1999 LEXUS SC300 cluster

65S007±6
PICTORIAL INDEX
xi
INSTRUMENT CLUSTER (SC400)

65S013±2
PICTORIAL INDEX
xiii
INSTRUMENT CLUSTER (SC300)

KEYS AND DOORS
17
The engine immobiliser system is a theft prevention
system. When you insert the key in the ignition switch, the
transponder chip in the key's head transmits an electronic
code to the vehicle. The engine will start, only when the
electronic code in the chip corresponds to the registered
ID code for the vehicle.
The system is automatically set when the key is removed from
the ignition switch. At this time, the security indicator light
at the bottom of the instrument cluster flashes. When you
insert the key in the ignition switch, the security indicator
light goes out and the system is canceled automatically, which
enables the engine to start.
For your Lexus dealer to make you a new key with built±in
transponder chip, your dealer will need your key number and
master key. However, there is a limit to the number of
additional keys your Lexus dealer can make for you. If you make your own duplicate key, you will not be able
to cancel the system or start the engine.

SWITCHES
33
To turn the lights on, twist the knob on the end of the lever.
FIRST CLICKSTOP: Only the parking, tail, license plate,
side marker and instrument panel lights turn on.
SECOND CLICKSTOP: Headlights also turn on.
THIRD CLICKSTOP (ºAUTOº): The headlights and all
other lights automatically turn on depending on the darkness
of the surroundings.
When the headlights are on, the headlight indicator lights up
in the instrument cluster.
Manually twist the knob to the second clickstop to turn on
the headlights if they are needed immediately when
entering a dark tunnel, parking structure, etc.

SWITCHES
34
The automatic light control sensor is on top of the driver's
side instrument panel.
Do not place anything on the instrument panel, and/or do not
affix anything on the windshield to block this sensor.
The lights automatically turn off when the driver's door is
opened with the ignition key turned to the ºACCº or ºLOCKº
position. To turn them on again, turn the ignition key to the
ºONº position or turn the headlight switch off and then twist
the knob until the first or second clickstop. If you are going
to park for over one week, make sure the headlight switch is
off.
When the headlight switch is turned to the first or second
clickstop, the brightness of the instrument cluster will be
reduced slightly unless the instrument panel light control
knob is turned fully on.

SWITCHES
36
For high beam, push the lever forward. Pull it back for
low beam. For the headlight flasher, pull it further back.
A blue light in the instrument cluster indicates high beam or
headlight flasher is on.
The headlight flasher works even when the headlight switch
is off.

SWITCHES
37
For signaling turns, move the lever up or down in the
conventional manner.
The ignition key must be in the ºONº position.
The turn signal is self±cancelling after a turn, but after a lane
change, you may have to cancel it by hand. You can also
signal a lane change by moving the turn signal lever partway
and holding it there.
If the green light in the instrument cluster flashes faster than
normal, it indicates that the front or rear turn signal bulb has
burned out. If this indicator light does not come on,
the fuse
or the indicator light itself has probably failed.
FOG LIGHT SWITCH
To turn on the fog lights, turn the switch to the ºONº
position. The fog lights come on only when the headlights
are on low beam.

SWITCHES
38
WINDSHIELD WIPER ANDWASHER SWITCH
To turn the wipers on, move the lever down. To make the
washer squirt, push the button on the end of the lever.
The ignition key must be in the ºONº position.
For mist wiper operation (a single wipe), pull the lever toward
you and release it.
The interval adjuster lets you adjust the wiping time interval
between wiper sweeps if the wiper lever is in the ºINTº
position. Tw ist the lever upward to increase the time between
sweeps, and downward to decrease it.
Also, the wipers will automatically operate a couple of times
after the washer squirts even with the lever in the ºOFFº
position. The low washer fluid warning light in the instrument cluster
comes on when the fluid level in the tank becomes nearly
empty. For information on adding washer fluid, see ºAdding
washer fluidº on page 396.
In cold weather, warm the windshield with the defroster
before using the washer. This will help prevent icing, which
could block your vision.
NOTICE
Do not operate the wipers if the windshield is dry. It may
scratch the glass.