30-44
Do not use force when performing the following
steps, otherwise the forks on the adjuster ring
can break off.
- Apply two screwdrivers to forks on adjuster ring.
Use press to compress pressure plate until it is
just possible to move adjuster ring.
- Using two screwdrivers, turn back adjuster ring
evenly in direction of arrows until it reaches stop.
- Hold adjuster ring against stop and reduce
pressure exerted by press so that adjuster ring is
held in this position.
Pa
ge 9 of 10 Clutch, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.3
30-45
Removing and installing clutch with SAC pressure plate
Note:
The adjuster ring in the SAC pressure plate has to be reset ( Page 30
-42
) before assembly when replacing the clutch plate on its own.
Clutch lining and contact surface of pressure plate must make full
contact with flywheel before securing bolts are inserted. To avoid damaging centering holes in pressure plate and centering
pins on flywheel, tighten securing bolts evenly and in several stages in
diagonal sequence.
- Position of clutch plate: spring pack (coil springs) or marking
"Getriebeseite" towards pressure plate and transmission.
- Loosen and tighten bolts gradually in diagonal sequence and in several
stages to 22 Nm.
- Reverse position of counter-hold tool 10-201 when removing.
- Use mandrel 3176 to center clutch plate.
Pa
ge 10 of 10 Clutch, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM03.30.3
