WIPERS AND WASHERS
5
REPAIR
9.Remove cable ties securing washer tube to
windscreen wiper rack tube.
10.Loosen fully 4 nuts securing backplates to wheel
boxes and remove windscreen wiper rack tubes.
11.Remove seals from wheel box spindles.
12.Remove 2 nuts securing wheel boxes and
remove sealing washers.
13.Carefully pull fascia support rail from bulkhead
sufficiently to remove wheel boxes.
Refit
14.Loosen fully but do not remove nuts securing
wheel box back plates.
15.Grease wheel boxes.
16.Fit wheel boxes, fit sealing washers and tighten
nuts to5 Nm (3.7 lbf.ft).
17.Fit spindle seals.
18.Fit wiper rack tubes and tighten wheel box back
plate nuts sufficiently to hold tubes. Tighten
wheel box back plate nuts to6 Nm (4 lbf.ft)
after fitting windscreen wiper motor.
19.Align washer tube to rack tube and secure with
cable ties.
20.Align fascia support rail and secure with screws.
21.Fit steering column support bracket and tighten
bolt and nut and bolt to45 Nm (33 lbf.ft).
22.Fit demister duct to tube, align relay bracket and
secure duct with screws.
23.Position heater fan switch and secure with
screws.
24.Fit wiper motor and drive rack.See this
Section.
25.Fit steering column nacelle.See STEERING,
Repair.
26.Connect battery negative lead.See
ELECTRICAL, Repair.RELAY - WIPER DELAY - FROM 02MY
Service repair no - 84.15.37
Remove
1.Disconnect battery negative lead.See
ELECTRICAL, Repair.
2.Remove 4 screws securing instrument pack and
release pack from fascia.
3.Disconnect 2 multiplugs from warning lamp
panel.
4.Disconnect instrument pack multiplug from main
harness.
5.Remove instrument pack.
ProCarManuals.com
