1999 TOYOTA RAV4 lock

'99 Rav4.U
20
ÐInstalling
1. Insert the flat hinges of the sun roof
panel into the hinge cases on the
body. Then slowly lower it while
holding the roof with your hands.
Make sure both flat hinges are inserted
into the hinge cases.2. Press in the retaining spring arms and insert them into the holes. Then
lock the sun roof by pushing the
handle up with the palm of your
hand until the handle clicks.
CAUTION
To avoid serious personal injury, you
must do the following. While the vehicle is moving, always
keep the head, hands and other
parts of the body of all occupants
away from the soft- top opening.
Otherwise, you could be seriously
injured if the vehicle stops sudden-
ly or if the vehicle is involved in an
accident.
Do not lower or raise the soft- top
while the vehicle is moving. You
may lose control and it may cause
an accident.
The vehicle should never be driven
with the soft- top partially lowered.
Make sure the top has been either
fully latched to the roof or fully
lowered before driving.
When raising or lowering the soft-
top, keep hands clear from any
parts of the top linkage.
Soft- topÐ
ÐSoft- top precautions

'99 Rav4.U
24
LOWERING THE SOFT- TOP
Before lowering the soft- top, make sure
the quarter windows and rear window
are already removed.
NOTICE
Lowering the soft- top without remov- ing the quarter and rear window maycause damage to the soft- top.
1. While pressing the lock release but-
ton, pull down the latch handle.
2. Lock the latch handle and hook.3. Fold the soft- top. Make sure toplace the soft- top between the rear
seat backs and tailgate.
CAUTION
With the soft- top opened, when the
rear seat is in the reclined position
or when reclining the rear seat, be
careful not to damage the soft- top
and not to get your head hit or in-
jured by the latch handles.

'99 Rav4.U
26
3. Separate the latch handle and hook while pressing the lock release but-
ton.4. Set the hook, push up the latch han-dle to securely lock it.
CAUTION
Try pushing and pulling the latch
handle to make sure it is securely
locked.
Try pushing the soft- top forward
and rearward to make sure it is se-
curely locked.
INSTALLING THE REAR WINDOW
1. Open the tailgate and engage the zipper approximately 25 mm (1.0 in.).
CAUTION
The rear window must be securely
sealed to prevent exhaust gases from
coming into the occupant compart-
ment and causing serious personal
injury or death.

'99 Rav4.U
32
Adjust the driver's seat so that the foot
pedals, steering wheel and instrument
panel controls are within easy reach of
the driver.
CAUTION

Adjustments should not be made
while the vehicle is moving, as the
seat may unexpectedly move and
cause the driver to lose control of
the vehicle.
When adjusting the seat, be careful
not to hit the seat against a pas-
senger or luggage.
After adjusting the seat position,
try sliding it forward and backward
to make sure it is locked in posi-
tion.
After adjusting the seatback, exert
body pressure to make sure it is
locked in position.
Do not put objects under the seats.
The objects may interfere with the
seat- lock mechanism or unexpect-
edly push up the seat position ad-
justing lever; the seat may suddenly
move, causing the driver to lose
control of the vehicle.
While adjusting the seat, do not put
your hands under the seat or near
the moving parts. You may catch
and injure your hands or fingers.
ÐAdjusting front seats
Front seatsÐ
ÐSeat adjustment precautions

'99 Rav4.U33
1. SEAT POSITION ADJUSTING LEVER
Pull the lever up. Then slide the seat
to the desired position with slight body
pressure and release the lever. 2. SEATBACK ANGLE ADJUSTING LEVER
Lean forward and pull the lever up.
Then lean back to the desired angle
and release the lever.
CAUTION
To reduce the risk of sliding under
the lap belt during a collision, avoid
reclining the seatback any more than
needed. The seat belts provide maxi-
mum protection in a frontal or rear
collision when the driver and the pas-
senger are sitting up straight and
well back in the seats. If you are
reclined, the lap belt may slide past
your hips and apply restraint forces
directly to the abdomen. Therefore, in
the event of a frontal collision, the
risk of personal injury may increase
with increasing recline of the seat- back.
For easy access to the rear seat, do
this.
1. Lift the seatback angle adjusting lever or press the pedal behind the seat-
back.
The seat will slide forward.
2. Move the seat to the front- most posi- tion.
After passengers are in, lift up the seat-
back and return the seat until it locks.
CAUTION
After putting back the seat, try
pushing the seat forward and rear-
ward to make sure it is secured in
place.
Never allow anyone to rest their
foot on the release pedal while the
vehicle is moving.
ÐMoving passenger 's seat for
rear seat entry
(2- door hardtop and soft- top)

'99 Rav4.U
34
Lean forward and pull the lock release
lever. Then lean back to the desired
angle and release the lever.
CAUTION
Adjustments should not be made
while the vehicle is moving.
To reduce the risk of sliding under
the lap belt during a collision,
avoid reclining the seatback any
more than needed. The seat belts
provide maximum protection in a
frontal or rear collision when the
passengers are sitting up straight
and well back in the seats. If you
are reclined, the lap belt may slide
past your hips and apply restraint
forces directly to the abdomen.
Therefore, in the event of a frontal
collision, the risk of personal injury
may increase with increasing recline
of the seatback.
After adjusting the seatback, exert
body pressure to make sure it is
locked in position.
1. Remove the head restraint. Unlock
the seatback and fold it down.
Folding up the rear seats will enlarge the
luggage compartment. See ºLuggage stow-
age precautionsº in Part 2 for precautions
to observe for loading luggage.
Rear seatsÐ
ÐAdjusting seatback angle
ÐFolding up rear seats
(2- door hardtop and soft- top)

'99 Rav4.U35
2. Unlock the seat cushion. Swing thewhole seat up and forward.3. Lock the raised bottom cushion inplace by attaching the support rod
onto the hook. Then store the head
restraint in the head restraint retain-
ing holes in the bottom cushion.When returning the rear seat to its
original position, first remove the head
restraint. Unlock the seat and return it.
Be certain to replace the head restraint.

'99 Rav4.U
36
CAUTION
When returning seats to their original
position: Make sure the seat belts are not
twisted or caught under the seat
and are arranged in their proper
position and are ready to use.
Make sure the seat is securely
locked by pushing forward and rear-
ward on the top of the seatback or
by trying to pull up the edge of the
bottom cushion. Failure to do so
will prevent seat belt from proper
operation.
BEFORE FOLDING REAR SEAT
Stow the rear seat belt and buckles as
shown in the illustration.
This prevents the belt and buckles from
falling out when you fold the seatback.
NOTICE
The seat belt and buckles must be
stowed before you fold the seatback.
FOLDING REAR SEAT
1. Remove the head restraint. Unlock the seatback and fold it down.
Folding up the rear seats will enlarge the
luggage compartment. See ºLuggage stow-
age precautionsº in Part 2 for precautions
to observe for loading luggage.
ÐFolding up rear seats
(4- door hardtop)