Page 2 of 36
ELECTRICAL COMPONENTS
430
SPECIFICATIONS
± FUSE LOCATION
64G004±1
1Engine compartment
2Passenger's side kick panel
3Driver's side kick panel
4Engine compartment (Canada only)
± FUSES
Page 4 of 36
64G013
ELECTRICAL COMPONENTS
432
Engine compartment
64G026
Page 5 of 36
ELECTRICAL COMPONENTS
433
Engine compartment (Canada only)
Page 14 of 36
ELECTRICAL COMPONENTS
442
1Terminals 2Hold±down clamp
Check the battery for corroded or loose
connections, cracks, or loose hold±down clamps.
1. If the battery is corroded, wash it off with a solution of
warm water and baking soda. Coat the terminals with
grease to prevent further corrosion.
2. If the connections are loose, tighten the clamp bolts
± but do not overtighten.
3. Tighten the hold±down clamp only enough to keep
the battery firmly in place. Overtightening may damage
the battery case.NOTICE
Make sure the engine and all accessories are
turned off before performing maintenance.
When checking the battery, remove the ground
cable first and reinstall it last.
Be careful not to cause a short circuit with
tools.
Take care no solution gets into the battery
when washing it.
Checking battery fluid
There are 2 types of batteries: maintenance type
and non±maintenance type.
A non±maintenance battery has ºMAINTENANCE
FREE BATTERYº on its top. A maintenance type battery
does not have such indication.
Maintenance type battery
Check the fluid condition by the fluid level lines on the
side of the battery. Or if the battery has a hydrometer on
its top, you can also check the hydrometer.
Non±maintenance battery
Check the battery condition by the hydrometer on the top
of the battery.
Page 19 of 36
ELECTRICAL COMPONENTS
447
NOTICE
Never recharge the battery while the engine is
running. Also, be sure all accessories are turned
off.
Page 21 of 36
ELECTRICAL COMPONENTS
449
64G005±2
Engine compartment 1Spare fuses
2Pull±out tool
64G027
Page 22 of 36
ELECTRICAL COMPONENTS
450
Engine compartment (Canada only)
1. Turn the ignition switch off and open the fuse box
lid.
Determine which fuse may be causing the problem. The
lid of the fuse box shows the name of the circuit for each
fuse.
64L013
2. Make sure the inoperative component is turned
off. Pull the suspected fuse straight out with the
pull±out tool and check it. If it has blown, push a new
fuse into the clips.
Page 27 of 36
ELECTRICAL COMPONENTS
455
ADDING WASHER FLUID
64G009
If the washer tank becomes nearly empty, add
washer fluid.
You may use plain water as washer fluid. However, in
cold areas where temperatures range below the
freezing point, use washer fluid containing antifreeze.
This product is available at your Lexus dealer and most
auto parts stores. Follow the manufacturer's directions
for how much to mix with water.
NOTICE
Do not use engine antifreeze or any other
substitute because it may damage your vehicle's
paint.
CHECKING THE HEADLIGHT
AIM
