1999 NISSAN MAXIMA stop start

BRAKE BOOSTERCheck the brake booster function as follows:
1. With the engine off, press and release the
brake pedal several times. When brake
pedal movement (distance of travel) re-
mains the same from one pedal application
to the next, continue on to the next step.
2. While depressing the brake pedal, start the
engine. The pedal height should drop a
little.
3. With the brake pedal depressed, stop the
engine. Keeping the pedal depressed for
about 30 seconds, the pedal height should
not change.
4. Run the engine for one minute without
depressing the brake pedal, then turn it off.
Depress the brake pedal several times. The
pedal travel distance will decrease gradu-
ally with each depression as the vacuum is
released from the booster.
If the brakes do not operate properly, see your
NISSAN dealer.Press the pedal by hand and be sure the free
travel is within the limits shown above. If free
travel is too little or too much, see your
NISSAN dealer.
Never use a fuse of higher amperage
rating than that specified on the fuse
box cover. This could damage the elec-
trical system or cause a fire.
DI1021MC
CLUTCH PEDAL FUSES
Do-it-yourself
8-21
Z
01.1.22/A32-D/V5.0
X

system, brake system, etc. when the
hitch is installed.
ITo reduce the possibility of additional
damage if your vehicle is struck from
the rear, where practical, remove the
hitch when not in use. Remove the
receiver when not in use. After the
hitch is removed, seal the bolt holes
to prevent exhaust fumes, water or
dust from entering the passenger
compartment.
IRegularly check that all hitch mount-
ing bolts are securely mounted.
Tire pressuresIWhen towing a trailer, inflate the vehicle
tires to the recommended cold tire pressure
indicated on the tire placard (located on the
inside of the center console lid.)
ITrailer tire condition, size, load rating and
proper inflation pressure should be in ac-
cordance with the trailer and tire manufac-
turers' specifications.Safety chainAlways use a suitable chain between your
vehicle and the trailer. The chain should becrossed and should be attached to the hitch,
not to the vehicle bumper or axle. Be sure to
leave enough slack in the chain to permit
turning corners.
Trailer lightsTrailer lights should comply with federal and/or
local regulations. When wiring the vehicle for
towing, connect the stop and tail light pickup
into the vehicle electrical circuit at a point
between the sensor and stop light or light
switch.Trailer brakesIf your trailer is equipped with a braking sys-
tem, make sure it conforms to federal and/or
local regulations and that it is properly in-
stalled.Never connect a trailer brake system
directly to the vehicle brake system.Pre-towing tipsIBe certain your vehicle maintains a level
position when a loaded and/or unloaded
trailer is hitched. Do not drive the vehicle if
it has an abnormal nose-up or nose-downcondition; check for improper tongue load,
overload, worn suspension or other pos-
sible causes of either condition.
IAlways secure items in the trailer to prevent
load shifts while driving.
IBe certain your rear view mirrors conform to
all federal, state or local regulations. If not,
install any mirrors required for towing be-
fore driving the vehicle.
Trailer towing tipsIn order to gain skill and an understanding of
the vehicle's behavior, you should practice
turning, stopping and backing up in an area
which is free from traffic. Steering stability, and
braking performance will be somewhat differ-
ent than under normal driving conditions.
IAlways secure items in the trailer to prevent
load shift while driving.
IAvoid abrupt starts, acceleration or stops.
IAvoid sharp turns or lane changes.
IAlways drive your vehicle at a moderate
speed.
IAlways block the wheels on both vehicle
and trailer when parking. Parking on a
slope is not recommended; however, if you
must do so, and if your vehicle is equippedTechnical and consumer information
10-15
Z
01.1.22/A32-D/V5.0
X

Fusible links .................................................... 8-22
GGarage door opener, Integrated HomeLinkUniversal Transceiver ..................................... 2-30
Gas cap .......................................................... 3-10
Gauge ............................................................... 2-3
Engine coolant temperature gauge ............. 2-5
Fuel gauge .................................................. 2-5
Odometer..................................................... 2-4
Speedometer ............................................... 2-4
Tachometer ................................................. 2-4
General maintenance ................................ 9-2, 9-3
Glove box........................................................ 2-24
Glove box lock ................................................ 2-24
HHazard warning flasher switch........................ 2-19
Head restraints ................................................. 1-5
Headlamps, (Bulb replacement) ..................... 8-25
Headlight switch .............................................. 2-17
Headlights, (Bulb replacement) ...................... 8-25
Heated seats................................................... 2-20
Heater
Engine coolant heater ............................... 5-21
Heater and air conditioner (automatic)
(if so equipped) ........................................... 4-9
Heater and air conditioner controls ............. 4-3
Heater operation.......................................... 4-3
Operation, Semiautomatic air conditioner ... 4-4
HomeLink
Universal Transceiver .................. 2-30
Hood, release ................................................... 3-8Horn ................................................................ 2-19
How to stop alarm, Theft warning .................. 2-13
I
Ignition switch ................................................... 5-4
Automatic transmission models .................. 5-4
Key positions ............................................... 5-6
Manual transmission models....................... 5-5
Indicator lights and chimes (See warning/
indicator lights and chimes) .............................. 2-9
Inside mirror .................................................... 3-12
Inspection/maintenance (I/M) test................. 10-18
Instrument panel ............................................... 2-2
Integrated HomeLink
Universal
Transceiver ..................................................... 2-30
Interior and cargo light .................................... 2-28
Interior light ..................................................... 2-28
Interior light replacement ................................ 8-26
J
Jump starting .................................................... 6-7
KKeyless entry, (See multi-remote control
system) ............................................................. 3-5
Keys .................................................................. 3-2
LLabel, Air conditioner specification label ...... 10-11
Label, Emission control information label ..... 10-10Label, F.M.V.S.S. certification label.............. 10-10
Labels
Air bag warning labels............................... 1-15
Air conditioner specification label ........ 4-3, 4-9
Engine serial number .............................. 10-10
Vehicle identification number (VIN)........... 10-9
Lamp replacement .......................................... 8-24
License plate, Installing front license plate... 10-11
Light
Air bag warning light ................................. 1-15
Bulb replacement ...................................... 8-24
Fog light switch ......................................... 2-18
Headlamps (Bulb replacement)................. 8-25
Headlight switch ........................................ 2-17
Headlights (Bulb replacement) .................. 8-25
Interior and cargo light .............................. 2-28
Interior light................................................ 2-28
Personal light............................................. 2-28
Trunk light.................................................. 2-29
Vanity mirror light ...................................... 2-29
Warning/indicator lights and chimes .... 2-7, 2-9
Lights, Exterior and interior light
replacement .................................................... 8-26
Loading information (See vehicle loading
information) ................................................... 10-12
Lock
Door locks ................................................... 3-3
Glove box lock........................................... 2-24
Power door lock .......................................... 3-3
Trunk lid lock opener lever.......................... 3-9
Low fuel warning light ....................................... 2-9
Z
01.1.22/A32-D/V5.0
X
11-3