Page 2 of 432

INTRODUCTION
ii
New vehicle warranty
Your new vehicle is covered by the following Lexus limited
warranties:
New vehicle warranty
Emission control systems warranty
Others
For further information, please refer to the separate ºOwner's
Guideº, ºOwner's Manual Supplementº or ºWarranty
Bookletº.
Your responsibility for maintenance
It is the owner's responsibility to make sure the specified
maintenance is performed. Section 5 of this Owner's Manual
gives details of these maintenance requirements. Included in
Section 6 is general maintenance. For scheduled
maintenance information, please refer to the separate
ºOwner 's Manual Supplement/Maintenance Scheduleº.
Accessories, spare parts and modification of
your Lexus
A wide variety of non±genuine spare parts and accessories for
Lexus vehicles are currently available in the market. You
should know that Toyota does not warrant these products and
is not responsible either for their performance, repair or
replacement, or for any damage they may cause to, or adverse
effect they may have on, your Lexus vehicle. This vehicle should not be modified with non±genuine Lexus
products. Modification with non±genuine Lexus products
could affect its performance, safety or durability, and may
even violate governmental regulations. In addition, damage
or performance problems resulting from the modification
may not be covered under warranty.
Installation of a mobile two±way radio system
As the installation of a mobile two±way radio system in your
vehicle could affect electronic systems such as the multiport
fuel injection system/sequential multiport fuel injection
system, cruise control system, anti±lock brake system and
SRS airbag system, be sure to check with your Lexus dealer
for precautionary measures or special instructions regarding
installation.
Scrapping of your Lexus
The SRS airbag device in your Lexus contains explosive
chemicals. If the vehicle is scrapped with the airbags left as
they are, it may cause an accident such as a fire. Be sure to
have the SRS airbag system removed and disposed of by a
qualified service shop or by your Lexus dealer before you
scrap your vehicle.
Page 35 of 432

KEYS AND DOORS
17
The engine immobiliser system is a theft prevention
system. When you insert the key in the ignition switch, the
transponder chip in the key's head transmits an electronic
code to the vehicle. The engine will start, only when the
electronic code in the chip corresponds to the registered
ID code for the vehicle.
The system is automatically set when the key is removed from
the ignition switch. At this time, the security indicator light
at the bottom of the instrument cluster flashes. When you
insert the key in the ignition switch, the security indicator
light goes out and the system is canceled automatically, which
enables the engine to start.
For your Lexus dealer to make you a new key with built±in
transponder chip, your dealer will need your key number and
master key. However, there is a limit to the number of
additional keys your Lexus dealer can make for you. If you make your own duplicate key, you will not be able
to cancel the system or start the engine.
Page 36 of 432
KEYS AND DOORS
18For vehicles sold in U.S.A.
FCC ID: MOZ RI±4CTY MADE IN JAPAN
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
Page 42 of 432
KEYS AND DOORS
24
CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
Page 58 of 432
SWITCHES
40
CAUTION
Since the mirror surfaces can get hot, keep your hands off
them when the switch is on.
If further defrosting or defogging is desired, simply actuate
the switch again. When the surface has cleared, push the
switch once again to turn the defogger off. Continuous use
may cause the battery to discharge, especially during
stop±and±go driving. The defogger is not designed to dry rain
water or to melt snow.
If the outside rear view mirrors are heavily coated with ice,
use a spray de±icer before operating the switch.
NOTICE
When cleaning the inside of the rear window, be
careful not to scratch or damage the heater wires.
To prevent the battery from being discharged, do not
operate the defogger continuously longer than
necessary.
POWER WINDOW SWITCHES
Page 62 of 432
SWITCHES
44
CAUTION
To avoid serious personal injury, you must do the following.
Always make sure the head, hands and other parts of the
body of all occupants are kept completely inside the vehicle
before you close the power windows. If someone's neck,
head or hands gets caught in a closing window, it could
result in a serious injury. When anyone closes the power
windows, be sure that they operate the windows safely.
When small children are in the vehicle, never let
them use the power window switches without
supervision. Use the ºWINDOW LOCKº switch to
prevent them from making unexpected use of the
switches.
Never leave small children alone in the vehicle,
especially with the ignition key still inserted. They
could use the power window switches and get
trapped in a window. Unattended children can
become involved in serious accidents.EMERGENCY FLASHER
SWITCH
Page 64 of 432
SWITCHES
46
The seat heater has two switches. Push these switches on
the left side to turn the respective seat heater on, and push
the switches on the right side to turn them off.
The ignition key must be in the ºONº position.
Page 93 of 432

INTERIOR EQUIPMENT
75
CAUTION
When programming or operating the garage door opener,
make sure there is no one around the moving door. It is
dangerous if someone is caught.
(b) Operating the garage door opener
Push the appropriate button to activate the garage door
opener. The indicator light comes on. The garage door
opener continues to send the signal for up to 20 seconds as
long as the button is pushed.
(c) Erasing the garage door opener memory
Push and hold down the 2 outside buttons for about 20
seconds until the indicator light flashes. All memorized data
will be erased.FCC ID: CB2V94800
This device complies with FCC Rules part 15.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference that
may be received, including interference that may
cause undesired operation. WARNING: This
transmitter has been tested and complies with
FCC and DOC/MDC rules. Changes or
modifications not expressly approved by the
partly responsible for compliance could void the
user's authority to operate the device.