2000 Acura RL lock

Key
s an d Lock s

Powe r Doo r Lock s
Each front door has a master door
lock switch. Either switch locks and unlocks all doors. Push the switchdown to lock all doors, and up to
unlock them. Each door has a lock tab at the top of
the door. When you push down the
lock tab on the driver's door, all doors lock. Pulling up the lock tab on
the driver's door only unlocks that door. The lock tab on each
passenger's door only locks and
unlocks that door. To lock any passenger's door when
getting out of the car, push the lock
tab down and close the door. To lock
the driver's door, remove the key
from the ignition switch and push the lock tab down or push the master switch down, then close the door.
All doors can be locked from the outside by using the key in either
front door. To unlock only the driver's door from the outside, insert the key
in the driver's door lock, turn the key
and release it. If you turn the key
and hold it, all doors will unlock. All
four doors will unlock when you unlock the passenger's door with the
key.
CONTINUED
Instrument s an d Control s

MASTE
R DOO R LOC K SWITC H
LOCK TA B

Key
s an d Lock s

Lockout Prevention
If you forget and leave the key in the
ignition switch, Lockout Prevention
will not allow you to lock the driver's door. With the driver's door open
and the key in the ignition, both
master door lock switches are disabled. However, if the driver's
door is not open, the master door
lock switches are not disabled. Pushing the switch down on the
open passenger's door will lock all
doors. If you try to lock an open
driver's door by pushing in the lock
tab, the tabs on all doors pop out. Pushing in the lock tab on the
passenger's door only locks that door. Remot
e Transmitte r
You can lock and unlock your car with the remote transmitter. When
you push the LOCK button, all doorslock. You will hear a beep, and the
parking lights, taillights and license
plate lights will flash once. When you push the UNLOCK button
once, only the driver's door unlocks.
The remaining doors unlock when you push the button a second time.
You will hear two beeps, and the outside lights will flash twice, each
time you push the button.
The ceiling lights (if the ceiling light switch is in the center position) and
the door courtesy lights will come on
when you press the UNLOCK button. If you do not open any door, the
lights stay on for about 10 seconds,
then fade out. If you relock the doors
with the remote transmitter before 10 seconds have elapsed, the lights
will go off immediately.
Instrument s an d Control s
LE
D

UNLOC K
BUTTO N
LOC
K

BUTTO N
TRUN K

RELEAS E

BUTTO N
PANI C
BUTTO N

Key
s an d Lock s

If you unlock the doors with the
remote transmitter, but do not open
any of the doors within 30 seconds,
the doors automatically relock and
the security system sets.
You cannot lock any of the doors with the remote transmitter if any door is not fully closed or the key is
in the ignition switch. You cannot
unlock any of the doors with the key
in the ignition switch.
To open the trunk, push the Trunk Release button for approximately
one second.
You can open the trunk with the remote transmitter regardless of the
position of the main switch in the
glove box. The trunk will not open if
the key is in the ignition switch.
Turning the Beep Off and On

You can program the keyless entry system so it does not beep when you
lock and unlock the doors. This
procedure only turns off the beep;
the exterior lights will still flash.
To turn this feature off, stand near the car with the remote transmitter.Press and hold the Trunk Release
button, then press the Lock button
within one second. You should see the LED on the remote transmittercome on for one second. Release the
buttons after the LED goes out.
To turn this feature on, repeat the above procedure. You should see the
LED blink twice.
After you program the remote transmitter, make sure the trunk lidis closed.
Panic Mode

Panic mode allows you to remotely activate your car's security system to
attract attention. When activated, the
horn will sound, and the exterior
lights will flash, for about 30 seconds.
To activate panic mode, press and hold the PANIC button for about two
seconds.

To cancel Panic mode before 30 seconds, press any button on the
remote transmitter. You can also
turn the ignition switch to ON (II).
Panic mode will not activate if the
ignition switch is in ON (II).
CONTINUED
Instrument s an d Control s

Key
s an d Lock s

Replacing the Battery

When the remote transmitter's battery begins to get weak, it may
take several pushes on the button to
lock or unlock the doors, and theLED will get dim. Replace the

battery as soon as possible.

Battery type: CR2025
To replace the battery, remove the
round cover on the back of the trans-
mitter by turning it counterclockwise
with a coin.
Remove the old battery and note the
polarity. Make sure the polarity of
the new battery is the same (+ side
facing up), then insert it in the
transmitter. Reinstall the cushion ring. Align the mark on the cover with the
mark on the transmitter,
then set the cover in place and turn it
clockwise.

Instrument s an d Control s
Ope
n
Clos e
ROUN
D
COVE R
CUSHIO N
RIN G

BATTER Y

Key
s an d Lock s

As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any
interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly
approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with Industry
Canada Standard RSS-210.

Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept any interference that may causeundesired operation of the device. Transmitter Care
Avoid severe shock to the trans- mitter, such as dropping or throwing
it. Also, protect it from extreme hot
or cold temperatures.
Clean the transmitter case with a
soft cloth. Do not use strong
cleaners or solvents that could harm
the case. Immersing the transmitter in any liquid will harm the trans-
mitter and cause it to not function
properly.
If you lose a transmitter, you will
need to have the replacement
programmed to your car's system by
your Acura dealer. Any other transmitters you have will also need
to be reprogrammed. Childproo
f Doo r Lock s
The childproof door locks are designed to prevent children seated
in the rear from accidentally opening
the rear doors. Each rear door has a
lock lever near the edge. With the
lever in the LOCK position, the door cannot be opened from the inside
regardless of the position of the lock
tab. To open the door, pull the lock
tab up and use the outside door

handle.

Instrument s an d Control s

LEVE
R

Key
s an d Lock s

Trun k

You can open the trunk in three
ways:
Press the trunk release button on
the driver's door.
Use the master key to open the
trunk lock. The valet key does not
work in this lock. Press and hold the trunk release
button on the remote transmitter
for approximately one second (see

page 82).
To close the trunk, press down on
the trunk lid.
See page 174 for cargo loading and
weight limit information. Keep the
trunk lid closed at all times while driving to avoid damaging the lid,
and to prevent exhaust gas from
getting into the interior. See Carbo n
Monoxid e Hazar d on page 49. To protect items in the trunk when
you need to give the key to someone
else:

1. Disable the trunk release button on the driver's door by turning off
the trunk main switch in the glove

box.

Instrument s an d Control s

TRUN
K RELEAS E BUTTO N MASTE
R KE Y

TRUNK MAI N SWITC H

Key
s an d Lock s
2. Lock the glove box with the master key.
3. Make sure the trunk pass-through cover is locked (see page 97).
4. Give the person the valet key. Even if the trunk main switch is
turned off, you can open the trunk
with the master key or the remote transmitter. Glov
e Bo x
Open the glove box by pulling the
bottom of the handle. Close it with a
firm push. Lock or unlock the glove
box with the master key.
The glove box light comes on only when the parking lights are on.

Instruments an d Control s

An open glove box can cause
serious injury to your passengerin a crash, even if the
passenger is wearing the seat

belt.

Always keep the glove box closed while driving.

HomeLin
k Universa l Transmitte r

Trainin g th e Transmitte r
Before you can use the HomeLink
Universal Transmitter to operate
devices around your home, it must

"learn" the proper codes. For
example, to train the transmitter to
open and close the garage door:

1. This step erases all previously learned
codes. Perform this step before
training the transmitter for the very

first time. Press and hold the two
outside buttons until the red light
in the transmitter flashes (approximately 20 seconds).
Release the buttons.
2. Hold the end of the garage door opener remote control 1 to 3
inches from the HomeLink
transmitter. Make sure you are
not blocking your view of the red
light in the transmitter. 3. Select the transmitter button you
want to train.
4. Press the button on the remote control and the button on the
transmitter at the same time. Hold down both buttons. 5. The red light in the transmitter
should begin flashing. It will flash
slowly at first, then rapidly.
6. When the red light flashes rapidly, release both buttons. The
transmitter should have learned
the code from the remote control.
7. Test the transmitter button by pushing it. It should operate the
garage door.
8. Repeat these steps to train the other two transmitter buttons to
operate any other remotely-
controlled devices around your
home (lighting, automatic gate, security system, etc.).

CONTINUED

Instrument s an d Control s