39-81
- Remove mounting bolts for both driveshaft
flanges.
- Remove upper three mounting bolts for each
driveshaft constant velocity joint.
- Back off mounting bolts for center support
slightly.
Only for carbon fiber driveshafts:
Spacer pieces are attached to 3405 alignment fixture via a chain.
Arrow -A- points in direction of travel.
WARNING!
Assembly tool must rest on both steel rings -1- before tightening
plastic nut -A-. If that is not the case, the surface of the carbon fiber
driveshaft can be damaged and must be replaced see Important
notes Page 39
-74
- Place spacer pieces -2- onto 3405 alignment fixture (distance
dimension = 10 mm).
- Using spacer pieces -2-, hook in 3405 alignment fixture according to
illustration.
Pa
ge 10 of 23 Driveshaft, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.5
39-88
Driveshaft, adjusting
Special tools and equipment
Adjustments must be made very carefully as a poorly adjusted driveshaft
is usually the cause of vibrations and humming noises.
Repair Manual, Engine Mechanical, Repair Group 26; removing and
installing exhaust system
3405 alignment fixture
- Observe notes page 39
-73
.
- Remove crossmember below exhaust system if installed.
- Remove rear part of exhaust system starting at clamp to gain access to
the driveshaft: - Remove heat shields above driveshaft.
- Release mounting bolts for center support slightly.
Pa
ge 18 of 23 Driveshaft, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.5
