1999 LEXUS SC300 run

IN CASE OF AN EMERGENCY
274
IF YOUR ENGINE STALLSWHILE DRIVING
If your engine stalls while driving . . . .
1. Reduce your speed gradually, keeping a straight line.
Move cautiously off the road to a safe place.
2. Turn on your emergency flashers.
3. Try starting the engine again.
If the engine will not start, see ºIf your vehicle will not startº.
CAUTION
If the engine is not running, the power assist for the brakes and
steering will not work, so steering and braking will be much
harder than usual.

IN CASE OF AN EMERGENCY
279
JUMP STARTING PROCEDURE
1. If the booster battery is installed in another vehicle, make
sure the vehicles are not touching. Turn off all unnecessary
lights and accessories.
2. If required, remove all the vent plugs from the booster
battery.
Lay a cloth over the open vents on the booster battery.
(This helps reduce the explosion hazard, personal injuries and
burns.)
3. If the engine in the vehicle with the booster battery is not
running, start it and let it run for about 5 minutes. During
jump starting, run the engine at about 2000 rpm with the
accelerator pedal lightly depressed.
4. Connect the jumper cables in the exact order shown in the
illustration: positive terminal (º+º mark)±to±positive
terminal (º+º mark), and negative terminal (º±º
mark)±to±engine or body ground. Note that you first connect
the positive cable to the discharged battery and then to the
booster battery. Next, connect the negative cable to the
booster battery and then to a solid, stationary, unpainted
metallic point (e.g. SC400: brake booster vacuum pipe
bracket, SC300: cylin der head) away from the battery. Do not
connect it to or near any part that moves when the engine is
cranked.
CAUTION
When making the connections, to avoid serious injury, do not
lean over the battery or accidentally let the jumper cables or
clamps touch anything except the correct battery terminals or
the ground.

IN CASE OF AN EMERGENCY
2805. Start your engine in the normal way. After starting, run it
at about 2000 rpm for several minutes with the accelerator
pedal lightly depressed.
6. Carefully disconnect the cables in the exact reverse order:
the negative cable and then the positive cable.
7. Carefully dispose of the battery cover cloths which may
now contain sulfuric acid.
8. If removed, replace all the battery vent plugs.
If the cause of your battery discharging is not apparent (for
example, lights left on), you should have it checked.
IF YOUR VEHICLE
OVERHEATS
If your engine coolant temperature gauge indicates
overheating, if you experience a loss of power, or if you
hear a loud knocking or pinging noise, the engine has
probably overheated.

IN CASE OF AN EMERGENCY
282B: If no steam is coming from your engine:
Leave the engine running and turn off the air conditioning.
Check the following.


Is the cooling fan operating?

Is the coolant in the acceptable range?

Is the engine drive belt O.K.?
CAUTION

When the engine is running, keep hands and clothing away
from the moving fan and engine drive belt.

Do not attempt to remove the radiator cap when the engine
and radiator are hot. Serious injury could result from
scalding hot fluid and steam blown out under pressure.
If the cooling fan is not operating or the coolant is not in the
acceptable range, turn off the engine and call your Lexus
dealer.
If both conditions are O.K., after the engine coolant
temperature has cooled to normal, continue driving your
vehicle.
If the engine coolant temperature does not cool down, or your
vehicle overheats again, have it checked as soon as possible
by your Lexus dealer.

IN CASE OF AN EMERGENCY
283
IF YOU HAVE A FLAT TIRE
1. Reduce your speed gradually, keeping a straight line.
Move cautiously off the road to a safe place ± well away from
the traffic. A void stopping on the center divider of a highway.
Park on a level spot with firm ground.
2. Stop the engine and turn on your emergency flashers.
3. Firmly set the parking brake and put the transmission in
ºPº.
4. Have everyone get out of the vehicle on the side away from
traffic.
5. Read the following instructions thoroughly.
CAUTION
When jacking, be sure to observe the following to reduce the
possibility of personal injury:

Follow jacking instructions.

Do not put any part of your body under a vehicle supported
by a jack. Personal injury may occur.

Do not start or run the engine while your vehicle is
supported by the jack.

Stop the vehicle on a level firm ground, firmly set the
parking brake and put the transmission in ºPº. Block the
wheel diagonally opposite to the one being changed if
necessary.

IN CASE OF AN EMERGENCY
305
CAUTION
Use extreme caution when towing the vehicle. Avoid sudden
starts or erratic driving maneuvers which would place
excessive stress on the emergency towing eyelet and towing
cable or chain. The eyelet and towing cable or chain may
break and cause serious injury or damage.
NOTICE
Use only a cable or chain specifically intended for use in
towing vehicles. Securely fasten the cable or chain to the
towing eyelet provided.
Before towing, release the parking brake and put the
transmission in ºNº. The ignition key must be in ºACCº
(engine off) or ºONº (engine running).
CAUTION
If the engine is not running, the power assist for the brakes and
steering will not work so steering and braking will be much
harder than usual.

MAINTENANCE
312
GENERAL MAINTENANCE
Listed below are the general maintenance items that should be
performed at the intervals specified. It is recommended that
any problem you notice be brought to the attention of your
Lexus dealer or qualified service shop for their advice.
CAUTION
Make these checks only where adequate ventilation can be
obtained if you run the engine.
Vehicle exterior
Items listed below should be performed from time to time,
unless otherwise specified.
Tire pressure
Check the pressure with a gauge every two weeks, or at least
once a month and adjust as shown on the tire pressure label.
See page 363 for additional information.
Tire surface
Check the tires carefully for cuts, damage or excessive wear.
See page 365 for additional information.
Wheel nuts
When checking the tires, make sure to check the nuts for
looseness. Tighten them if necessary. Tire rotation
Rotate the tires every 12000 km (7500 miles). See page 365
for additional information.
Fluid leaks
Check underneath for leaking fuel, oil, water or other fluid
after
the vehicle has been parked for a while. If you smell fuel
fumes or notice any leak, have the cause found and corrected
immediately.
Doors and engine hood
Check that all doors, including trunk lid, operate smoothly
and all latches lock securely. Make sure the engine hood
secondary latch secures the hood when the primary latch is
released.

INTRODUCTION
324
DO±IT±YOURSELF SERVICEPRECAUTIONS
If you perform maintenance yourself, be sure to follow the
correct procedure given in this Section.
You should be aware that improper or incomplete servicing
may result in operating problems.
Performing do±it±yourself maintenance during the warranty
period may affect your warranty coverage. Read the separate
Lexus Warranty statement for details and suggestions.
This Section gives instructions only for those items that are
relatively easy for an owner to perform. As explained in
Section 5, there are still a number of items that must be
performed by a qualified technician with special tools.
For information on tools and parts for do±it±yourself
maintenance, see ºParts and toolsº.
Utmost care should be taken when working on your vehicle
to prevent accidental injury. Here are a few precautions that
you should be especially careful to observe:
CAUTION

When the engine is running, keep hands, clothing, and tools
away from the moving fan and engine drive belt.
(Removing rings, watches, and ties is advisable.)