2000 Acura RL light

Control
s Nea r th e Steerin g Whee l

Windshiel d Wiper s

The right lever controls the wind- shield wipers and washers. The
rotary switch at the end of the lever
has three positions: INT: intermittent
: low speed
: high speed

In intermittent, the wipers operate
every few seconds. The sweep
interval will change slightly with

speed; getting shorter as you drive

faster. In low speed and high speed, the wipers run continuously. You can vary how often the wipers
sweep the windshield by turning the
INT TIME ring next to the rotary
switch.

If you turn the INT TIME ring to the shortest delay, the wipers will
change from intermittent to low speed operation when vehicle speed
exceeds 12 mph (20 km/h).

Instrument s an d Control s

Control
s Nea r th e Steerin g Whee l

To operate the wipers in mist mode, push the control lever down. The
wipers run at high speed until you release the lever. This gives you aquick way to clear the windshield.
Wiper Arms Winter Position

The windshield wiper arms have two
parked positions: Winter andSummer. In the winter position, the
arms sit slightly above the edge of
the hood. This reduces the possibili-
ty of damage to the wiper arms or
windshield wiper motor by a build-up of snow and ice.
Adjust the wiper arms to the winter position by grasping either arm near
the pivot. Pull on the arm, parallel to the windshield, until it locks in the
higher position. Push the arm in the other direction to return the wipers
to the summer position. A heavy build-up of snow or ice on
the wiper arms will cause them toautomatically park in the winter

position.

Instrument s an d Control s
WIPE
R ARM S

Control
s Nea r th e Steerin g Whee l

Windshiel d Washer s
To clean the windshield, pull back on
the wiper control lever. The washers spray until you release the lever. The
wipers run at low speed while you're pulling the lever, then complete one
more sweep of the windshield after
you release it.
Hazar
d Warnin g

Push the red button to the left of the
clock to turn on the hazard warning
lights (four-way flashers). This causes all four outside turn signalsand both indicators in the instrument
panel to flash. Use the hazard
warning lights if you need to park in a dangerous area near heavy traffic,
or if your car is disabled. Car
s wit h navigatio n syste m
Instrument s an d Control s

Control
s Nea r th e Steerin g Whee l
Rea r Windo w Defogge r
The rear window defogger will clear fog, frost, and thin ice from the
window. Push the defogger button to turn it on and off. The light in the
button lights to show the defogger is
on. If you do not turn it off, the
defogger will shut itself off after
about 25 minutes. It also shuts off
when you turn off the ignition. You have to turn it on again when you
restart the car.
Car
s wit h navigatio n syste m

Make sure the rear window is clear and you have good visibility before
starting to drive.
The defogger and antenna wires on the inside of the rear window can beaccidentally damaged. When
cleaning the glass, always wipe side
to side. Steerin
g Whee l Adjustment s

See page 17 for important safety
information about how to properly
position the steering wheel

Your Acura's steering wheel is electrically-adjustable for angle and
distance. The adjustment switch is
on the left side of the steering
column. Always adjust the steering
wheel before you begin driving.

CONTINUED

Instrument s an d Control s

Adjusting the steering wheel
position while driving may
cause you to lose control of the
car and be seriously injured in a
crash.
Adjust the steering wheel only
when the car is stopped.

Control
s Nea r th e Steerin g Whee l

1. Locate the adjustment switch on the left side of the steering column.Move the steering wheel, in, out,
up, or down by pushing and
holding the adjustment switch in
that direction. 2. Release the switch when the
steering wheel reaches thedesired position. Make sure the
steering wheel points towards
your chest, not toward your face, and that you can see the
instrument panel gauges and
warning lights.
Automatic Movement

AUTO SWITC H
The AUTO switch controls automat- ic movement of the steering wheel.
When this switch is in the ON posi- tion, the steering wheel automatical-
ly moves fully in and up when you re-move the key from the ignition
switch.

Instrument s an d Control s

Control
s Nea r th e Steerin g Wheel , Steerin g Whee l Control s

The steering wheel then returns to its original position when you insert
the key back in the ignition switch.
Steering wheel movement is also
controlled by the Driving Position
Memory System (see page 100). Cruis
e Contro l
Cruise control allows you to maintain
a set speed above 25 mph (40 km/h)
without keeping your foot on the accelerator pedal. It should be used
for cruising on straight, open highways. It is not recommended for
conditions such as city driving,
winding roads, slippery roads, heavy rain, or bad weather. You should
have full control of the car under
those conditions. Using the Cruise Control
CRUIS E CONTRO L MASTE R SWITC H
1. Push in the Cruise Control Master Switch to the left of the steering
column. The indicator in theswitch will light.
2. Accelerate to the desired cruising speed above 25 mph (40 km/h).
CONTINUED
Instrument s an d Control s

Improper use of the cruise
control can lead to a crash.
Use the cruise control only
when traveling on open highways in good weather.

Steerin
g Whee l Control s

3. Press and release the SET/decel button on the steering wheel. TheCRUISE CONTROL light on the
instrument panel comes on to show the system is now activated. The cruise control may not hold the
set speed when you are going up and
down hills. If your speed increases
going down a hill, use the brakes to slow down to the desired speed. This
will cancel the cruise control. To resume the set speed, press the
RESUME/accel button. The
CRUISE CONTROL light on the
instrument panel comes on.
When climbing a steep hill, the automatic transmission may
downshift to hold the set speed. Changing the Set Speed
You can increase the set cruising
speed in any of these ways: Press and hold the RESUME/
accel button. The car will acceler- ate. When you reach the desired
cruising speed, release the button. Push on the accelerator pedal. Ac-
celerate to the desired cruising
speed and press the SET/decel
button. To increase your speed in very
small amounts, tap the RESUME/
accel button repeatedly. Each time
you do this, your car will speed up about 1 mph (1.6 km/h).

Instrument s an d Control s

RESUME
/

acce l

BUTTO N

SET/dece l
BUTTO N

Steerin
g Whee l Control s

You can decrease the set cruising speed in any of these ways: Press and hold the SET/decel
button. The car will decelerate. Release the button when you
reach the desired speed. Tap the brake pedal lightly with
your foot. The CRUISE CONTROL light on the
instrument panel will go out.
When the car slows to the desired speed, press the SET/decel button.
The car will then maintain the desired speed.
To slow down in very small amounts, tap the SET/decel
button repeatedly. Each time you do this, your car will slow down
about 1 mph (1.6 km/h). Even with the cruise control turned
on, you can still use the accelerator
pedal to speed up for passing. After
completing the pass, take your foot
off the accelerator pedal. The car
will return to the set cruising speed.
Resting your foot on the brake pedal
will cause the cruise control to
cancel.
Cancelling the Cruise Control

CANCEL

BUTTO N

You can cancel the cruise control in any of these ways:
Tap the brake pedal. Push the CANCEL button on the

steering wheel.

Press the Cruise Control Master

Switch.

Instrument s an d Control s

CONTINUED