00-12
Thoroughly clean all connections and the
surrounding area before disconnecting.
When installing transmission, ensure dowel
sleeves are correctly seated.
O-rings, seals, gaskets
Always replace O-rings, seals and gaskets.
After removing gaskets and seals, always
inspect the contact surface on the housing or
shaft for burrs resulting from removal or for
other signs of damage.
Thoroughly clean housing joint surfaces before
assembling.
Before installing radial shaft oil seals, lightly oil outer edge and fill
space between sealing lips (arrow) with a thin coating of sealing
grease G 052 128 A1. The open side of the oil seals faces toward the side with fluid filling.When replacing oil seals, always vary the point at which the sealing
lips make contact (use insertion depth tolerances). Lightly oil O-rings before installing; this prevents the rings being
crushed when inserting. Check oil level after replacing gaskets and oil seals Page 34
-39
Pa
ge 3 of 12 Re
pair instructions
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.00.5
