44-6
Wheel alignment
WARNING!
Do not re-use any fasteners that are worn or
deformed in normal use.
Some fasteners are designed to be used only
once, and are unreliable and may fail if used
a second time. This includes, but is not
limited to, nuts, bolts, washers, circlips and
cotter pins. Always follow the
recommendations in this manual-replace
these fasteners with new parts where
indicated, and any other time it is deemed
necessary by inspection.
The wheel alignment should be measured using
VW/Audi approved wheel alignment equipment.
Wheel alignment checks must always include
both the front and the rear axles. Otherwise the
proper running characteristics of the vehicle
cannot be ensured.
Notes:
The wheel alignment should not be checked
before the vehicle has completed 1000-2000
km (600-1200 miles) so that the coil springs
have time to settle.
Pa
ge 1 of 37 Wheel ali
gnment
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.44.2
44-10
Wheel alignment must be checked if
There are problems with vehicle performance.
There is accident damage.
Tires are worn on one side.
Axle components have been removed table below.Front axle component
removed or replaced Alignment check
required S-point adjustment
required Rear axle component
removed or replaced Alignment check
required
Yes
No
Yes
No
Yes
No
Rear upper link X X Shock absorber X
Front upper link X X
Guide link with hydraulic-
bushing X X Coil spring X
Suspension strut X X
Track control link X X Upper control arm 1) X
Mounting bracket X X Lower control arm 1) X
Wheel bearing housing X X Wheel bearing housing1) X
Tie rod X X Track rod 1) X
Steering gear X X Subframe 1) X
Pa
ge 7 of 37 Wheel ali
gnment
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU01.44.2
