1999 LEXUS SC300 brake light

STARTING AND DRIVING
248
Traction control failure warning
If the ºTRAC OFFº indicator/warning light flashes, contact
your Lexus dealer as soon as possible. There may be trouble
in the traction control system.
CAUTION
Under certain slippery road conditions, full traction of the
vehicle and power to the rear wheels cannot be maintained,
even though the traction control system is in operation. Do not
drive the vehicle under any speed or maneuvering conditions
which will cause the vehicle to lose traction. In situations
where the road surface is covered with ice or snow, your
vehicle should be fitted with snow tires or tire chains. Always
drive at an appropriate and cautious pace.
BRAKE SYSTEM
The tandem master cylinder brake system is a hydraulic
system with two separate sub±systems. If either sub±system
should fail, the other will still work. However, the pedal will
be harder to press, and your stopping distance will be longer.
Also, the brake system warning light may come on.
CAUTION
Do not drive your vehicle with only a single brake system.
Have your brakes fixed immediately.

STARTING AND DRIVING
253
This light comes on when the ignition key is turned to the
ºONº
position. After about a few seconds, the light will go
off.
If either of the following conditions occurs, this indicates a
malfunction somewhere in the parts monitored by the
warning light system. Contact your Lexus dealer as soon as
possible to service the vehicle.
 The light does not come on as described above, or remains
on.
 The light comes on while driving.
Even if the anti±lock brake system should fail, the brake
system will still operate conventionally. But when the ºABSº
warning light is on (and the brake system warning light is off),
anti±lock brake system is not assisting brake performance so
that the wheels could lock up during a sudden brake or
braking on slippery road surfaces. Have your vehicle
checked by your Lexus dealer as soon as possible.
Drum±in±disc type parking brake system
Your vehicle has a drum±in±disc type parking brake system.
This type of brake system needs bedding±down of the brake
shoes periodically or whenever the parking brake shoes
and/or drums are replaced.
Have your Lexus dealer perform the bedding±down.

DRIVING TIPS
259
BREAK±IN PERIOD
Drive gently and avoid high speeds.
You need not follow a break±in schedule with your new
Lexus. But following a few simple tips for the first 1600 km
(1000 miles) can add to the future economy and long life of
your vehicle:

Do not drive over 88 km/h (55 mph).

Avoid overrevving. Maintain engine speed between 2000
and 4000 rpm.

Avoid full±throttle starts.

Try to avoid hard stops during the first 300 km (200 miles).

Do not drive for a long time at any single speed, either fast
or slow.

Do not tow a trailer during the first 800 km (500 miles).
OPERATION IN FOREIGN
COUNTRIES
If you plan to drive your Lexus in another country ...
First, comply with the vehicle registration laws.
Second, confirm the availability of the correct fuel (unleaded
and minimum octane rating).
TIPS FOR DRIVING IN VARIOUS CONDITIONS

Always slow down in gusty crosswinds. This will allow
you much better control.

Drive slowly onto curbs and, if possible, at a right angle.
Avoid driving onto high, sharp±edged objects and other
road hazards. Failure to do so can lead to severe tire
damage resulting in tire bursts.

When parking on a hill, turn the front wheels until they
touch the curb so that the vehicle will not roll. Apply the
parking brake, and place the transmission in ºPº. If
necessary, block the wheels.

Washing your vehicle or driving through deep water may
get the brakes wet. To see whether they are wet, check that
there is no traffic near you and then press the pedal lightly.
If you do not feel a normal braking force, the brakes are
probably wet. To dry them, drive the vehicle cautiously
while lightly pressing the brake pedal with the parking
brake applied. If they still do not work safely, pull to the
side of the road and call a Lexus dealer for assistance.
CAUTION

Before driving, make sure the parking brake is fully
released and that the parking brake reminder light is off.

DRIVING TIPS
265
Hitches

If you wish to install a trailer hitch, your Lexus dealer
should be consulted.

Use only a hitch which is recommended by Lexus dealer
and conforms to the total trailer weight requirement.

Follow the directions supplied by the hitch manufacturer.
Lubricate the hitch ball with a light coat of grease.

Lexus recommends removing the trailer hitch whenever
you are not towing a trailer to reduce the possibility of
additional damage caused by the hitch if your vehicle is
struck from behind. After removing the hitch, seal any
mounting holes in the vehicle body to prevent entry of
pollutants such as exhaust fumes, dirt, water, etc.

Remove the trailer hitch whenever you are not towing a
trailer so that the rear license plate can be seen clearly.
NOTICE

Install the trailer hitch using only the position
recommended by your Lexus dealer. Do not install the
trailer hitch on the bumper; this may cause body
damage.

Do not use axle±mounted hitches as they can cause
damage to the axle housing, wheel bearings, wheels or
tires.
Brakes and safety chains

Lexus recommends trailers with brakes that conform
to any applicable federal and state/provincial
regulations.

A safety chain must always be used between the towing
vehicle and the trailer. Leave sufficient slack in the
chain for turns. The chain should cross under the
trailer tongue to prevent the tongue from dropping to
the ground in case it becomes damaged or separated.
For correct safety chain procedur es, follow the hitch or
trailer manufacturer's recommendations.
CAUTION

If the total trailer weight exceeds 450 kg (1000 lb.), trailer
brakes are required.

Never tap into your vehicle's hydraulic system as it will
lower its braking effectiveness.

Never tow a trailer without using a safety chain securely
attached to both the trailer and the vehicle. If damage
occurs to the coupling unit or hitch ball, there is possible
danger of the trailer wandering over into another lane.

DRIVING TIPS
267
Trailer towing tips
When towing a trailer, your vehicle will handle differ ently
than when not towing. The three main causes of
vehicle±trailer accidents are driver error, excessive speed
and improper trailer loading. Keep these in mind when
towing:

Before starting out, check the operation of the lights and
all vehicle±trailer connections. After driving a short
distance, stop and recheck the lights and connections.
Practice turning, stopping and backing with a trailer in an
area away from traffic until you learn the feel.

Backing with a trailer is difficult and requires practice.
Grip the bottom of the steering wheel and move your hand
to the left to move the trailer to the left. Move your hand
to the right to move the trailer to the right. (This procedure
is generally opposite to that when backing without a
trailer.) Also, just turn the steering wheel a little at a time,
avoiding sharp or prolonged turning. Have someone guide
you when backing to reduce the risk of an accident.

Because stopping distance may be increased,
vehicle±to±vehicle distance should be increased when
towing a trailer. For each 16 km/h (10 mph) of speed,
allow at least one vehicle and trailer length between you
and the vehicle ahead. Avoid sudden braking as you may
skid, resulting in jackknifing and loss of control. This is
especially true on wet or slippery surfaces.

Avoid jerky starts or sudden acceleration.

Avoid jerky steering and sharp turns. The trailer could hit
your vehicle in a tight turn. Slow down before making a
turn to avoid the need of sudden braking.

Remember that when making a turn, the trailer wheels will
be closer than the vehicle wheels to the inside of the turn.
Therefore, compensate for this by making a larger than
normal turning radius with your vehicle.

Crosswinds and rough roads will adversely aff ect handling
of your vehicle and trailer, causing sway. Pay attention to
the rear from time to time to prepare yourself for being
passed by large trucks or buses, which may cause your
vehicle and trailer to sway. If swaying happens, firmly
grip the steering wheel and reduce speed immediately but
gradually. Never increase speed. If it is necessary to
reduce speed, brake slowly. Steer straight ahead. If you
make no extreme correction with the steering or brakes,
your vehicle and trailer will stabilize.

Be careful when passing other vehicles. Passing requires
considerable distance. After passing a vehicle, do not
forget the length of your trailer and be sure you have plenty
of room before changing lanes.

In order to maintain efficient engine braking and electrical
charging performance, do not use overdrive.
Transmission must be in the º4º position (SC400) or in the
º3º position (SC300).

DRIVING TIPS
270
HOW TO SAVE FUEL AND
MAKE YOUR VEHICLE LAST LONGER
Getting more kilometer/mileage from a liter/gallon of fuel is
easy ± just take it easy. It will help make your vehicle last
longer, too. Here are some specific tips on how to save money
on both fuel and repairs:

Keep your tires inflated at the correct pressure. Check
the pressure every two weeks, or at least once a month.
Underinflation causes tire wear and wastes fuel.

Do not carry unneeded weight in your vehicle. Excess
weight puts a heavier load on the engine, causing greater
fuel consumption.

Avoid lengthy warm±up idling. Once the engine is
running smoothly, begin driving ± but gently. Remember,
however, that on cold winter days this may take a little
longer.

Accelerate slowly and smoothly. Avoid jackrabbit starts.

Avoid long engine idling. If you have a long wait and you
are not in traffic, it is better to turn off the engine and start
again later.

Avoid engine overrevving. Use a gear position suitable
for the road on which you are traveling.

Avoid continuous speeding up and slowing down.
Stop±and±go driving wastes fuel.

Avoid unnecessary stopping and braking. Maintain a
steady pace. Try to time the traffic signals so you only
need to stop as little as possible or take advantage of
through streets to avoid traffic lights. Keep a proper
distance from other vehicles to avoid sudden braking. This
will also reduce wear on your brakes.

Avoid heavy traffic or traffic jams whenever possible.

Do not r est your foot on the clutch or brake pedal. This
causes needless wear, overheating and poor fuel economy.

Maintain a m oderate speed on highways. The faster you
drive, the greater the fuel consumption. By reducing your
speed, you will cut down on fuel consumption.

Keep the front wheels in proper alignment. Avoid
hitting the curb and slow down on rough roads. Improper
alignment not only causes faster tire wear but also puts an
extra load on the engine, which, in turn, wastes fuel.

Keep the bottom of your vehicle free from mud, etc.
This not only lessens weight but also helps prevent
corrosion.

Keep your vehicle tuned±up and in top shape. A dirty
air cleaner, improper valve clearance, dirty plugs, dirty oil
and grease, brakes not adjusted, etc. all lower engine
performance and contribute to poor fuel economy. For
longer life of all parts and lower operating costs, keep all
maintenance work on schedule, and if you often drive
under severe conditions, see that your vehicle receives
more frequent maintenance. (For scheduled maintenance
information, please refer to the separate ºOwner's Manual

IN CASE OF AN EMERGENCY
279
JUMP STARTING PROCEDURE
1. If the booster battery is installed in another vehicle, make
sure the vehicles are not touching. Turn off all unnecessary
lights and accessories.
2. If required, remove all the vent plugs from the booster
battery.
Lay a cloth over the open vents on the booster battery.
(This helps reduce the explosion hazard, personal injuries and
burns.)
3. If the engine in the vehicle with the booster battery is not
running, start it and let it run for about 5 minutes. During
jump starting, run the engine at about 2000 rpm with the
accelerator pedal lightly depressed.
4. Connect the jumper cables in the exact order shown in the
illustration: positive terminal (º+º mark)±to±positive
terminal (º+º mark), and negative terminal (º±º
mark)±to±engine or body ground. Note that you first connect
the positive cable to the discharged battery and then to the
booster battery. Next, connect the negative cable to the
booster battery and then to a solid, stationary, unpainted
metallic point (e.g. SC400: brake booster vacuum pipe
bracket, SC300: cylin der head) away from the battery. Do not
connect it to or near any part that moves when the engine is
cranked.
CAUTION
When making the connections, to avoid serious injury, do not
lean over the battery or accidentally let the jumper cables or
clamps touch anything except the correct battery terminals or
the ground.

MAINTENANCE
313
Vehicle interior
Items listed below should be checked regularly, e.g. while
performing periodic services, cleaning the vehicle, etc.
Lights
Make sure the headlight, stop lights, tail lights, turn signal
lights, and other lights are working. Check headlight aim.
Service reminder indicators and warning buzzers
Check that all service reminder indicators and warning
buzzers function properly.
Steering wheel
Check that it has the specified freeplay. Be alert for changes
in steering condition, such as hard steering, excessive
freeplay or strange noise.
Seats
Check that all front seat controls such as seat adjusters,
seatback recliner, etc. operate smoothly. Check that the head
restraints move up and down smoothly and that the locks hold
securely in any latched position.
Seat belts
Check that the seat belt system s uch as buckles, retractors and
anchors operate properly and smoothly. Make sure the belt
webbing is not cut, frayed, worn or damaged. Accelerator pedal
Check
the pedal for smooth operation and uneven pedal ef fort
or catching.
Brake pedal
Check the pedal for smooth operation and the proper
clearance and freeplay. Check the brake booster function.
Brakes
At a safe place, check that the brakes do not pull to one side
when applied.
Parking brake
Check that the lever has the proper travel and that, on a safe
incline, your vehicle is held securely with only the parking
brake applied.
Automatic transmission ºParkº mechanism
On a safe incline, check that your vehicle is held securely with
the selector lever in ºPº position and all brakes released.