure switch.

Note:
While starting engine, watch pressure tester and LED as oil pressure
switch may open during start. - Remove oil pressure switch and install VAG1342 oil pressure tester.
- Install oil pressure switch into VAG1342 oil pressure tester.
- Connect brown wire -1- of tester to Ground (GND).
- Using VAG1594 adapter, connect VAG1527B voltage tester to oil
pressure switch and Battery Positive Voltage (B+).
LED must not be lit.
- If LED is lit, replace oil pressure switch.
- Start engine.
At 1.2-1.6 bar (17.4-23.2 psi) LED must be lit.
- If LED does not light, replace oil pressure switch.
Pa
ge 30 of 33 Lubrication s
ystem com
ponents, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.17.1

17-25

Oil pressure, checking

- Disconnect line from oil pressure switch.

If specified values are not obtained, the pressure relief valve or the oil
pump is faulty. - Remove oil pressure switch and install VAG1342 oil pressure tester.
- Install oil pressure switch into VAG1342 oil pressure tester.
- Start engine.
Engine oil temperature approximately 80 C (176 F). Oil pressure at idle: 1.0-3.5 bar (14.5-50.75 psi)Oil pressure at 3000 RPM: 5.0-7.0 bar (72.5-101.5 psi)
- Replace oil pump Page 17
-21
.
Pa
ge 31 of 33 Lubrication s
ystem com
ponents, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.17.1

17-26

Engine oil

Engine oil capacity (w/filter): 3.5 L (3.7 qt.).
The engine is factory-filled with a high quality
multi-grade oil that can be used as an all-season
oil, except in extremely cold climates.

Viscosity classes and oil specifications

Select the viscosity according to the chart shown. The oil does not need
to be changed if the outside temperature only briefly exceeds the
specified ranges.
The specifications stated on these pages must be indicated on the
container either individually or in combination with other specifications. 1) This VW specification must have a date of 10/91 or later. 2) These oils may only be used in exceptional cases if no approved
engine oil is available.
Mixing oils when topping up is permissible. A - Multi-grade oil, specification VW 500 00
1)
B - Multi-grade oil, specification VW 501 01
1)
- Multi-grade oil, specification API-SF- or -SG-
2)
Pa
ge 32 of 33 Lubrication s
ystem com
ponents, removin
g and installin
g
11/18/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE02.17.1