39-55
- Press outer race for tapered roller bearing without shim "S1" into cover
for differential.
- Insert differential without drive wheel for speedometer sender -G22 into
transmission housing. Ring gear is positioned on left-hand side (same
side as cover for final drive).
- Install cover for differential with 4 bolts (25 Nm).
- Position transmission so that cover for differential faces up.
- Turn differential 5 turns in both directions so that tapered roller
bearings settle.
Note:
The tip of the dial gauge must be positioned on center of differential. - Assemble measuring equipment, use a 30 mm dial gauge extension.
- Set dial gauge (3 mm measuring range) -A- to "0" with 2 mm preload.
- Lift differential, without turning, and read off play on dial gauge.
Measurement in following example: 0.62 mm.
Pa
ge 4 of 15 Rin
g gear, ad
justin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.39.8
